气相色谱–质谱法快速分析化妆品中3种香精香料

建立气相色谱-质谱法快速测定化妆品中甲基柏木酮、甲基柏木醚、壬酸3种香精香料的方法。样品用甲醇超声提取,经高速冷冻离心,上清液干燥脱水后经0.45 μm滤膜过滤,直接注入气相色谱-质谱仪进行测定,用选择离子和保留时间定性,外标法定量。甲基柏木酮、甲基柏木醚、壬酸在各自的质量浓度范围内与色谱峰面积成良好的线性关系,相关系数分别为0.9992,0.9991,0.9994,检出限分别为0.05,0.1,0.1 mg/kg。测定结果的相对标准偏差为2.1%~6.6%(n=5),样品加标回收率为91.5%~97.7%。该方法准确度和灵敏度高,样品用量少,前处理简单,可同时测定化妆品中3种香精香料。     

高效液相色谱-四极杆/飞行时间高分辨质谱测定化妆品中的西咪替丁及雷尼替丁

建立了化妆品中西咪替丁及雷尼替丁的高效液相色谱-四极杆/飞行时间高分辨质谱检测方法,并对其质谱裂解规律进行研究。待测样品经甲醇超声提取,过滤膜后经Zorbax SB-Aq色谱柱(3.0 mm×100 mm,1.8μm)分离,用乙腈-含0.1%甲酸的水溶液梯度洗脱后,在双喷雾电喷雾离子源正离子模式下检测,数据采集使用一级母离子全扫描和目标二级离子扫描。在不同的化妆品基质中,西咪替丁和雷尼替丁分别在5.65～113 ng/mL和4.95～99.0 ng/mL范围内线性关系良好(r0.999),检出限分别为1.1、0.99 ng/mL,定量下限分别为5.6、5.0 ng/mL;2种待测物在低、中、高3个加标水平下的回收率为86.7%～110%,相对标准偏差(RSD)为0.90%～6.0%,方法重复性良好(RSD10%)。该方法前处理简单,灵敏度较好,线性、回收率及重复性均满足方法学要求,可用于化妆品中西咪替丁和雷尼替丁的筛查测定。     

Paper spray tandem mass spectrometry: A rapid approach for the assay of parabens in cosmetics and drugs

A fast methodology for the assay of parabens in drug and cosmetic preparations has been presented. The procedure developed is based on paper spray tandem mass spectrometry and isotope dilution approach. For each investigated paraben, the corresponding labeled standard has been used in order to improve the accuracy and reproducibility of the analyses. The MS experiments have been performed under MRM conditions, monitoring the transitions [M‐H]^? → m/z 92 and [M‐H]^? → m/z 98, respectively, for each analyte and the corresponding labeled internal standard. The quantitative assay has been performed using a calibration curve built from 2 to 15 mg/L. The method accuracy, in all case near 100%, was evaluated using fortified samples at two concentration levels, which are representative of the lower and the higher portion of calibration curve. The good values of LOQ, LOD, and reproducibility confirm the consistency of the developed approach.     

Trace determination of parabens in cosmetics and personal care products using fabric‐phase sorptive extraction and high‐performance liquid chromatography with UV detection

A simple, fast, and sensitive analytical protocol using fabric‐phase sorptive extraction followed by high performance liquid chromatography with ultraviolet detection has been developed and validated for the extraction of five parabens including methylparaben, ethylparaben, propylparaben, butylparaben, and benzylparaben. In the present work, sol‐gel polyethylene glycol coated fabric‐phase sorptive extraction membrane is used for the preconcentration of parabens (polar) from complex matrices. The use of fabric‐phase sorptive extraction membrane provides a high surface area which offers high sorbent loading, shortened equilibrium time, and overall decrease in the sample preparation time. Various factors affecting the performance of fabric‐phase sorptive extraction, including extraction time, eluting solvent, elution time, and pH of the sample matrix, were optimized. Separation was performed using a mobile phase consisting of water:acetonitrile (63:37; v/v) at an isocratic elution mode at a flow rate of 0.9 mL/min with wavelength at 254 nm. The calibration curves of the target analytes were prepared with good correlation coefficient values (r² > 0.9955). The limit of detection values range from 0.252 to 0.580 ng/mL. Finally, the method was successfully applied to various cosmetics and personal care product samples such as rose water, deodorant, hair serum, and cream with extraction recoveries ranged between 88 and 122% with relative standard deviation <5%.     

