实验仪器和教学方法优化研究

针对大学生物理知识减少和仪器设备智能化的现状,在综合分析的基础上,提出了相应的对策.     

5-氮杂吲哚的合成工艺研究

本文以3-甲基-4-硝基氮氧化吡啶为起始原料,经两步反应合成5-氮杂吲哚。通过单因素实验法研究了温度、N,N-二甲基甲酰胺(DMF)、N,N-二甲基甲酰胺二甲缩醛(DMA)、铁粉等因素对反应的影响。较佳工艺条件下,产品按3-甲基-4-硝基吡啶氮氧化物计总收率为88.57%,较文献[1,2]提高了6%。通过熔点测定、1H NMR对最终产物进行了结构表征。此工艺的优点在于操作简单,反应时间短,成本低,收率高,适合于工业化生产。     

普通化学教学改革与探索

结合近几年的普通化学教学实践,我们分析了普通化学教学实践过程中存在的一些问题,并提出了培养学生的创新能力,不断更新教学内容,将理论教学与实验教学相结合等几方面建议。     

Cosmic ray test for a T0 detector

The endcap of time-of-flight (ETOF) detector in BES (Beijing Spectrometer) III is planned to be upgraded by using multi-gap resistive plate chambers (MRPCs) and the designed time resolution of the MRPCs is around 50 ps. Thus a time-zero (T0) detector needs to be built to offer a high quality reference time for the MRPCs beam test. So a T0 detector is built using plastic scintillator tiles (BC420) to couple with four fast phototubes (PMTs, Hamamatsu H6533). The timing properties of the detector is studied by using a cosmic ray test and factors related to the time resolution, such as plastic scintillator size, readout mode and angle effects, are discussed. T0 detector timing resolutions of ～41-62 ps are achieved, which means that the T0 detector can be used in the MRPC beam test.     

Time calibration for the end cap TOF system of BESⅢ

The time calibration for end cap TOF system of BESⅢ is studied in this paper.It has achieved about 110 ps time resolution for muons in dimu events.The pulse height correction using electronic scan curve and the predicted time calculated using Kalman filter method are introduced.This paper also describes the study of using electrons and muous as calibration samples.     

PMT overshoot study for the JUNO prototype detector

The quality of PMT signals is crucial for large-size and high-precision neutrino experiments, but most of these experiments are affected by the overshoot of PMT signals from the positive HV-single cable scheme. Overshoot affects the trigger, dead time and charge measurement from a detector. For the JUNO prototype detector, we have performed a detailed study and calculation on PMT signal overshoot to control the ratio of overshoot to signal amplitude to ~1%, with no effect on other PMT parameters.     

原子核单粒子共振态的研究进展

共振是自然界普遍存在的有趣现象。在核物理领域,存在许多奇特现象,共振在其中扮演着重要角色。介绍了近期发展的RMF-CSM、RMF-CGF和RMF-CMR方法及其对原子核单粒子共振态的研究。给出了120Sn,31Ne等核的单粒子共振态的能量和宽度及其随质量数、形变的变化规律,分析了19C,31Ne和39Mg等核的晕形成的物理机制和在N=20附近能级反转的原因。特别是新发展的RMF-CMR方法,在描述稳定核和奇特核方面都取得了成功,支持Zr同位素存在巨晕的预言。Resonance is an interesting phenomenon in nature. In nuclear physics, resonance plays an important role in the formation of many exotic phenomena. This paper introduces the recently developed RMF-CSM, RMFCGF, and RMF-CMR methods and their researches on nuclear single-particle resonances. The energies and widths of the single-particle resonant states in 120Sn and 31Ne and their evolution to mass number and deformation are given. In addition, the physical mechanism of the halo formation in 19C, 31Ne and 39Mg and the cause of energy level inversion near N=20 are analyzed. In particular, the newly developed RMF-CMR approach has been successful in describing stable and exotic nuclei and supports the prediction that Zr isotopes exist in a giant halo.     

傅里叶红外光谱法研究GAP/AP混合体系的快速热裂解

用T-Jump/FTIR在线联用分析技术,研究了GAP/AP混合体系在模拟燃烧条件下快速加热高温高压的热裂解。结果表明,GAP/AP混合体系的主要热裂解气相产物的组成发生了变化,说明组分之间存在相互作用。压力对GAP/AP混合体系气相产物有明显的影响,表明混合体系组分GAP和AP之间的相互作用是通过AP分解气相产物进行的,混合体系不但存在气相之间的反应,也存在气相/凝聚相反应。而温度并没有影响AP对GAP的作用。用T-Jump/FTIR在线分析技术能够实现模拟燃烧条件下含能材料实时气体产物分析,为从微观反应的角度探索含能材料的快速高压热裂解及其组分之间的相互作用提供一条技术途径。     

高度有序的二氧化钛纳米管阵列的制备及其光催化活性的研究

采用电化学阳极氧化法在钛表面构筑了一种结构有序、微米级的TiO₂纳米管阵列膜层. 考察了制备电压、氧化时间、溶液搅拌等实验参数对TiO₂纳米管阵列形貌和尺寸的影响. 应用SEM和XRD对膜层的形貌和晶型进行了分析和表征, 并通过TiO₂纳米管阵列膜对甲基橙的光催化降解, 研究了TiO₂纳米管阵列膜层结构与光催化活性的关系. 结果表明: 阳极电压和溶液搅拌对制备TiO₂纳米管阵列的结构起到关键的作用. 控制20 V电压制备的TiO₂纳米管阵列膜, 管长达2.6～3.3 μm, 经500 ℃热处理后具有最高的光催化活性, 其光催化性能明显优于一般的TiO₂纳米颗粒膜.