Ion pair generation rates near planar3H and63Ni electron capture detector foils

The ion-pair generation rate (ionization topography) in plasmas from⁶³Ni and particularly Ti³H₄ foils, as used in electron capture detectors, was measured at room temperature using large, parallel plates of low backscattering ability in nitrogen gas of varying density. For one atmosphere pressure, the fall-off of ion pair formation as calculated from the exponential region equalsN ₀·e ^–0.19d for⁶³Ni andN ₀·e ^–1.4d for³H (whereN ₀ is the initial ionization rate immediately adjacent to the foil andd is the distance from the foil in mm). The experimentally measured half ranges (distances from the foil within which 50% of all possible ion pairs are created) are 2.7 mm for⁶³Ni and 0.27 mm for³H. The half ranges calculated from the exponential region where there is less interference from electron backscattering, are 3.7 and 0.5 mm, respectively. The latter values are considered closer to the true, unimpeded ionization topography near planar⁶³Ni and³H foils.Material taken from doctoral thesis     

固体超强酸催化剂SO_4~(2-)/TiO_2-WO_3的制备及其催化性能研究

制备了固体超强酸催化剂SO2 -4/TiO2 WO3 ,并以丁酸丁酯的合成作为探针反应 ,系统考察了WO3 的含量、硫酸浸渍浓度、焙烧温度等制备条件对SO2 -4/TiO2 WO3 催化活性的影响 .实验表明 :制备催化剂的适宜条件为m(H2 WO4) =12 5 % ,硫酸浸渍浓度为 1 0mol·L-1,焙烧温度为 5 80℃ ,活化时间 3h .利用优化条件下制备的催化剂SO2 -4/TiO2 WO3 催化合成缩醛 (酮 ) ,在醛 /酮与二元醇 (乙二醇 ,1,2 丙二醇 )的投料摩尔比为 1∶1 5 ,催化剂的用量占反应物总投料质量的 0 5 % ,反应时间为 1h条件下 ,2 甲基 2 乙氧羰甲基 1,3 二氧环戊烷的收率为 78 7% ,2 ,4 二甲基 2 乙氧羰甲基 1,3 二氧环戊烷的收率为 83 0 % ,环己酮 -乙二醇缩酮的收率为 85 9% ,环己酮 1,2 丙二醇缩酮的收率为 84 6% ,丁酮 -乙二醇缩酮的收率为70 7% ,丁酮 1,2 丙二醇缩酮的收率为 88 3 % ,2 丙基 1,3 二氧环戊烷的收率为 80 6% ,4 甲基 2 丙基 1,3 二氧环戊烷的收率为 79 6% ,2 异丙基 1,3 二氧环戊烷的收率为 64 2 % ,4 甲基 2 异丙基 1,3 二氧环戊烷的收率为 83 3 % ,2 苯基 1,3 二氧环戊烷的收率为 75 3 % ,4 甲基 2 苯基 1,3 二氧环戊烷的收率为 95 1% .     

Morphology Control over the Organic Nanoparticles of 1,3-Diphenyl-5-（9-anthryl）-2-pyrazoline

The organic nanoparticles of a blue-light-emitting molecule, 1,3-diphenyl-5-(9-anthryl)-2-pyrazuline, were prepared by reprecipitation method using acetonitrile as the solvent for the molecular precursor. Three morphologies, spherical, doughnut-shaped and cubic, could be observed on the silicon substrate forthe nanoparfides by the volume-controlled addition of acetonitrile. The evolution of particle morphology as a function of acetonitrile addition was attributed to the variation of the growth habits of the particles in the different environment. The nanoparticles exhibit the novel photoluminescence spectra as compared to those of monomer and the bulk crystals.     

Synthesis of Substituted Hydroxyspiro([1]benzopyran-2,4'(1'H)-pyrimidine)-2'(3'H)thiones and Hydroxyspiro-([1]benzopyran-2,4'(1'H)-pyrimidin)-2'(3'H)ones

We have developed a novel regioselective method for synthesis of substituted spiro([1]benzopyran-2,4'-(1'H)pyrimidine)-2'-(3'H)thiones and spiro([1]benzopyran-2,4'-(1'H)pyrimidin)-2'-(3'H)ones having one or two hydroxyl groups on the benzene ring.     

Y2O3:Eu纳米晶的硝基取代苯甲酸配合物固相热解制备和性能

以苯甲酸、邻硝基苯甲酸、间硝基苯甲酸、对硝基苯甲酸、3,5 二硝基苯甲酸等为配体制备了Y3+、Eu3+二元配合物,配合物中Y3+与Eu3+的摩尔比为9：1.利用这些配合物的爆炸式热分解特性通过固相热解反应制备了一系列Y2O3:Eu纳米晶.透射电镜观察,可以看出所得纳米晶呈球形,粒度介于40～60 nm,X射线衍射分析表明实验所得纳米晶属立方晶系,粒径与电镜观察所得结果基本一致；Eu3+的引入并不影响Y2O3的晶相组成；配体类型对纳米晶的结构没有显著影响,不过相对于硝基取代苯甲酸配合物,苯甲酸配合物热解所得Y2O3∶Eu纳米晶团聚严重；退火温度显著影响纳米晶粒度,退火温度高,纳米晶粒度大,反之亦然.荧光光谱测定表明所有Y2O3∶Eu纳米晶具有相似的发光行为,其中以苯甲酸配合物分解所得Y2O3:Eu纳米晶发光性能最为优越.     

