排序方式: 共有25条查询结果,搜索用时 359 毫秒
1.
光纤药物原位溶出度/释放度监测仪实时监测复方氯唑沙宗片体外溶出度 总被引:1,自引:0,他引:1
研制了光纤-光学传感-药物溶出监测仪并应用于复方氯唑沙宗片的实时-原位体外溶出度.分支光纤的一端与光源相接,另一端与检测器连接,其公共端部探头浸入于盛于溶出杯中的溶解液中.借联机的计算机进行数据记录及处理,对复方氯唑沙宗片的组分对乙酰氨基酚和氯唑沙宗的回收率在低、中、高三个浓度水平进行了试验,结果依次为98.3%,102.3%和103.1%及108.6%,98.7%和97.7%,其相应的RSD值为1.0%,1.4%和0.4%及1.7%,1.6%及1.3%.应用此监测仪对药片的溶出全过程进行了监控,并显示了药物的溶解曲线,相关的溶出参数可随时提取.试验证明,使用该仪器可获得药物溶出全过程的真实情况的信息. 相似文献
2.
3.
Realization of MMI Power Splitter by UV-light Imprinting Technique Using Hybrid Sol-Gel SiO2 Materials 下载免费PDF全文
An efficient fabrication scheme of buried ridge waveguide devices is demonstrated by UV-light imprinting technique using organic-inorganic hybrid sol-gel Zr-doped SiO2 materials. The refractive indices of a guiding layer and a cladding layer for the buried ridge waveguide structure are 1.537 and 1.492 measured at 1550nm, respectively. The tested results show more circular mode profiles due to existence of the cladding layer. A buried ridge single-mode waveguide operating at 1550 nm has a low propagation loss (0.088 dB/cm) and the 1× 2 MMI power splitter exhibits uniform outputs, with a very iow splitting loss of 0.029 dB at 1549nm. 相似文献
4.
16×0.8nm硅基二氧化硅阵列波导光栅设计 总被引:2,自引:2,他引:0
给出了更为合理的阵列波导光栅(AWG)的设计原则。在设计时兼顾了输出谱的非均匀性Lu和输出通道数N的要求,克服了设计中可能引起通道数N丢失和不考虑输出谱非均匀性Lu的缺点。用该方法设计了折射率差为0 75%和16×0 8nm的硅基二氧化硅AWG。采用广角有限差分束传播方法(FD BPM)对所设计的AWG进行了输出谱的模拟,得到了插损为 1.5dB、串扰为 48dB、通道非均匀性约为1dB的AWG,设计指标达到了商用要求。 相似文献
5.
A new fabrication technology for three-dimensionally buried silica on silicon optical waveguide based on deep etching and thermal oxidation is presented. Using this method, a silicon layer is left at the side of waveguide. The stress distribution and effective refractive index are calculated by using finite element method and finite different beam propagation method, respectively. The results indicate that the stress of silica on silicon optical waveguide fabricated by this method can be matched in parallel and vertical directions and stress birefringence can be effectively reduced due to the side-silicon layer. 相似文献
6.
7.
采用电子束光刻和感应耦合等离子刻蚀等工艺,研制了一种基于绝缘硅材料的的微环谐振可调谐滤波器.滤波器微环半径为5 μm左右,波导截面尺寸为(350~500 nm)×220 nm不等.测试结果表明,波导宽度为450 nm时器件性能最为理想,其自由频谱宽度为16.8 nm,1.55 μm波长附近的消光比为22.1 dB.通过对微环滤波器进行热光调制,在21.4 ℃~60 ℃温度范围内实现了4.8 nm波长范围的可调谐滤波特性,热光调谐效率达到0.12 nm/℃.研究了基于单环和双环的多通道上下载滤波器,实验结果表明多通道滤波器的信号传输存在串扰,主要是不同信道之间的串扰,尤其在信号上载时,会在相邻信道产生较大串扰. 相似文献
8.
设计了一种基于绝缘上层硅的硅-有机物材料混合马赫-曾德干涉型高速电光调制器.利用光束传播法对顶层硅为220nm的绝缘上层硅基片上的3dB分束器/合束器的结构参数进行模拟,优化后附加损耗仅为0.106dB.为提高模式转换效率,在条形波导和slot波导之间设计了模式转换器,光耦合效率高达98.8%,实现了光模式高效转化.利用时域有限差分法模拟了slot波导平板区掺杂浓度对波导内光学损耗的影响,在几乎不产生光学损耗的情况下,得到平板区轻掺杂浓度为71017/cm3,调制器设计总损耗为0.493dB.利用薄膜模式匹配法对slot波导结构进行仿真分析,考虑slot区等效电容及平板区等效电阻对带宽的影响,优化后得到slot波导结构的限制因子为0.199.采用slot波导与强非线性有机材料LXM1结合的绝缘上层硅平台实现了强普克尔效应,得到电光调制器半波电压长度积为1.544V·mm,电学响应3dB带宽为137GHz. 相似文献
9.
Temperature characterizations of silica asymmetric Mach-Zehnder interferometer chip for quantum key distribution 下载免费PDF全文
Quantum key distribution (QKD) system based on passive silica planar lightwave circuit (PLC) asymmetric Mach-Zehnder interferometers (AMZI) is characterized with thermal stability, low loss and sufficient integration scalability. However, waveguide stresses, both intrinsic and temperature-induced stresses, have significant impacts on the stable operation of the system. We have designed silica AMZI chips of 400 ps delay, with bend waveguides length equalized for both long and short arms to balance the stresses thereof. The temperature characteristics of the silica PLC AMZI chip are studied. The interference visibility at the single photon level is kept higher than 95% over a wide temperature range of 12 ℃. The delay time change is 0.321 ps within a temperature change of 40 ℃. The spectral shift is 0.0011 nm/0.1 ℃. Temperature-induced delay time and peak wavelength variations do not affect the interference visibility. The experiment results demonstrate the advantage of being tolerant to chip temperature fluctuations. 相似文献
10.