LaAlO_3/SrTiO_3界面增强光伏效应

探索LaAlO_3/SrTiO_3(LAO/STO)界面产生的新奇物理特性对理解关联电子系统中多自由度耦合和设计功能材料器件具有重要的价值.本文通过脉冲激光沉积方法在SrTiO_3基底上制备了LAO/STO薄膜,研究了正面照射LAO/STO膜面和侧面照射LAO/STO界面时的光伏效应,探讨了LAO/STO界面对光伏效应的影响.研究结果表明,在同样光照能量下侧面照射LAO/STO界面产生的光电压远高于正面照射LAO/STO膜面产生的光电压,说明LAO/STO界面对光伏效应有明显的增强作用.通过偏压调控可以进一步增强照射LAO/STO界面产生的光电压,当偏压为60 V时, LAO/STO样品的位置探测灵敏度达到了36.8 mV/mm.这些研究结果为设计场调控位置敏感探测器等新型光电子器件提供了新的思路.     

High Beam Quality Green Generation with Output 140W Based on a Thermally-Near-Unstable Flat-Flat Resonator

By using a diode-side-pumped Q-switched Nd:YAG rod laser based on a thermally-near-unstable fiat-fiat resonator, an intracavity-frequency-doubled green beam generation is investigated. Output power 140 W is obtained at a repetition rate of 10kHz and a pulse width of 110ns. The green beam quality factors Mx^2 and My^2, which are measured by a laser beam analyser, are 10.65 and 10.85, respectively, at output power of 124W.     

在GaAs-Al矩形光栅界面上表面增强二次谐波产生

我们以GaAs-Al矩形光栅界面为例具体推导了二次谐波产生的公式.依据Bloembergen和Pershan关于非线性介质的理论,用微扰论方法求解了麦克斯韦方程.理论公式和数值计算均表明,表面增强二次谐波起源于共振激励表面电磁波.     

A 45-μJ, 10-kHz,burst-mode picosecond optical parametric oscillator synchronously pumped at a second harmonic cavity

A novel high-energy picosecond optical parametric oscillator (OPO) was realized by placing an OPO in a second-harmonic (SH) cavity. In a proof-of-principle experiment, we demonstrated excellent burst energy of 45 μJ for the OPO signal at 900 nm that operates at a pulse repetition rate of 10 kHz and a pulse width of 46.8 ps. The beam quality was measured as $M^{2}_{x} = 1.44$ and $M^{2}_{y} = 1.40$ in the orthogonal directions, corresponding to an average beam factor $M^{2} = 1.42$. So far, this study is the first to investigate high-energy ps OPO synchronously pumped in a second-harmonic cavity.     

High-energy picosecond single-pass multi-stage optical parametric generator and amplifier

We demonstrate a new management of multi-stage optical parametric generator(OPG)and amplifier(OPA)to obtain high-energy picosecond sources with high beam quality.The setup of multi-stage OPG-OPA requires mode-matching between the pump beam and the stable mode of the OPG-OPA.In a proof-of-principle experiment,the single-pass multi-stage OPG-OPA consists of three walk-off compensated KTP crystal pairs and two lenses,pumped by an 86 ps,1064 nm 10 kHz picosecond laser.The signal light at~1.77μm has an average output power of 502 mW with record energy up to 50.2μJ.The beam quality factor of the signal light can be improved toM²_x ×M²_yafter filtering out about 40%signal power.To the best of our knowledge,it is the first picosecond single-pass multi-stage OPG-OPA pumped at kHz regime.     

Low-Threshold Mid-Infrared Optical Parametric Oscillator Using Periodically Poled LiNbO33

We report the generation of tunable mid-infrared optical pulses using all-solid-state pumped optical parametri coscillator in a periodically poled lithium niobate. Several ways were used to lower the threshold, resulting in a mean threshold as low as 6.5mW and an achievement of wavelength conversion in the 2.77-4.04μm spectral range. Continuous tuning range from 2.97 to 3.25μm was achieved. The maximum idler output power of 466mW at the wavelength of 3.41μm was obtained, which represents an optical-to-optical conversion efficiency of 19% from incident pump power to the idler output.     

光学元件激光预处理技术研究进展及其应用

光学元件中的杂质和缺陷会引起其激光损伤阈值的大幅降低,现阶段这一问题已成为激光装置向高功率、高能量方向发展的“瓶颈”,亟待解决。在对光学元件激光损伤的研究中发现,用低于光学元件损伤阈值的激光对元件表面进行预处理,可以有效提高光学元件的抗激光损伤能力。对激光预处理技术的提出背景、定性作用机理、定量理论模型及国内外技术应用现状进行了概述。并且介绍了一种可在薄膜制备过程中进行原位实时激光预处理的新型薄膜制备技术。最后指出,激光预处理技术作为一种无污染,可有效改善光学薄膜、光学玻璃、光学晶体元件损伤阈值的最有效方法之一,其作用机理、实用化、仪器化还有待进一步发展。     

考虑液面凹陷时金属熔化与蒸发的数值研究

将关于液面凹陷的Young-Laplace方程与关于金属溶池的流体力学方程组及关于金属蒸发的ＢＧＫ方程联立求解，在给定的电子枪加热条件下，获得了熔池流场和温度场图像及金属蒸气密度、速度和温度分布.数值计算结果表明，随电子枪功率增加，金属的蒸发速率增加，蒸气的密度增大、温度降低而速度升高.与假设液面为平面的情况相比，考虑液面凹陷后求得的液面温度较低，金属的蒸发速率较小，并且这种差别随电子枪功率的增加而扩大.因此对于高功率电子枪加热金属蒸发，必须考虑液面凹陷的影响才能得到符合实际的结果. 关键词： 液面凹陷 Young-Laplace方程 熔池 金属蒸发     

High－Power Blue Light Generation by External Frequency Doubling of an Optical Parametric Oscillator ＊

We report on an all-solid-state high-power quasi-continuous blue light source by the frequency doubling of asignal wave from an optical parametric oscillator (OPO). A 50-mm-long LiB305 (LBO) crystal is used for theOPO, which is pumped by a diode-pumped Nd:YAG green laser (1OkHz, 50ns). Tunable blue emission in a newnonlinear crystal BiB306 (BiBO) is obtained with a wavelength range from 450 to 495 nm. The average power ofthe signal output is as high as 9.3 W from 924 to 970nm. The maximum output of the blue laser with the secondharmonic walk-off compensation is 1.3W average power at 470nm for 6.2W of OPO signal light at 940nm.     

Mid—Infrared Optical Parametric Oscillator Based on All—Solid—State—Pumped Periodically Poled LiNbO

We report the tunable mid-infrared generation with a periodically poled LinbO3(PPLN).Using an all-solid-state pumped Nd:YVO4 laser as the pump source and a PPLN nonlinear crystal with grating periods of 28.2-30.8μm,we have achieved wavelength conversion in the 2.90-4.05μm spectral range by period tuning.The use of confocal cavity design has brought a compact,all-solid-state configuration with an average output powers of idler up to -200mW.The maximum power of 277mW was obtained at the wavelength of 3.35um.