差示扫描量热法对芝麻酚纯度标准物质的定值

建立了采用差示扫描量热法对芝麻酚纯度标准物质的定值及不确定度评价的数学模型、有效检测技术和分析方法.采用差示扫描量热法测量芝麻酚样品纯度的实验条件为升温速率3.0 K/min,称样量3.4～4.7 mg,炉内气体为静态空气.对通过均匀性检验和长期稳定性考察的芝麻酚纯度标准物质进行定值和不确定度评价,同时采用高效液相色谱...     

多波长薄层扫描分析非那西丁和咖啡因

将阵列感光的光纤光谱仪与二维电移平台结合,完成多波长薄层反射扫描定量,提供二阶张量数据输出.设计的仪器采取“弓”形二维移动扫描,探头与薄层板间距2mm,能在200ms积分时间内同时获取紫外—近红外2048个波长响应值,利用Kubelka-Munk函数积分值定量,提高了薄层扫描定量的线性度和准确度,检出范围覆盖纳克到毫克...     

疏水缔合聚丙烯酰胺与双子表面活性剂的相互作用

制备了一种脂肪酸酯双磺酸盐型双子表面活性剂, 利用粘度法、界面张力法和原子力显微镜研究了疏水缔合聚丙烯酰胺与双子表面活性剂在溶液中的相互作用. 实验结果表明: 疏水缔合聚丙烯酰胺在溶液中能够通过自组装形成疏水微区并发展成网络结构, 疏水微区与表面活性剂在溶液中能形成混合胶束; 当一定量的表面活性剂加入时, 对疏水缔合聚丙烯酰胺的自组装起促进作用, 而过多双子表面活性剂的加入又会对聚合物分子的自组装起抑制作用, 从而显著影响疏水缔合聚丙烯酰胺的溶液性质, 随着表面活性剂浓度的增加, 聚合物溶液粘度先增加、再降低; 同时, 疏水缔合聚丙烯酰胺对双子表面活性剂的界面性能也有较大影响, 聚合物的加入使双子表面活性剂降低油/水界面张力的能力下降, 油/水界面张力达到平衡所需时间延长.     

线性扫描伏安法测定废水中镉离子的教学实践

针对＂线性扫描伏安法测定废水中镉离子＂实验中的问题,提出允许适度＂失败＂,引入竞争机制,激发学生学习兴趣和创新意识的教学方法,并结合教学案例加以说明。     

线性扫描极谱法测定消旋山莨菪碱

用线性扫描极谱法和循环伏安法研究了消旋山莨菪碱在0.3mol·L~(-1)磷酸氢二钠-磷酸二氢钾缓冲溶液(pH 6.70)中的电化学行为。消旋山莨菪碱于-1.095V(vs.SCE)处产生一灵敏的吸附波,消旋山莨菪碱质量浓度在0.10～10.0mg·L~(-1)范围内与其一次微分线性扫描峰电流i_p呈线性关系,检出限(3S/N)为0.06mg·L~(-1)。对5.0mg·L~(-1)消旋山莨菪碱溶液进行6次平行试验,相对标准偏差为0.34%,该方法用于片剂中消旋山莨菪碱含量的测定,测定值与标示值相符。     

Ir(111)表面石墨烯中缺陷的原子结构确认

识别和解析石墨烯中缺陷的精确原子结构是研究不同类型缺陷的物化特性, 实现石墨烯物性调控的前提, 可以为在原子尺度研究石墨烯缺陷的构效关系提供重要的实验依据. 本文结合扫描隧道显微镜(STM)和原子力显微镜(AFM)确认了在Ir(111)表面生长的石墨烯中自发形成的缺陷, 以及通过离子轰击方法在石墨烯中引入的多种缺陷结构, 包括单空位缺陷、 非六元环拓扑结构以及石墨烯层下的基底缺陷.     

