超薄屏蔽层300 V SOI LDMOS抗电离辐射总剂量仿真研究

本文研究了300 V绝缘体上硅横向双扩散金属氧化物半导体场效应管在电离辐射总剂量效应下的线性电流退化机理,提出了一种具有超薄屏蔽层的抗辐射结构实现线性电流加固.超薄屏蔽层位于器件场氧化层的下方,旨在阻止P型掺杂层表面发生反型,从而截断表面电流路径,有效抑制线性电流的退化.对于横向双扩散金属氧化物半导体场效应管,漂移区上的场氧化层中引入的空穴对线性电流的退化起着主导作用.本文基于器件工艺仿真软件,研究器件在辐照前后的电学特性,对超薄屏蔽层的长度、注入能量、横向间距进行优化,给出相应的剂量窗口,在电离辐射总剂量为0—500 krad(Si)的条件下,将最大线性电流增量从传统结构的447%缩减至10%以内,且辐照前后击穿电压均维持在300 V以上.     

硅和锗纳米线的原子排布和电荷分布的密度泛函紧束缚方法研究

低维硅锗材料是制备纳米电子器件的重要候选材料，是研发高效率、低能耗和超高速新一代纳米电子器件的基础材料之一，有着潜在的应用价值。采用密度泛函紧束缚方法分别对厚度相同、宽度在0.272 nm~0.554 nm之间的硅纳米线和宽度在0.283 nm~0.567 nm之间的锗纳米线的原子排布和电荷分布进行了计算研究。硅、锗纳米线宽度的改变使原子排布，纳米线的原子间键长和键角发生明显改变。纳米线表层结构的改变对各层内的电荷分布产生重要影响。纳米线中各原子的电荷转移量与该原子在表层内的位置相关。纳米线的尺寸和表层内原子排列结构对体系的稳定性产生重要影响。     

不同退火条件对PEALD制备的Ga2O3薄膜特性的影响

利用等离子增强原子层沉积技术(PEALD)在c面蓝宝石衬底上制备了氧化镓(Ga₂O₃)薄膜,研究了退火气氛(v(N₂)∶v(O₂)=1∶1(体积比)、空气和N₂)及退火时间对Ga₂O₃薄膜晶体结构、表面形貌和光学性质的影响。研究结果表明,退火前的氧化镓处于亚稳态,不同退火气氛下退火后晶体结构发生明显改变,而且退火气氛中N₂比例增加有利于Ga₂O₃重结晶。在N₂气氛下退火达到30 min,薄膜结构已由亚稳态转变成择优取向的β-Ga₂O₃。而且表面形貌分析表明,退火30 min后表面形貌开始趋于稳定,表面晶粒密度不再增加。另外实验样品在 400~800 nm的平均透射率几乎是100%,且光吸收边陡峭。采用N₂气氛退火,对于富氧环境下沉积的Ga₂O₃更利于薄膜表面原子迁移,以及择优取向Ga₂O₃重结晶。     

利用空间位阻和氢溢流协同作用促进5-羟甲基糠醛选择性加氢制备5-甲基糠醛

化学工业生产中，用氢气为还原剂，通过选择性加氢可以制备多种重要化学品。5-羟甲基糠醛是重要的生物质基平台化合物，而5-甲基糠醛是用途广泛的化学品。由5-羟甲基糠醛加氢得到5-甲基糠醛是一条非常理想的路径，但是选择性活化C-OH非常困难。本文设计并制备了Pt@PVP/Nb₂O₅(PVP: 聚乙烯吡咯烷酮)催化剂，该催化体系巧妙地结合了位阻效应、氢溢流和催化剂界面的电子效应，系统研究了该催化剂对5-羟甲基糠醛选择性加氢制备5-甲基糠醛催化性能，在最优条件下，5-甲基糠醛的选择性可达92%。利用密度泛函理论计算研究了5-羟甲基糠醛选择性加氢制备5-甲基糠醛反应路径。     

射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

层间单向耦合星形圆环状网络的同步能力

多层复杂网络同步是网络科学研究的一个前沿方向,目前对多层复杂网络同步性的研究大多集中在无向多层复杂网络上,而更加贴近于实际的多层有向网络研究很少.首先根据主稳定方程(MSF)严格计算出M层层间单向耦合星形圆环状网络的超拉普拉斯矩阵的特征值谱,并得到反映M层层间单向耦合星形圆环状网络同步能力的重要指标,其次讨论了M层层间单向耦合星形圆环状网络在同步域为有界和无界的两种情况下同步能力与层数、节点数、层间耦合强度和层内耦合强度及中心节点耦合强度之间的关系.最后通过数值模拟给出了层间单向耦合星形圆环状网络同步能力的仿真图像,验证了理论结果的有效性.     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.