氮气退火对二氧化钛薄膜光学性能的影响

 提出了一种利用离子注入和后续退火制备氮掺杂TiO₂薄膜的方法。首先在室温下向石英玻璃中注入Ti离子,随后在氮气中退火到900 ℃,从而制备了氮掺杂的玻璃基TiO₂薄膜。SRIM2006程序模拟和卢瑟福背散射谱（RBS）研究表明注入离子从样品表面开始呈高斯分布,实验结果和模拟结果吻合很好。X射线光电子能谱（XPS）研究结果表明注入态样品中形成了金属Ti和TiO₂,900 ℃退火后金属Ti转变成TiO₂,同时N原子替代少量的晶格O原子形成了O－Ti－N化合物。紫外-可见吸收光谱（UV-Vis）结果显示,当退火温度至500 ℃时,在吸收光谱中开始出现TiO₂的吸收边,随退火温度升高到900 ℃,由于O－Ti－N化合物形成,TiO₂的吸收边从3.98 eV红移到3.30 eV,TiO₂吸收边末端延伸到可见光区,在可见光区的吸收强度明显增加。     

环境气氛压强对熔石英紫外激光损伤阈值的影响

 利用1∶1, S∶1, R∶1方法,测试了不同真空度（10-3～105 Pa）和不同气氛（空气、氮气、氧气）环境下熔石英351 nm激光损伤阈值,测试结果表明,用1∶1, S∶1方法测试得到的阈值在不同气氛压强下几乎相等;R∶1损伤阈值受气压的影响较大,在小于等于10³ Pa气压下,较105 Pa气压的阈值降低28%～41%;但R∶1损伤阈值同气氛的关系不大,在同气压下差别小于10%,在测量值误差范围内。利用50%破坏几率对应的损伤阈值Fth（R∶1）一半的激光能量密度辐照样品,考察其抗多脉冲辐照的能力,分析表明,在同样的能量密度辐照下,10³ Pa空气及氮气环境和105 Pa氮气环境下同样具有高的寿命;而10^-3 Pa高真空环境下其寿命较短,在10^-1 Pa低真空环境下其寿命最短。     

层间热处理对SiO2/ZrO2双层膜的影响

 以正硅酸乙酯和丙醇锆为前驱体,用溶胶-凝胶法在K9基片上提拉镀制SiO₂/ZrO₂双层膜。采用不同实验步骤制备了2个样品,样品1镀完SiO₂后直接镀ZrO₂ ,样品2镀完SiO₂经热处理后再镀ZrO₂。采用原子力显微镜、椭偏仪、紫外-可见分光光度计对薄膜进行表征。针对SiO₂/ZrO₂双层膜,考虑到膜间渗透的影响,采用３层Cauchy模型进行椭偏模拟,椭偏参数的模拟值曲线与椭偏仪的测量值曲线十分吻合,进而发现热处理可以使SiO₂/ZrO₂双层膜之间的渗透减少近23 nm,从而提高其峰值透射率。利用输出波长1.064 mm,脉宽8.1 ns的激光束对样品进行了损伤阈值的测试,用光学显微镜观察损伤形貌,结果发现两者损伤阈值分别为13.6 J/c2和14.18 J/cm²,均为膜的本征损伤。     

Ab initio study of H and He migrations in β-phase Sc, Y, and Er hydrides

Ab initio calculations based on the density functional theory have been performed to investigate the migrations of hydrogen(H) and helium(He) atoms in β-phase scandium(Sc),yttrium(Y),and erbium(Er) hydrides with three different ratios of H to metal.The results show that the migration mechanisms of H and He atoms mainly depend on the crystal structures of hydrides,but their energy barriers are affected by the host-lattice in metal hydrides.The formation energies of octahedral-occupancy H(H oct) and tetrahedral vacancy(V tet) pairs are almost the same(about 1.2 eV).It is of interest to note that the migration barriers of H increase with increasing host-lattice atomic number.In addition,the results show that the favorable migration mechanism of He depends slightly on the V tet in the Sc hydride,but strongly on that in the Y and Er hydrides,which may account for different behaviours of initial He release from ScT2 and ErT2.     

