Determination of Mg, Ti and Cl in Ziegler-Natta catalysts by WDXRF

A method for determination of Mg, Ti and Cl in Ziegler-Natta (ZN) catalysts by wavelength dispersive X-ray fluorescence (WDXRF) spectrometry was developed. For comparative reasons, Ti was determined by spectrophotometry, Mg by complexometry and Cl by argentometric titration. Direct pressing was shown to be unsuitable for sample preparation due to catalyst decomposition. For Ti and Mg measurements, catalyst samples were calcinated at 1000 °C and pressed at 275 MPa. Their determination by the fundamental parameters based on the Ti Ka line measurement was shown to be equivalent to those results obtained by univariate calibration or by the classical methods. Cl was determined by aqueous extraction, followed by deposition on a support. Chloride loss was observed. Fixation of Cl as AgCl on polytetrafluoroethylene (FHLC) millipore membrane afforded the best results. Nevertheless, measurements by WDXRF were shown to be inferior to those obtained by argentometric titration.     

Novel Synthetic Approach to Thiophosphinates Incorporating Different N-Heterocycles

Eight new cycloiminylidenamidothiophosphinates incorporating pyridine, pyrimidine, thiazole, and benzothiazole heterocycles were synthesized by phosphorylation of the quaternary iminium salts of the heterocycles by diphenylchlorophosphine followed by in situ sulfurization by elemental sulfur. Crystalline solid products were well characterized by elemental analysis and NMR spectroscopy.     

铂修饰光阴极及其在纳晶太阳能电池中的应用

分别用真空镀膜法、热分解法和电化学法制备了铂金修饰导电玻璃,并以此作为光阴极组装了染料敏化纳晶TiO₂太阳能电池.用SEM观察了铂金修饰导电玻璃表面形貌,发现用真空镀膜法制备的铂金膜结构缺陷多、不均匀,存在较多的污点.用热分解法制备的铂金膜具有多孔状结构,但存在较多的有机物分解的残留物.用电镀法制备的铂金膜结构均匀、排列规则、缺陷少、污染少.测定了所制备铂金膜的电阻,结果表明由电镀法所制得的铂金膜电阻最小,用热解法和真空镀膜法制得的铂金膜电阻较大.测定了DSSC电池的光电性能,发现用电镀法制得的铂金膜的催化性能最好,大大提高了DSSC电池的性能;其次是热分解法,由真空镀膜法制备的铂金膜对电池的性能没有多大改善.     

湿化学法制备硅纳米线阵列及其光电化学产氢性能分析

为了探究不同方法条件下制备的硅纳米线阵列电极产氢性能异同,文中分别采用了两步金属辅助催化无电刻蚀法、一步金属辅助催化无电刻蚀法以及阳极氧化法来制备硅纳米线阵列用作为光电分解水电池光阴极材料。通过FESEM、XRD和UVVis-IR DRS等手段对实验样品的形貌、晶型、减反性表征,发现相比于其他2种方法所得硅纳米线样品,两步金属辅助催化无电刻蚀法制备的硅纳米线结构晶型保持更好,表面缺陷更少。光电化学测试表明两步金属辅助催化无电刻蚀法制备的硅纳米线光电化学性能表现最优,其光电流密度值是一步法的4倍,阳极氧化法的40倍;转移电荷电阻仅是一步法制备的硅纳米线阵列阻值的1/3,阳极氧化法制备的1/1 000。     

方波伏安法评估聚苯胺膜修饰电极的电荷传输速度

研究导电聚合物的电荷传输机制与速度对于其在应用方面的研究极为重要［‘］．例如在电池的研究中，充放电的速度决定于导电聚合物的电荷传输速度；在电致变色器件的研究中，响应时间也是决定于导电聚合物在氧化还原态间的变化速度，即电荷传输速度．显然较低的电荷传输速度不利于器件的实用化，因此人们必须找到一种能够迅速准确评价电荷传输速度的方法，由于导电聚合物是一个特殊的体系，用一般的电化学方法对其电荷传输速度进行测定时常常遇到这样或那样的问题［‘j．一般说来，导电聚合物的氧化还原过程中均伴随着抗衡离子的运动．体系…     

正交设计-偏最小二乘光度法同时测定磷和硅

采用正交设计法研究了磷、硅在酸性钼酸铵和混合还原剂中的最佳显色条件，建立了多波长紫外可见光度法同时测定磷、硅的方法。试验中采集多个波长下的吸光度构成校正矩阵，用偏最小二乘法对该矩阵进行解析，得出了校正模型。该模型与通过主成分回归法得到的模型相比，预测结果更准确。     

