ZrO2纳米粉等离子喷涂层组织与性能

用纳米结构粉末做喂料进行喷涂，缩短了颗粒熔化时间，在有限的飞行时间内，颗粒熔化效果更好，从而制备的涂层孔隙率更小，表面更平整。用ZrO2纳米结构喂料制备了等离子喷涂层，研究了功率、粒度、氧化钇含量等工艺参数条件下涂层的微观组织、孔隙率、相组成及抗热震性能。经X衍射分析表明，原始粉末由m-ZrO2,t-ZrO2,c-ZrO2构成，单斜相的含量为11％，主要由四方相和立方相构成。     

第二讲 行程问题

在小学数学应用题这一大家庭中,行程问题是其中最为重要的一类。它以丰富多彩的内容、变化多端的解法,对广大少年儿童产生着巨大的吸引力,它对提高少年儿童分析问题、解决问题的能力有着十分重要的作用,在各级各类竞赛中,它是每赛必有,并经常被当作拉开考生档次的把关题。     

Improve the performance of interferometer with ultra-cold atoms

Ultra-cold atoms provide ideal platforms for interferometry.The macroscopic matter-wave property of ultra-cold atoms leads to large coherent length and long coherent time,which enable high accuracy and sensitivity to measurement.Here,we review our efforts to improve the performance of the interferometer.We demonstrate a shortcut method for manipulating ultra-cold atoms in an optical lattice.Compared with traditional ones,this shortcut method can reduce the manipulation time by up to three orders of magnitude.We construct a matter-wave Ramsey interferometer for trapped motional quantum states and significantly increase its coherence time by one order of magnitude with an echo technique based on this method.Efforts have also been made to enhance the resolution by multimode scheme.Application of a noise-resilient multi-component interferometer shows that increasing the number of paths could sharpen the peaks in the time-domain interference fringes,which leads to a resolution nearly twice compared with that of a conventional double-path two-mode interferometer.With the shortcut method mentioned above,improvement of the momentum resolution could also be fulfilled,which leads to atomic momentum patterns less than 0.6hkL. To identify and remove systematic noises,we introduce the methods based on the principal component analysis (PCA) that reduce the noise in detection close to the 1/√2 of the photon-shot noise and separate and identify or even eliminate noises.Furthermore,we give a proposal to measure precisely the local gravity acceleration within a few centimeters based on our study of ultracold atoms in precision measurements.     

纤维丛的全测地子流形

本文证明了底空间Ｍ是纤维丛Ｐ的全测地子流形；并且在ｄｉｍＰ－ｄｉｍＭ＝２时证明了若Ｐ是平坦的，则Ｐ的每一纤维也是全测地子流形．     

基础滑移隔震体系的地震响应计算

利用随机振动理论求出了基础滑移隔震房屋在无频谱过程的白噪声过程作用下的响应特性，探讨了基础滑移隔震的振动时最佳阻尼系数取值，提出了基础最大滑移量在白噪声过程作用下的计算公式，并进行了基础滑移隔震位移量的试验测定。计算结果与试验结果表明，本文提出的基础滑移隔震体系的计算公式是可行的，为滑移隔震房屋设计证结构安全、合理提供了理论依据。     

双分布聚乙二醇接枝纳米二氧化硅的高效可控制备

在混合溶剂中通过"grafting to"的方法将2种分子量不同的聚乙二醇单甲醚(MPEG M_w=750,4000)接枝到氨基修饰的St?ber法二氧化硅(SiO_2-NH_2)表面,制备双分布纳米接枝复合物.采用二步法,先将带环氧端基的低分子量聚乙二醇单甲醚(MPEG-EO)与SiO_2-NH_2在甲苯溶剂中充分反应后,与高分子量的MPEG-EO在甲苯和正癸烷的混合溶剂中使用相同的反应条件和后处理方法,能便捷制备出具有双分布接枝的纳米复合物.在接枝反应体系中,分子链的链段尺寸和接枝密度之间存在着密切关系.一定的范围内,接枝密度随链段尺寸减小而增大.通过改变混合溶剂比例来调控接枝链段的尺寸,可以很好控制聚合物的接枝密度.在双分布接枝的纳米复合物中,低分子量的接枝密度为0.85 chains/nm~2,高分子量的接枝密度能达到0.40 chains/nm~2,体现出了简单、高效、可控的特点,与聚环氧乙烷(PEO)共混后分散良好,对于制备出均匀分散的纳米复合材料起到了一定的指导作用.     

具非负Ricci曲率和次大体积增长的流形

设M是具非负Ricci曲率的n维黎曼流形,其截曲率有下界,对M中的任意的点p有vol[B(p,r)]/rn-1=αM+o(1/rn-1)且假设函数f(r)=vol[B(p,r)]/2In(r)rn-1是单调递减的,则M具有限拓扑型,其中In(r)是一有界函数.     

具非负Ricci曲率和强有界几何条件的流形

设M是具非负Ricci曲率的n维完备非紧黎曼流形,若M具次大体积增长vol{B(p,r)1≥βM*, p ∈M, r≥1和满足强有界几何条件,则M具有限拓扑型.     

Theory of Z-scan technique using Gaussian-Bessel beams with a phase object

This paper reports the theoretical study of combining Z-scan technique with Gauss-Bessel (GB) beams beside a phase object (PO) to measure the third-order nonlinear susceptibility components.By using this method,the sign of refractive index which depends on the shape of the close aperture Z-scan curve can be easily determined.Meanwhile,the magnitude of nonlinear coefficients can also be deduced by theoretical fit.The proposed method is advantageous for high sensitivity and imposes a lower stress in the cases of fragile materials,since small pulse energy is enough for the measurement of nonlinear coefficients.Predictions of the models are compared with Gaussian Z-scan measurement and GB Z-scan measurement.By using GB beams with a PO,the sensitivity of Z-scan measurements is found to be a factor of over 60 times greater than for Gaussian beams and 2 times greater than for Gaussian-Bessel beams.     

用于电磁驱动实验装置CQ-7的多间隙气体开关

基于电磁驱动实验装置CQ-7研制需求,设计了一套6间隙气体开关,开关高131 mm,直径108 mm,总间隙36 mm,开关电感约40 nH。采用模拟软件Ansoft Maxwell计算分析开关电场强度分布,电场分布较均匀,不均匀系数为1.14。开展了开关放电特性研究,充电100 kV条件下,开关放电电流峰值可达70 kA,放电延时约35 ns,抖动3 ns。根据开关自击穿电压值,采用正态分析开关自击穿概率,开关80%安全系数下,自放电概率小于10-4。该开关满足CQ-7实验装置研制需求。