固定化脂肪酶催化合成生物柴油

固定化脂肪酶催化合成生物柴油;转酯反应;固定化脂肪酶;菜籽油;甲醇;生物柴油     

交联烯丙基葡聚精凝胶固定化脂肪酸的研究

本文研究了烯丙基葡聚糖和N、N＇－亚甲基双丙烯酰胺经反相悬浮聚合包埋固定化脂肪酶的方法。考察了悬浮介质、交联度对固定化酶的影响，得出了包埋固定化脂肪酶的最佳条件；并测定了固定化脂肪酶的催化性能，确定了该固定化酶催化橄榄油水解的最适条件。     

猪胰脂肪酶的固定化及其在有机相中催化丁酸甲酯和正丁…

考察了大孔苯乙烯－二乙烯苯交联共聚物的交联度、致孔剂理及胺化试剂对载体固定化猪胰脂肪酶的影响。选择出一种最佳载体对猪胰脂肪酶进行固定化，对比了自由酶和固定化酶在有机相中催化丁酸甲酯和正丁醇的酯交换反应。结果表明，酶经固定化后催化反应活力比自由酶提高近１倍。     

脂肪酶仿生固定化及性质

将仿生钛化过程用于脂肪酶固定化,研究了该过程中工艺条件对脂肪酶固定化的影响及固定化脂肪酶的性质.结果表明：0.5 mL浓度8 mg/mL精蛋白诱导剂、0.5 mL浓度6 mg/mL脂肪酶与1 mL,0.25 mol/L钛前驱体（Ti-BALDH）在pH 7.5,0.05 mol/L磷酸盐缓冲液为反应介质的条件下,脂肪酶...     

聚甲基丙烯酸羟乙酯载体固定化酵母脂肪酶在有机溶剂中催化…

用悬浮聚合法合成了一系列聚甲基丙烯酸羟乙酯载体，考察了它们固定化酵母脂肪酶活力与载体的交联度和致孔剂用量之间的关系。研究了这些固定化酵母脂肪酶在有机溶剂中催化酯合成反应的活性，脂肪酶的固定化使之活力表达更为充分，对亲水性较强的有机溶剂有更强的耐受性，并能为其在有机溶剂中催化酯合成反应提供必需水。考察了ＰＨ值，底物种类对固定化酵母脂肪酶催化酯合成反应的影响。     

微乳液凝胶固定化脂肪酶催化α-单硬脂酸甘油酯水解反应活性

微乳液凝胶固定化脂肪酶催化α-单硬脂酸甘油酯水解反应活性;微乳液凝胶;固定化脂肪酶;催化活性;水解反应;α-单硬脂酸甘油酯     

碳酸钙固定化猪胰脂肪酶的制备及活性研究

本文利用市售普通碳酸钙(general calcium carbonate,GCC)作为猪胰脂肪酶(PPL)固定化的载体材料,研究了不同固定化条件对所制备的固定化酶活性的影响.结果显示PPL固定化于GCC上的最佳制备工艺为:将20 mL酶液与1.50 g GCC放入置于摇床内的三角瓶中,摇床温度设为40℃,摇床转速设为...     

固定化脂肪酶活性的X射线微区分析

利用X射线微区分析的方法，对吸附交联法得到的固定化脂肪酶的微观活性进行了分析。结果表明：以合成出的大孔吸附树脂为固定化酶栽体，酶活较高，活性脂肪酶分布较均匀。并得到了固定化脂肪酶的活性定位的最佳条件。     

有机相中蚕丝固定化脂肪酶催化酯化反应性能研究

研究了有机相中蚕丝固定化脂肪酶催化酶化反应的催化活性。考究了有机溶剂,底物、反应温度,ＰＨ值和体系含水量等因素对固定化脂肪酶催化活性的影响。结果表明,以异辛烷为有机溶剂,在反应温度为５０℃ＰＨ值为７．４时,酶催化活性最好。     

纳米-微米复合孔泡沫陶瓷固定化脂肪酶

考察了泡沫陶瓷的孔径分布和表面性质对脂肪酶固定化的影响.研究表明,泡沫陶瓷的纳米孔孔径分布非常适合脂肪酶的固定化,对固定化酶的催化效率有决定性的影响.经1h的定化,泡沫陶瓷固定化酶的活性达商业化硅藻土固定化酶的1.33倍,体积活力为其2.63倍,蛋白载量为45.36mg/g陶瓷,比活为1215.39U/g,活力回收为41.2%.泡沫陶瓷固定化脂肪酶在有机相乙酸乙酯合成中表现优良,连续使用5次,每次反应3h,乙酸转化率均在93%左右.     

二氧化碳和丙烯直接合成甲基丙烯酸的NiPMo/TiO2催化剂的研究

用溶胶-凝胶法以磷钼酸(MPA)的镍盐溶液水解钛酸四丁酯制备了NiPMo/TiO2催化剂.使用ICP、 XRD、 TG-DTA、 IR、 TPD-MS和微反应技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化反应性能.杂多钼酸盐与TiO2通过O2-在TiO2表面发生了键合.在623 K下,杂多阴离子仍保持原有的Keggin结构.CO2在Lewis酸位Ni(Ⅱ)和Lewis碱位Ni-O-Mo的桥氧协同作用下生成CO2卧式吸附态Ni(Ⅱ)←O-(CO)←(O--Ni).丙烯有多种吸附态在催化剂上吸附.在563 K、 1 MPa和空速1500 h-1的反应条件下,丙烯的摩尔转化率为3.2%,产物MAA选择性为95%.     