Fabrication of solid thin film electrolyte and LiCoO2 by aerosol flame pyrolysis deposition

Aerosol flame pyrolysis deposition method was applied to deposit the oxide glass electrolyte film and LiCoO₂ cathode for thin film type Li-ion secondary battery. The thicknesses of as-deposited porous LiCoO₂ and Li₂O–B₂O₃–P₂O₅ electrolyte film were about 6 μm and 15 μm, respectively. The deposited LiCoO₂ was sintered for 2 min at 700 °C to make partially densified cathode layer, and the deposited Li₂O–P₂O₅–B₂O₃ glass film completely densified by the sintering at 700 °C for 1 h. After solid state sintering process the thicknesses were reduced to approximately 4 μm and 6 μm, respectively. The cathode and electrolyte layers were deposited by continuous deposition process and integrated into a layer by co-sintering. It was demonstrated that Aerosol flame deposition is one of the good candidates for the fabrication of thin film battery.     

固溶体结构对Ca2-xSrxZn4Ti15O36∶Pr3+发光性质的影响

Ca_2-xSr_xZn₄Ti₁₅O₃₆∶Pr red long decay phosphor was synthesized by high temperature solid state reaction. Photoluminescence property and crystalline and unit cell parameters of the orthorhombic were investigated by fluorescence spectrophotometer and by powder X-ray diffraction, respectively. The emission intensity at 618 nm changes sharply when the concentration of Sr²⁺ (x) is less than 0.1 and the emission intensity reaches the maximum when x is equal to 0.007. There is an obviously broad excitation band at 270 nm when x is equal to 0.003 and it disappears gradually when x is over 0.01. The unit cell a parameter of Ca_2-xSr_xZn₄Ti₁₅O₃₆∶Pr decreases while c parameter increases with the increases of the concentration of the doped Sr²⁺. When x is over 0.1 the value of the unit cell parameters a and c become stable. TL peaks of Ca₂Zn₄Ti₁₅O₃₆∶Pr, Ca_1.993Sr_0.007Zn₄Ti₁₅O₃₆∶0.002Pr³⁺, 0.002Na⁺, are located at 62 ℃, 88 ℃, respectively, which indicates that there are deeper traps in Ca_1.993Sr_0.007Zn₄Ti₁₅O₃₆∶0.002Pr³⁺, 0.002Na⁺.     

Pt3Co核-Pt壳型纳米粒子的制备及磁性

Pt₃Co alloy nanoparticles were prepared by the reduction of H₂PtCl₆ and Co(OOCCH₃)₂ using NaBH₄ as a reducing agent. The Pt₃Co core-Pt shell nanoparticles (Pt₃Co@Pt) were synthesized using hydrogen absorption reduction and characterized by plasma-atomic emission spectrometry (ICP), transmission electron microscopy (TEM), X-ray diffraction (XRD) and SQUID magnetometer. The results show that average size of Pt₃Co@Pt nanoparticles is 3.6 nm with a standard deviation of 0.9 nm. Heating Pt₃Co nanoparticles in air at 700 ℃ for 1 h, Co in Pt₃Co nanoparticles was oxidized to Co₃O₄ and CoO; while no oxidation tendency was detected for Pt₃Co@Pt nanoparticles. The crystallize structure of Pt₃Co@Pt changed from the face centered cube (fcc) to the face centered tetragonal (fct) after the heating treatment. The coercivity of the heated Pt₃Co@Pt reached to 276 Oe at room temperature.     

KF-蒙脱土催化下2-氨基-3-氰基-4-芳基-7,7-二甲基-5-氧代-4H-5,6,7,8-四氢苯并[b]吡喃的合成

以KF-蒙脱土为催化剂, 取代肉桂腈与5,5-二甲基-1,3-环己二酮在95%乙醇中回流反应得2-氨基-3-氰基-4-芳基-7,7-二甲基-5-氧代-4H-5,6,7,8-四氢苯并[b]吡喃, 此方法快速、方便、高效, 同时考察了溶剂、催化剂对反应的影响.     

Titanyl Acetylacetonate as an Efficient Catalyst for Regioselective 1,2‐Reduction of α,β‐Unsaturated Carbonyl Compounds and Conversion of α‐Diketones & Acyloins to Vicinal Diols with Sodium Borohydride

α,β‐Unsaturated aldehydes and ketones were reduced readily and exclusively to their corresponding allylic alcohols with NaBH₄ and catalytic amounts of titanyl acetylacetonate at room temperature. Reduction reactions were carried out in CH₃CN or THF. This reducing system was also efficient for the reduction of α‐diketones and acyloins to their corresponding vicinal diols in CH₃CN.