河豚鱼、鳗鱼和烤鳗中角黄素残留的超高效液相色谱法测定和超高效液相色谱-串联质谱法确证

建立了河豚鱼、鳗鱼和烤鳗中角黄素残留的超高效液相色谱测定方法和超高效液相色谱-串联质谱确证方法。样品用抗氧化剂焦性没食子酸保护,乙腈均质提取,正己烷液-液分配净化,超高效液相色谱-紫外检测器测定,外标法定量,超高效液相色谱-串联质谱法确证。测定方法采用BEHC18色谱柱(50 mm×2.1 mm,i.d.1.7μm),流动相为V(0.1%的甲酸)∶V(乙腈)=3∶97,检测波长470 nm。实验结果表明,角黄素在0.05~2.0 mg/L范围内线性关系良好(r=0.9999),在空白样品中,添加低、中、高3个浓度水平(0.05,0.1,1.0 mg/kg),角黄素的回收率均在82.52%~96.96%之间,相对标准偏差为6.9%~15%。方法的检出限(LOD)为0.02 mg/kg,定量限(LOQ)为0.05 mg/kg。串联质谱确证方法采用电喷雾(ESI)离子源,在正离子模式下以多反应监测(MRM)扫描方式检测,定性离子对565.5/203.2和565.5/133.1,定量离子对565.5/203.2。     

中波紫外线与化学致癌物诱导下HaCaT细胞的蛋白表达应答

对角质形成细胞HaCaT分别进行中波紫外线(UVB)照射、2,4-二硝基苯磺酸(DNBS)刺激及UVB+DNBS(UD)共同刺激, 利用二维荧光差异胶内凝胶电泳(2D DIGE)、DeCyder定量分析软件和HPLC-nESI-MS/MS分析技术, 对HaCaT细胞产生的差异表达蛋白进行了鉴定. 有65个蛋白质点发生了明显表达差异(P<0.05), 与UVB或DNBS单独处理细胞相比, 有41个蛋白点表现为UVB和DNBS的正协同效应, 13个蛋白点表现为负协同效应, 5个蛋白点与UVB单独处理相近, 6个蛋白点与DNBS单独处理相近. HPLC-nESI-MS/MS从65个差异表达蛋白质点中共鉴定出60种单一(Unique)蛋白. 采用生物信息学方法对这些鉴定蛋白所涉及的分子功能、参与的生物学过程及信号通路进行了系统分析. 实验得到了与紫外辐射和化学诱导损伤的直接相关蛋白, 有助于研究不同环境条件下皮肤癌的形成及皮肤疾病的有效防护与治疗.     

New designer drug 2,5-dimethoxy-4-ethylthio-beta-phenethylamine (2C-T-2): studies on its metabolism and toxicological detection in rat urine using gas chromatography/mass spectrometry

Studies are described on the metabolism and the toxicological analysis of the phenethylamine-derived designer drug 2,5-dimethoxy-4-ethylthio-beta-phenethylamine (2C-T-2) in rat urine using gas chromatography/mass spectrometry (GC/MS) after enzymatic cleavage of conjugates, liquid-liquid extraction and derivatization. The structures of 14 metabolites were assigned tentatively by detailed interpretation of their mass spectra. Identification of these metabolites indicated that 2C-T-2 was metabolized by sulfoxidation followed by N-acetylation and either hydroxylation of the S-ethyl side chain or demethylation of one methoxy group, O-demethylation of the parent compound followed by N-acetylation and sulfoxidation, deamination followed by reduction to the corresponding alcohol followed by partial glucuronidation and/or sulfation or by oxidation to the corresponding acid followed either by partial glucuronidation or by degradation to the corresponding benzoic acid derivative followed by partial glucuronidation. Furthermore, 2C-T-2 was metabolized by N-acetylation of the parent compound followed either by O-demethylation and sulfoxidation or by S-dealkylation, S-methylation and sulfoxidation. The authors' systematic toxicological analysis (STA) procedure using full-scan GC/MS after acid hydrolysis, liquid-liquid extraction microwave-assisted acetylation allowed the detection of an intake of a dose of 2C-T-2 in rat urine, which corresponds to a common drug users' dose. Assuming similar metabolism, the described STA procedure should be suitable for proof of an intake of 2C-T-2 in human urine.