Ag/Bi4Ti3O12栅n沟道铁电场效应晶体管制备及存储特性

在溶胶-凝胶工艺获得高质量Bi4Ti3O12薄膜的基础上,制备了Ag/Bi4Ti3O12栅n沟道铁电场效应晶体管. 研究了Si基Bi4Ti3O12薄膜的生长特性及其对铁电薄膜/硅的界面状态和铁电场效应晶体管存储特性的影响. 研究表明,在合理的工艺条件下可以获得具有较高c-轴择优取向的纯钙钛矿相Si基Bi4Ti3O12铁电薄膜并有利于改善Bi4Ti3O12/Si之间的界面特性; 顺时针回滞的C-V特性曲线和C-T曲线表明Ag/Bi4Ti3O12栅n沟道铁电场效应晶体管具有极化存储效应和一定的极化电荷保持能力; 器件的转移(Isd-VG)特性曲线显示Ag/Bi4Ti3O12栅n沟道铁电场效应晶体管具有明显的栅极化调制效应.     

SrBi2Ta2O9/Bi4Ti3O12复合铁电薄膜的制备与特性研究

采用溶胶凝胶工艺在p-Si衬底上制备了SrBi₂Ta₂O₉/Bi₄Ti₃O₁₂复合铁电薄膜. 研究了SrBi₂Ta₂O₉/Bi₄Ti₃O₁₂复合薄膜的微观结构与生长行为、铁电性能和疲劳特性. 研究表明: Si衬底Bi₄Ti< 关键词： 2Ta₂O₉')" href="#">SrBi₂Ta₂O₉ 4Ti₃O₁₂')" href="#">Bi₄Ti₃O₁₂ 复合铁电薄膜 溶胶凝胶工艺     

Si基Bi4Ti3O12铁电薄膜的制备与特性研究

采用sol-gel工艺, 在分层快速退火的工艺条件下成功地制备了高质量Si基Bi_{4Ti3O12铁电薄膜. 研究了Si基Bi4Ti3O12薄膜的生长行为、铁电性能、C-V特性和疲劳特性. 研究表明: Si基Bi4Ti3O12薄膜具有随退火温度升高沿c轴择优生长的趋势; 退火温度通过影响薄膜的晶粒尺寸、生长取向和薄膜中载流子的浓度来改变Si基Bi关键词： sol-gel法 铁电薄膜 4Ti3O12')" href="#">Bi4Ti3O12 C-V特性}     

La掺杂对Bi4Ti3O12薄膜铁电性能的影响

利用Sol-Gel法在Pt/Ti/SiO₂/Si衬底上制备出Bi₄Ti₃O₁₂和Bi_3.25La_0.75Ti₃O₁₂薄膜，研究了La掺杂对Bi₄Ti₃O₁₂薄膜的晶体结构、铁电性能和疲劳特性的影响，发现La掺杂没有改变Bi₄Ti₃O₁₂薄膜的基本晶体结构，并且提高了Bi₄Ti₃O₁₂铁电薄膜的剩余极化值和抗疲劳性能，对La掺杂改善Bi₄Ti₃O₁₂铁电薄膜性能的机理进行了讨论. 关键词： 铁电性能 4Ti₃O₁₂薄膜')" href="#">Bi₄Ti₃O₁₂薄膜 3.25La_0.75Ti₃O₁₂薄膜')" href="#">Bi_3.25La_0.75Ti₃O₁₂薄膜 sol-gel法 La掺杂     

Si基Bi3.25La0.75Ti3O12铁电薄膜的制备与特性研究

采用Sol-Gel工艺低温制备了Si基Bi_3.25La_0.75Ti₃O₁₂铁电薄膜.研究了退火温度对薄膜微观结构、介电特性与铁电性能的影响.500℃退火处理的Bi_3.25La_0.75Ti₃O₁₂薄膜未能充分晶化，晶粒细小且有非晶团聚，介电与铁电性能均较差.高于550℃退火处理的Bi_3.25La_{0.75 关键词： 铁电薄膜 3.25}La_0.75Ti₃O₁₂')" href="#">Bi_3.25La_0.75Ti₃O₁₂ Sol-Gel工艺     

溶胶-凝胶法制备Sr2Bi4Ti5O18薄膜及其铁电性能研究

采用溶胶-凝胶法,在氧气氛中和层层晶化的工艺条件下,成功地制备了沉积在Pt/Ti/SiO₂/Si(100)衬底上的铁电性能优良的Sr₂Bi₄Ti₅O₁₈ (SBTi)薄膜,并研究了SBTi薄膜的微结构、表面形貌、铁电性能和疲劳特性.研究表明：薄膜具有单一的层状钙钛矿结构，且为随机取向；薄膜表面光滑，无裂纹，厚度约为725nm；铁电性能测试显示较饱和、方形的电滞回线，当外电场强度为275kV/cm时 关键词： 溶胶-凝胶法 铁电薄膜 2Bi₄Ti₅O₁₈')" href="#">Sr₂Bi₄Ti₅O₁₈     

Bi2Ti2O7/Si薄膜的制备及C-V特性研究

采用化学溶液分解法(CSD)在Si衬底上制备了Bi₂Ti₂O₇薄膜.X射线双晶衍射和原子力显微镜检测表明,所制备的薄膜主要为Bi₂Ti₂O₇相的多晶材料.同时还研究了AuBi₂Ti₂O₇/n-Si(100)结构的电容电压(C-V)特性,结果表明,在Bi₂Ti₂O关键词： C-V特性 2Ti₂O₇薄膜')" href="#">Bi₂Ti₂O₇薄膜 电荷迁移     