Toward new camptothecins. Part 6: Synthesis of crucial ketones and their use in Friedländer reaction

In the context of the preparation of camptothecin and luotonin A analogs, the synthesis of some key keto-precursors and their use in Friedländer condensation are described. This paper also focuses on the stability of these keto intermediates and emphasizes the major differences between indolizinones and pyrroloquinazolinones series. Noteworthy is also the report of some original structures isolated as by-products of some experiments.     

α-Amino acid derived enaminones and their application in the synthesis of N-protected methyl 5-substituted-4-hydroxypyrrole-3-carboxylates and other heterocycles

A new and simple synthesis of novel N-protected methyl 5-substituted-4-hydroxypyrrole-3-carboxylates, which exist in equilibrium with their 4-oxo tautomers, has been developed in two steps starting from N-protected α-amino acids. The key intermediates are enaminones, which can also be isolated, characterized, and used for the construction of other functionalized heterocycles, before they spontaneously decompose to pyrrole products. 4-Hydroxypyrroles are prone to partial aerial oxidation but can be efficiently alkylated or reduced to stable polysubstituted pyrrolidine derivatives.     

Specific intramolecular aromatic CH insertion of diazosulfonamides

The chemoselectivity in the intramolecular CH insertion of various diazosulfonamides has been experimentally studied. The results reveal that the aliphatic 1,4-, 1,5-, or 1,6-C(sp³)?H insertions of diazosulfonamides are not accessible, while the aromatic 1,5-C(sp²)?H insertion can be realized specifically by adjusting the diazo-adjacent group. In addition, the general chemoselectivities in the intramolecular CH insertions of diazosulfonyl compounds are summarized. Generally, diazosulfones undergo both aromatic 1,5-C(sp²)?H and aliphatic 1,5- and 1,6-C(sp³)?H insertions, while diazosulfonates undergo aliphatic 1,5- and 1,6-C(sp³)?H insertions. However, diazosulfonamides only undergo aromatic 1,5-C(sp²)?H insertion.     

CoFe2O4自形成磁性液体场致结构化对磁化的影响

The Langevin paramagnetic theory can’t describe the relation between magnetization of ferrofluids and applied magnetic field. The structuralization of ferrofluids, which is considered the main influence factor of the magnetization, is regarded. The part of magnetization works is deposited when the structure is forming. This action influences the magnetization of ferrofluids directly or indirectly. On the base of the “compressing” model, the Langevin function that usually describes the magnetization of ferrofluid is modified, and a well-fitted curve is obtained. An equation of the relation between the equivalent volume fraction after being “compressed” and the intensity of magnetic field is discovered, which approximately describes the process of magnetization. The relation between the approximate initial susceptibility and the volume fraction can be obtained from modified formula.     

KMnO4-mediated oxidative CN bond cleavage of tertiary amines: Synthesis of amides and sulfonamides

KMnO₄-mediated oxidative CN bond cleavage of tertiary amines producing secondary amine was introduced, which was trapped by electrophiles (acyl chloride and sulfonyl chloride) to form amides and sulfonamides. The reaction could take place at mild condition, tolerating a wide range of function groups and affording products in moderate to excellent yields.     

Highly regioselective Buchwald–Hartwig amination at C-2 of 2,4-dichloropyridine enabling a novel approach to 2,4-bisanilinopyridine (BAPyd) libraries

The highly regioselective Buchwald–Hartwig amination at C-2 of the cheap and readily accessible reagent, 2,4-dichloropyridine with a range of anilines and heterocyclic amines is described. This new methodology is robust and provides a facile access to 4-chloro-N-phenylpyridin-2-amines on 0.25 mol scale. These intermediates undergo a further Buchwald–Hartwig amination at higher temperature to enable rapid exploration of the chemical space at C-4 and to provide a library of 2,4-bisaminopyridines.     

Chemistry of heterocyclic compounds at the A. E. Favorsky Irkutsk Institute of Chemistry, Siberian Branch of the Russian Academy of Sciences, over 50 years (Review)

The review contains a concise historical account and information on the most significant researches undertaken by the staff at the A. E. Favorsky Irkutsk Institute of Chemistry, Siberian Branch of the Russian Academy of Sciences on the Chemistry of Heterocyclic Compounds. Dedicated to Academician of the Russian Academy of Sciences B. A. Trofimov on his 70th jubilee. Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 10, pp. 1443–1502, October, 2008.     

N-Heterocyclic carbene-palladacyclic complexes: synthesis,characterization and their applications in the C-N coupling and α-arylation of ketones using aryl chlorides

N-Heterocyclic carbene-palladacyclic complexes 3 were successfully achieved in a one-pot procedure under mild conditions. The structure of 3a was unambiguously confirmed by X-ray single crystal diffraction and it was an active catalyst in the Buchwald-Hartwig amination and α-arylation of ketones even at very low catalyst loadings (0.01?mol%).     

Iodine-mediated oxidative Pictet-Spengler reaction using terminal alkyne as the 2-oxoaldehyde surrogate for the synthesis of 1-aroyl-β-carbolines and fused-nitrogen heterocycles

An efficient iodine-mediated oxidative Pictet-Spengler reaction in dimethyl sulphoxide (DMSO) using terminal alkynes as the 2-oxoaldehyde surrogate for the synthesis of aryl (9H-pyrido[3,4-b]indol-1-yl)methanones is described. The scope of the protocol includes the total synthesis of Fascaplysin, Eudistomins Y₁ and Y₂. The methodology is extended for preparing pyrrolo[1,2-a]-quinoxaline and indolo[1,5-a]quinoxaline derivatives. The utility of 1-aroyl-β-carbolines was demonstrated by performing palladium-catalyzed β-carboline directed ortho-C(sp2)-H functionalization of the phenyl ring with thiomethyl (SMe) group using DMSO as source and for accessing 4-aryl-canthin-6-ones.