排序方式: 共有47条查询结果,搜索用时 15 毫秒
1.
采用高温固相法合成了一系列Ca_(2-x-y)Sr_(y-x)SiO_4∶x Ce~(3+),x Li~+蓝色固溶体荧光粉。XRD结果表明,所合成的固溶体荧光粉均为单一物相。随着Sr~(2+)成分的增加,Ca_(2-y)Sr_y SiO_4物相从单斜晶系β-Ca_2SiO_4向正交晶系α′-Ca_2SiO_4转变,发射光谱逐渐红移。组成为Ca_(1.75)Sr_(0.25)SiO_4时,荧光粉的发射波长最长(454 nm),Stokes位移最大。基质为Ca_(1.1)Sr_(0.9)SiO_4的晶体结构可诱导掺杂离子Ce~(3+)取代SrO_(10)格位、Li~+取代CaO8格位。优化的荧光粉Ca_(1.05)Sr_(0.85)SiO_4∶0.05Ce~(3+),0.05Li~+(CS_(0.85)SO∶CeLi)在375 nm紫外光激发下,发射445 nm的蓝光,内量子效率(IQE)达到91.18%,200℃时发射强度保持室温发光强度的98.70%。根据晶体结构、晶体场分裂和掺杂离子质心位移等理论,讨论了CS_(0.85)SO∶CeLi综合发光效应最佳的内在原因。 相似文献
2.
The kinetic model of induced codeposition of nickel-molybdenum alloys from ammoniun citrate solution was studied on rotating disk electrodes to predict the behavior of the electrode-position. The molybdate (MoO42-) could be firstly electro-chemically reduced to MoO2, and subsequently undergoes a chemical reduction with atomic hydrogen previously adsorbed on the inducing metal nickel to form molybdenum in alloys. The kinetic equations were derived, and the kinetic parameters were obtained from a comparison of experimental results and the kinetic equations. The electrochemical rate constants for discharge of nickel, molybdenum and water could been expressed as k1(E) = 1. 23 × 109 CNi exp( - 0.198FE/RT) mol/(dm2·s), k2(E) =3.28× 10-10 CMoexp( - 0. 208FE/ RT) mol/(dm2·s) and k3(E) = 1.27 × 10-6exp( - 0.062FE/ RT) mol/(dm2 · s), where CNi and CMo are the concentrations of the nickel ion and molybdate, respectively, and E is the applied potential vs. saturated calomel electrode (SCE). The codeposition p 相似文献
3.
0引言在绿色和蓝色长余辉发光材料达到应用程度之后,耐候性红色长余辉发光材料成为人们研究的重点。Eu3 、Sm3 激活的硫氧化物[1 ̄3]、Eu2 铝锶复合硫氧化物[4]和Y2O3∶Eu3 [5]等耐热耐水性红色长余辉材料被相继发现。Pr3 离子掺杂的碱土金属钛酸盐(M TiO3∶Pr,M=M g,Ca,Sr,Ba)是一种新型的红色长余辉发光材料。这种发光材料在615nm附近有很好的单色性红光发射。碱土金属钛酸盐基质化学性能稳定,已开始应用于场发射显示器(FE D)[6,7]。碱土金属钛酸盐是A BO3型化合物,具有钙钛矿结构。B all[8]曾通过在CaTiO3中掺入不同量的Sr2 … 相似文献
4.
5.
6.
Eu2 激活的CaS: Eu[1],Eu3 激活的硫氧化物[2],Pr3 激活的Ca0.8Zn0.2TiO3[3]以及Eu2 和Mn2 掺杂的SrY2S4[4]都是重要的红色发光材料. 相似文献
7.
以NH4Cl作助溶剂,碳还原硫酸钙的方法合成了CaS:Ce。在紫外光激发下,CaS:Ce中存在着Ce^3+的^2D-^2F5/2(500nm)和^2D-^2F7/2(550nm)跃迁发射,但在蓝色光激发下,只有波峰为532nm半宽度为92nm的宽带发射。当Ce^3+的浓度为0.075mol%时,^2D-^2F5/2跃迁发射强度与^2D-^2F7/2跃迁发射强度相等,而532nm发射猝灭。 相似文献
8.
用两种方法合成长余辉发光玻璃的对比研究 总被引:5,自引:0,他引:5
在还原性气氛下高温固相反应法(一步法)合成了长余辉发光玻璃GA;用SrAl2O4:Eu,Dy荧光粉(SAED)与玻璃粉混合高温熔融(二步法)合成了长余辉发光玻璃GB和GC,通过XRD,发光光谱和磷光衰减曲线对样品进行了表征,荧光粉SAED和玻璃GA,GB,GC的发射峰值依次是525,493。462,516nm,发光强度和余辉时间都是SAED>GC>GB>GA,玻璃的发射光谱峰随玻璃组成不同发生位移,两种发生合成的夜光玻璃发光性质存在明显的差异,同一合成方法下,玻璃基料决定着玻璃网络结构,同时也影响着夜光玻璃的发光性质。 相似文献
9.
Ca2-xSrxZn4Ti15O36∶Pr red long decay phosphor was synthesized by high temperature solid state reaction. Photoluminescence property and crystalline and unit cell parameters of the orthorhombic were investigated by fluorescence spectrophotometer and by powder X-ray diffraction, respectively. The emission intensity at 618 nm changes sharply when the concentration of
Sr2+ (x) is less than 0.1 and the emission intensity reaches the maximum when x is equal to 0.007. There is an obviously broad excitation band at 270 nm when x is equal to 0.003 and it disappears gradually when x is over 0.01. The unit cell a parameter of
Ca2-xSrxZn4Ti15O36∶Pr decreases while c parameter increases with the increases of the concentration of the doped
Sr2+. When x is over 0.1 the value of the unit cell parameters a and c become stable. TL peaks of
Ca2Zn4Ti15O36∶Pr, Ca1.993Sr0.007Zn4Ti15O36∶0.002Pr3+,
0.002Na+, are located at 62 ℃, 88 ℃, respectively, which indicates that there are deeper traps in
Ca1.993Sr0.007Zn4Ti15O36∶0.002Pr3+,
0.002Na+. 相似文献
10.
采用高温固相法合成了Ba(Y1-0.5x-yAly)2S4:xHo3+系列荧光粉。在465 nm蓝光激发下,荧光粉的发射光谱呈多谱带发射,主峰位于492、543和661 nm处,分别对应于Ho3+的5F3→5I8,(5S2,5F4)→5I8和5F5→5I8跃迁发射。研究了Ho3+和Al3+掺杂量对BaY2S4:Ho3+发光性能的影响。结果表明,随着Ho3+掺杂量的逐渐增大,荧光粉的发光颜色由绿色逐渐向红色转变;适量Al3+取代Y3+可以提高BaY2S4:Ho3+荧光粉的发光强度。荧光粉Ba(Y0.665Al0.3)2S4:0.07Ho3+在蓝光(465 nm)激发下发射黄光,是一种潜在的白光LED用黄色荧光粉。 相似文献