首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   11篇
  免费   36篇
物理学   47篇
  2023年   3篇
  2022年   5篇
  2021年   1篇
  2020年   1篇
  2019年   1篇
  2018年   2篇
  2016年   3篇
  2015年   2篇
  2014年   1篇
  2011年   2篇
  2010年   4篇
  2009年   7篇
  2008年   1篇
  2007年   2篇
  2006年   3篇
  2005年   5篇
  2004年   1篇
  2003年   1篇
  2002年   1篇
  1996年   1篇
排序方式: 共有47条查询结果,搜索用时 15 毫秒
1.
余洋  刘钊  刘可  马超  高宏伟  王小军  薄勇  崔大复  彭钦军 《中国物理 B》2022,31(1):14204-014204
We demonstrate a new management of multi-stage optical parametric generator(OPG)and amplifier(OPA)to obtain high-energy picosecond sources with high beam quality.The setup of multi-stage OPG-OPA requires mode-matching between the pump beam and the stable mode of the OPG-OPA.In a proof-of-principle experiment,the single-pass multi-stage OPG-OPA consists of three walk-off compensated KTP crystal pairs and two lenses,pumped by an 86 ps,1064 nm 10 kHz picosecond laser.The signal light at~1.77μm has an average output power of 502 mW with record energy up to 50.2μJ.The beam quality factor of the signal light can be improved toM2x ×M2yafter filtering out about 40%signal power.To the best of our knowledge,it is the first picosecond single-pass multi-stage OPG-OPA pumped at kHz regime.  相似文献   
2.
Chao Ma 《中国物理 B》2022,31(8):84206-084206
A novel high-energy picosecond optical parametric oscillator (OPO) was realized by placing an OPO in a second-harmonic (SH) cavity. In a proof-of-principle experiment, we demonstrated excellent burst energy of 45 μJ for the OPO signal at 900 nm that operates at a pulse repetition rate of 10 kHz and a pulse width of 46.8 ps. The beam quality was measured as $M^{2}_{x} = 1.44$ and $M^{2}_{y} = 1.40$ in the orthogonal directions, corresponding to an average beam factor $M^{2} = 1.42$. So far, this study is the first to investigate high-energy ps OPO synchronously pumped in a second-harmonic cavity.  相似文献   
3.
4.
We demonstrate a high efficiency multi-kW diode-side-pumped Nd:YAG laser. High cooling efficiency of the diode-side-pumped module in the laser is achieved. The middle portion of the Nd:YAG rod in the module is cooled by a coolant jet with screwed side surface, and the end-caps of the rod without screwed side surface are cooled by Au coated on the surface. The thermal effect of the laser rod is reduced, which leads to high output power with high optical-optical conversion efficiency. By using three identical Nd:YAG laser modules, an output power of 4.2 kW and beam quality of 58 mm・mrad with an optical-optical efficiency of 35% at 1064 nm is obtained in a laser oscillator. By using four identical Nd:YAG laser modules, an output power of 3.1 kW and beam quality of 17 mm・mrad with an optical-optical efficiency of 25.8% is demonstrated in a master oscillator power-amplifier system.  相似文献   
5.
Thermally stable region of a seven-rod resonator is theoretically investigated. A plane-plane symmetric resonator, where the distance between two neighbor rods is two times of that between the rods and the mirrors, is adopted because of its large stable range. Based on the investigation, a seven-rod resonator with an average output power of 3.79 kW and an optical-to-optical efficiency of 53% is developed.  相似文献   
6.
报道了高功率准连续波腔内和频全固态黄光激光器的研究结果.为获得高功率的黄光输出,首先,激光器采用准连续方式运转,在保持抽运水平的条件下降低热效应,从而提高光束质量和光光转换效率;第二,采用热近非稳腔腔型设计,双棒串接补偿热致双折射技术,获得大基模体积高光束质量的基频光;第三,通过优化腔型,采用L型共折叠臂平-凹对称腔,使两束基频光达到空间重合且满足功率配比.通过这些方法,得到了输出功率7.6W,重复频率1.1kHz的准连续波黄光输出.据我们所知,这是目前腔内和频方案所获得的最高功率全固态黄光输出. 关键词: 黄光激光 腔内和频 Nd:YAG激光 全固态激光器  相似文献   
7.
By using a diode-side-pumped Q-switched Nd:YAG rod laser based on a thermally-near-unstable fiat-fiat resonator, an intracavity-frequency-doubled green beam generation is investigated. Output power 140 W is obtained at a repetition rate of 10kHz and a pulse width of 110ns. The green beam quality factors Mx^2 and My^2, which are measured by a laser beam analyser, are 10.65 and 10.85, respectively, at output power of 124W.  相似文献   
8.
薄勇  王德武  应纯同 《物理学报》2004,53(6):1887-1894
将关于液面凹陷的Young-Laplace方程与关于金属溶池的流体力学方程组及关于金属蒸发的BGK方程联立求解,在给定的电子枪加热条件下,获得了熔池流场和温度场图像及金属蒸气密度、速度和温度分布.数值计算结果表明,随电子枪功率增加,金属的蒸发速率增加,蒸气的密度增大、温度降低而速度升高.与假设液面为平面的情况相比,考虑液面凹陷后求得的液面温度较低,金属的蒸发速率较小,并且这种差别随电子枪功率的增加而扩大.因此对于高功率电子枪加热金属蒸发,必须考虑液面凹陷的影响才能得到符合实际的结果. 关键词: 液面凹陷 Young-Laplace方程 熔池 金属蒸发  相似文献   
9.
薄勇  王德武  应纯同 《物理学报》2002,51(7):1535-1541
利用NavierStokes方程在一定的边界条件下求解了电子枪加热长槽形冷、热坩埚中的二维熔池流场,获得了熔池流场的速度和温度分布,并且详细地对比研究了冷、热坩埚中金属熔池的蒸发量与电子枪功率、束宽以及坩埚尺寸的关系.电子枪功率越高、束宽越小(除非小于05mm)、坩埚尺寸越大,则蒸发量越大,电子枪能量的有效利用率也越高.当电子枪束宽较大时,热坩埚的蒸发量较大,而当束宽较小时,冷坩埚的蒸发量较大.计算中对铁、铜、钆和铝等金属熔池进行了数值分析,获得了相似的结果. 关键词: NavierStokes方程 热毛细流 浮力流 金属熔池  相似文献   
10.
光学元件中的杂质和缺陷会引起其激光损伤阈值的大幅降低,现阶段这一问题已成为激光装置向高功率、高能量方向发展的“瓶颈”,亟待解决。在对光学元件激光损伤的研究中发现,用低于光学元件损伤阈值的激光对元件表面进行预处理,可以有效提高光学元件的抗激光损伤能力。对激光预处理技术的提出背景、定性作用机理、定量理论模型及国内外技术应用现状进行了概述。并且介绍了一种可在薄膜制备过程中进行原位实时激光预处理的新型薄膜制备技术。最后指出,激光预处理技术作为一种无污染,可有效改善光学薄膜、光学玻璃、光学晶体元件损伤阈值的最有效方法之一,其作用机理、实用化、仪器化还有待进一步发展。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号