Si基铁电Bi3.15Nd0.85Ti3O12多层薄膜的一致取向生长和性能的研究

采用脉冲激光沉积(PLD)技术，利用LSCO/CeO₂/YSZ多异质缓冲层，在Si(100)基 片上成功地制备了c轴一致取向的Bi_3.15Nd_0.85Ti₃O12(BNT)铁电薄膜.利用X射线衍射(XRD)和扫描电镜(SEM)分析测定了薄膜的相结构 、取向和形貌特征，考察了沉积温度和氧分压对BNT薄膜微结构、取向和形貌的影响，确定 了BNT薄膜的最佳沉积条件.对在优化的条件下制备得到的BNT薄膜的C-V曲线测试得到了典型 的蝴蝶形曲线，表明该薄膜具有较好的电极化反转存储特性.最后讨论了BNT薄膜铁电性能与 薄膜取向的相关性. 关键词： 3.15Nd_0.85Ti₃O₁₂')" href="#">Bi_3.15Nd_0.85Ti₃O₁₂ 铁电薄 膜 多层异质结 脉冲激光沉积     

非晶钛酸铋的晶化过程

利用差热分析、X射线衍射和透射电子显微镜等技术对溶胶-凝胶法合成的凝胶的晶化过程进行了分析，实验结果表明，Bi₄Ti₃O₁₂非晶凝胶晶化过程经历了四个过程：首先在433℃先形成了Bi₂O₃和TiO₂亚稳相，然后在488℃时TiO₂亚稳相与Bi₂O₃反应形成Bi，Ti复合氧化物亚稳相Bi₂T 关键词： 钛酸铋 铁电材料 溶胶凝胶 非晶 晶化过程     

退火气压对Bi3.25La0.75Ti3O12铁电薄膜的微观结构和铁电性能的影响

采用sol-gel法在Pt/TiO₂/SiO₂/p-Si(100)衬底上制备了Bi_3.25La_0.75Ti₃O₁₂(BLT)铁电薄膜,研究了在750 ℃时不同退火气压(p_{O2:10^-4—3 atm)对薄膜微观结构和电学性能的影响.XRD和拉曼光谱结果表明在10^-4和3 atm氧气压下退火 关键词： 3.25}La_0.75Ti₃O₁₂')" href="#">Bi_3.25La_0.75Ti₃O₁₂ 铁电性能 sol-gel法 正交化度     

Ferroelectric and dielectric properties of SrBi<Subscript>4</Subscript>Ti<Subscript>4</Subscript>O<Subscript>15</Subscript> thin films grown on Bi<Subscript>4</Subscript>Ti<Subscript>3</Subscript>O<Subscript>12</Subscript> film layer

Ferroelectric and dielectric properties of bilayered ferroelectric thin films, SrBi₄Ti₄O₁₅ grown on Bi₄Ti₃O₁₂, were investigated. The thin films were annealed at 700°C under oxygen atmosphere. The bilayered thin films were prepared on a Pt(111)/Ti/SiO₂/Si substrate by a chemical solution deposition method. The dielectric constant and dielectric loss of the bilayered thin films were 645 and 0.09, respectively, at 100 kHz. The value of remnant polarization (2P _r) measured from the ferroelectric thin film capacitors was 60.5 μC/cm² at electric field of 200 kV/cm. The remnant polarization was reduced by 22% of the initial value after 10¹⁰ switching cycles. The results showed that the ferroelectric and dielectric properties of the SrBi₄Ti₄O₁₅ on Bi₄Ti₃O₁₂ ferroelectric thin films were better than those of the SrBi₄Ti₄O₁₅ grown on a Pt-coated Si substrate suggesting that the improved properties may be due to the different nucleation and growth kinetics of SrBi₄Ti₄O₁₅ on the c-axis-oriented Bi₄Ti₃O₁₂ layer or on the Pt-coated Si substrate.     

Ferroelectric properties of bilayer structured Pb(Zr0.52Ti0.48)O3/SrBi2Ta2O9 (PZT/SBT) thin films on Pt/TiO2/SiO2/Si substrates

Pb(Zr_0.52Ti_0.48)O₃ (PZT) thin films with large remanent polarization and SrBi₂Ta₂O₉ (SBT) thin films with excellent fatigue-resisting characteristic have been widely studied for non-volatile random access memories, respectively. To combine these two advantages_, bilayered Pb(Zr_0.52Ti_0.48)O₃/SrBi₂Ta₂O₉ (PZT/SBT) thin films were fabricated on Pt/TiO₂/SiO₂/Si substrates by chemical solution deposition method. X-ray diffraction patterns revealed that the diffraction peaks of PZT/SBT thin films were completely composed of PZT and SBT, and no other secondary phase was observed. The electrical properties of the bilayered structure PZT/SBT films have been investigated in comparison with pure PZT and SBT films. PZT/SBT bilayered thin films showed larger remanent polarization (2P_r) of 18.37 μC/cm² than pure SBT and less polarization fatigue up to 1 × 10⁹ switching cycles than pure PZT. These results indicated that this bilayered structure of PZT/SBT is a promising material combination for ferroelectric memory applications.