双金属氮化物Co3W3N/CNTs纳米复合材料的制备及其室温常压氮还原性能

采用水热法并经氨气保护热处理制备了双过渡金属氮化物Co3W3N/CNTs复合材料,得到了价格低廉且拥有良好氮电化学还原性能(NRR)的催化剂。通过调节已经预氧化的CNTs与过渡金属氮化物前驱体CoWO4的比例以及氨气热处理温度,实现了Co3W3N在CNTs表面的均匀负载。扫描电子显微镜(SEM)及透射电子显微镜(TEM)测试结果显示该电化学活性纳米微粒均匀地分散于CNTs表面,表明经预氧化的CNTs由于表面富集了较多的活性基团,有利于双过渡金属氮化物的分散生长。热处理后CNTs表面的Co3W3N微粒尺寸约为20 nm,相较于无载体的Co3W3N尺寸(100 nm)有明显减小。室温条件下,在N2饱和的0.01 mol·L^-1 H2SO4溶液中测试了该纳米复合材料在不同过电位下的NRR,该材料在-0.3 V(vs RHE)时的产氨率及法拉第效率分别可达12.73μg·h^-1·cm-2和13.59%,对比同样条件下,纯相Co3W3N的产氨率及法拉第效率仅为1.08μg·h^-1·cm^-2和1.76%。结果表明,通过水热反应和氨气保护热处理的Co3W3N/CNTs纳米复合材料具有良好的NRR性能。     

Preparation and Photocatalytic Activity of Ce,H3PW12O40 co-doped TiO2 Hollow Fibers

A series of Ce, H3PW12O40 co-doped TiO2 hollow fibers photocatalysts have been prepared by sol-gel method using ammonium ceric nitrate, H3PW12O40 and tetrabutyltitanate as precursors and cotton fibers as template, followed by calcination at 500 ℃ in N2 atmosphere for 2 h. Scanning electron microscopy, X-ray diffraction, nitrogen adsorption-desorption mea- surements, and UV-Vis spectroscopy are employed to characterize the morphology, crystal structure, surface structure, and optical absorption properties of the samples. The photo- catalytic performance of the samples has been studied by photodegradation phenol in water under UV and visible light irradiation. The results show that the TiO2 fiber materials have hollow structures, and the co-doped TiO2 hollow fibers exhibit higher photocatalytic activities for the degradation of phenol than un-doped, single-doped TiO2 hollow fibers under UV and visible light. In addition, the recyclability of co-doped TiO2 fibers is also confirmed that the TiO2 fiber retains ca. 90% of its activity after being used four times. It is shown that the co-doped TiO2 fibers can be activated by visible light and may be potentially applied to the treatment of water contaminated by organic pollutants. The synergistic effect of Ce and H3PW12O40 co-doping plays an important role in improving the photocatalytic activity.     

数字离子阱质谱仪低质量截止值的改进方法

本研究在实验室自制的线形数字离子阱质量分析器上,通过改变数码电源的频率扫描方式,在CID过程中,通过扫描数字束缚方波电源的频率和数字激发方波的频率实现母体解离。例如对于利血平母体离子,当将离子数字束缚方波频率从500 kHz扫描到560 kHz,可以测量到低质荷比的碎片离子,成功实现了串级质谱分析的低质量碎片离子的分析。通过与利血平三重四极质谱串级质谱分析实验结果的比较,发现可以在数字离子阱质谱仪上获得与三重四极质谱相同的串级质谱测量结果。结果表明,本方法可以用于低质量离子的测量,克服了传统离子阱质谱进行串级质谱分析的一个主要难点,显著提高数字离子阱质谱的性能。     

Study of In Situ Formation of Magnesium Hydroxide Whisker via Basic Magnesium Chloride Whisker Regulated by Organic Parcels at Low Temperature

In this work, we demonstrate an in situ phase conversion from basic magnesium chloride（BMC） into magnesium hydroxide whisker by using polar organic solvent at low temperature. The morphology and phase composition of magnesium hydroxide whiskers prepared at different reaction temperature, alkali concentration and organic solvent were analyzed by X-ray diffraction（XRD） and scanning electronic microscope（SEM）. It was found that when one of the organic solvents such as absolute ethyl alcohol, butanol, polyethylene glycol（PEG-400）, acetone, et al. was selected as the template, the precursor BMC can transform into whisker-like magnesium hydroxide through precipitate transformation in low temperature and non-hydrothermal system. It can be reasonably explained that the regulation of Mg^2＋ solubility by those organic solvents and the sustained release of Mg^2＋ dissolution by organic adsorption played a significant role in the formation of magnesium hydroxide whisker via BMC whisker as the precursor.