In‐situ preparation of porous monolithic polymer inside hollow fiber as a micro‐solid phase extraction device for glucocorticoids in cosmetics

Glucocorticoids have a certain whitening effect on the skin. However, frequent and long‐term use of cosmetics including glucocorticoids is harmful to health. Herein, we proposed a novel micro‐solid phase extraction method for the detection of prednisolone acetate, prednisone, and prednisolone in cosmetics coupled with high‐performance liquid chromatography. In this method, porous monolithic polymer micro‐extraction bars were prepared by “one‐step, one‐pot” in situ photopolymerization combined with sacrificial support in hollow fiber under water atmosphere. The crucial factors such as pH of sample solution, extraction, and elution times that influence micro‐extraction were optimized and found to be 9.0, 2 h, and 32 min, respectively. Under the optimum experimental conditions, the linear range of the calibration curves were from 5.0 to 2000 µg/L with correlation coefficients (R²) between 0.9922 and 0.9996. The limit of detection and limit of quantification were 1.5 µg/L and 5.0 µg/L, respectively, and the recoveries were found to be in range of 69.0–113.3%. The analysis of precision for intraday and interday were less than 10.40 and 10.59%. The device has been successfully achieved photopolymerization under water atmosphere. The results indicated that this method is simple, accurate, and satisfactory for the pretreatment and determination of glucocorticoids in complex cosmetics samples.     

Physicochemical assessment of prednisone adsorption on two molecular composites using statistical physics formalism in cosmetics

In this paper, we consider two different polyethylene filter plates coated with multi-walled carbon nanotubes (MWCNTs) and synthesized by surface molecularly imprinted technique, namely plate@MWCNTs@MIPs (PMIPs) and plate@MWCNTs@NIPs (PNIPs). They were used as effective adsorbents for selective adsorption and detection of prednisone (PS) in cosmetics. As a first assessment to investigate the performance of these adsorbents, the PS adsorption isotherms were analyzed using an advanced multilayer statistical physics model at three different temperatures ( 293, 303 and 313 K) and over a wide PS concentration range (0.09–1.5 mg/mL). The obtained analyzing results from the best fitting model showed that the PMIPs adsorbent displayed a high adsorption capacity (27.4 mg/g) due to the contribution of the number of PS molecules per site (n_m) combined with the receptor sites density (D_m), which displayed a high recognition ability due to the adsorption energy. Modeling analysis process indicated that the PS molecules could be anchored on the PMIPs and PNIPs surfaces via a non-parallel orientation where the adsorption is a multi-molecular process. The calculated adsorption energies globally varied from 4.51 to 7.62 kJ/mol, confirming the physical nature of the adsorption process for the studied systems, which is beneficial in cosmetics. Finally, three thermodynamic potentials (entropy, internal energy and free enthalpy) were evaluated for a better understanding of the physico-chemical behavior of the adsorption process.     

高效液相色谱法测定化妆品中10种限用物质

建立了乙腈超声提取、高效液相色谱/二极管阵列检测快速测定化妆品中的氢醌、水杨酸、苯酚、苯氧乙醇、对羟基苯甲酸甲酯、对羟基苯甲酸乙酯、对羟基苯甲酸丙酯、对羟基苯甲酸丁酯、双氯酚、三氯生10种限用物质含量的分析方法.对提取方法、液相色谱条件和检测条件进行了优化,10种限用物质标准溶液的线性范围为0.01～0.1g/L,50...     

微波消解–石墨炉原子吸收法测定化妆品中的铅

建立了微波消解–石墨炉原子吸收光谱法测定化妆品中铅的方法。探讨了样品前处理条件、基体改性剂的选择和优化、石墨炉升温条件等对测定结果的影响。在优化的试验条件下,铅的质量浓度在0~100 ng/mL范围内与吸光度具有良好的线性关系,线性相关系数r=0.9991,检出限为0.33 ng/mL。用该法对5种化妆品中的铅进行测定,加标回收率在95.0%~106.1%之间,测定结果的相对标准偏差不大于3.6%。该方法可应用于化妆品中痕量铅的分析。     

顶空气相色谱法测定化妆品中15种挥发性有机溶剂残留

建立了化妆品中15种挥发性有机溶剂残留的顶空气相色谱测定方法。样品经60 ℃、30 min静态顶空后,采用气相色谱-氢火焰离子化检测器进行检测,外标法定量。加标回收试验结果表明: 15种挥发性有机溶剂残留平均回收率为62.8%～116%,相对标准偏差均小于5%。方法的检出限为0.09～0.68 mg/kg。该方法可有效克服基体干扰,一次进样可同时分离和测定化妆品中15种挥发性有机溶剂,准确灵敏,简单快速,适用于化妆品中挥发性有机溶剂残留的检测。     

萃取纳升喷雾-离子迁移谱法现场快速筛查化妆品中8种禁用抗生素

采用萃取纳升喷雾结合离子迁移谱技术,建立了化妆品中8种禁用抗生素的现场快速筛查方法。对萃取纳升喷雾毛细管拉制条件、萃取纳升喷雾离子化条件、离子迁移谱检测条件等进行了详细考察和优化。在优化的实验条件下,8种禁用抗生素的方法检出限为20 mg/kg,离子迁移谱分析时间小于20 ms,单个样品全部检测时间不超过30 s。对于筛检出的疑似阳性样品,进一步采用超高效液相色谱-串联质谱进行确证。该方法流程简便、快捷高效,为化妆品中违禁组分的现场快速筛查提供了较为广阔的应用前景。