中华圆田螺血细胞的分类和吞噬活性

血细胞作为主要的免疫效应细胞在贝类的免疫和防御中有重要作用。本文通过相差显微镜和透射电子显微镜对中华圆田螺(Viviparus chinensis)血细胞的形态与类型以及血细胞对枯草芽孢杆菌的吞噬观察。结果发现壳高4～6 cm的田螺血细胞浓度为(2.17±0.38)×106个/mL。根据血细胞大     

鑽研初中平面几何教材的几点体会

教师掌握全部教材的精神,是改进教学、提高教学質量的主要关鍵之一。因此教师必須深入鑽研教学大綱和教材。数年以来,我們在这一方面作了一些努力,在教学質量上得到一定的提高。現在我把鑽研初中平面几何教材的几点体会,提出来和同志們商榷。     

万花筒型散射的杨-Baxter方程组

本文以根图及Weyl分类的B_n与D_n万花筒型散射所满足的杨-Baxter方程组,并证明它们在Coxeter 图端点具有反射行为,也讨论了它们的物理意义。     

杂质对溶胶-凝胶SiO2薄膜激光损伤的影响

 采用溶胶-凝胶法制备了含有吸收性杂质和非吸收性杂质的SiO₂增透膜,采用波长为1 064 nm的激光对其进行了小光斑激光预处理,对比研究了预处理前后的激光损伤差异,研究表明：激光预处理对于洁净的SiO₂薄膜影响不大;含10 μm SiO₂颗粒杂质的样品微透镜效应很明显,容易成为损伤起始的种子,激光预处理后情况有所改善;含有CeO₂颗粒杂质的样品表现出了很强的吸收性质,损伤阈值降低到不足洁净样品的一半。所有样品激光预处理后损伤形貌未发生变化,透光率峰值均有约50 nm的蓝移。     

Irradiation effects of CO2 laser parameters on surface morphology of fused silica

To understand the surface morphology evolution of fused silica induced by 10.6-μm CO2 laser irradiation at different parameters,this paper reports that optical microscopy,profilometry,and hydrophilicity tests are utilized to characterize the surface structure and roughness of the laser irradiated area. The results show that three typical surface morphologies and two typical hydrophilicity test images are observed at different laser powers and pulse durations. The correlations between surface temperature and surface morphology as well as hydrophilicity behaviours are presented. The different hydrophilicity behaviours are related to surface structures of the laser-induced crater and thermal diffusion area. The thermal diffusion length monotonously increases with increasing laser power and pulse duration. The crater width is almost determined by the laser beam size. The crater depth is more sensitive to the laser power and pulse duration than the crater width.     

The effect of Si content on the martensitic transformation temperature of Ni55.5Fe18Ga26.5-xSix alloys

This paper investigates the effects of substitution of Si for Ga on the martensitic transformation behaviours in Ni-Fe-Ga alloys by using optical metallographic microscope and differential scanning calorimetry (DSC) methods. The structure type of Ni55.5Fe18Ga26.5-xSix alloys is determined by x-ray diffraction (XRD),and the XRD patterns show the microstructure of Ni-Fe-Ga-Si alloys transformed from body-centred tetragonal martensite (with Si content x = 0) to body-centred cubic austenite (with x = 2) at room temperature. The martensitic transformation temperatures of the Ni55.5Fe18Ga26.5-xSix alloys decrease almost linearly with increasing Si content in the Si content range of x ≤ 3. Thermal treatment also plays an important role on martensitic transformation temperatures in the Ni-Fe-Ga-Si alloy. The valence electronic concentrations,size factor,L21 degree of order and strength of parent phase influence the martensitic transformation temperatures of the Ni-Fe-Ga-Si alloys. An understanding of the relationship between martensitic transformation temperatures and Si content will be significant for designing an appropriate Ni-Fe-Ga-Si alloy for a specific application at a given temperature.