偏压及测试环境对离子束DLC膜摩擦学行为的影响

采用线性阳极层离子束技术制备了类金刚石薄膜(DLC膜),研究了不同衬底负偏压和测试环境对DLC薄膜摩擦学性能的影响.结果表明:在-50V偏压下,薄膜硬度和弹性模量最大,这主要与薄膜中高的sp³含量相关;衬底负偏压对薄膜在室温大气条件下的摩擦学性能影响不显著,薄膜总体呈现较低的摩擦系数和磨损率,显示出优异的抗磨损性能;线性离子束制备的含氢DLC薄膜的摩擦学行为受湿度及环境气氛影响较大,归因于环境中的氧气和水分造成的摩擦化学反应.     

刚性衬底上铜铟硒纳米棒阵列的合成与表征

在覆盖有钨电极的硅衬底上利用多孔阳极氧化铝模板为生长掩膜电沉积合成垂直排列的铜铟硒纳米棒阵列. 多孔阳极氧化铝模板由阳极氧化磁控溅射制备的铝膜制成. 扫描电子显微镜结果表明,该纳米棒阵列结构致密,直径约100 nm长度约1μm,纵横比为10. X射线衍射、微区拉曼光谱和高分辨透射电子显微镜结果表明,真空条件下450 oC退火处理的铜铟硒纳米棒是多晶纯相的黄铜矿结构的铜铟硒,在纳米棒轴向方向上有比较大的晶粒尺寸. 能量色散X射线光谱表明,铜铟硒纳米棒的化学组成接近InSe₂的化学计量比,由吸收光谱分析推算铜铟硒纳米棒带隙为0.96 eV.     

Two-dimensional photon counting imaging detector based on a Vernier position sensitive anode readout

A two-dimensional photon counting imaging detector based on a Vernier position sensitive anode is reported. The decode principle and design of a two-dimensional Vernier anode are introduced in detail. A photon counting imaging system was built based on a Vernier anode. The image of very weak optical radiation can be reconstructed by image processing in a period of integration time. The resolution is superior to 100 μm according to the resolution test. The detector may realize the imaging of very weak particle flow of high-energy photons, electrons and ions, so it can be used for high-energy physics, deep space exploration, spectral measurement and bio-luminescence detection.     

GISAXS and SAXS studies on the spatial structures of Co nanowire arrays

The spatial structures of magnetic Co nanowire array embedded in anodic aluminium membranes were investigated by grazing incidence small angle X-ray scattering (GISAXS) and conventional small angle X-ray scattering (SAXS) techniques. Compared with SEM observation, the GISAXS and SAXS measurements can get more overall structural information in a large-area scale. In this study, the two-dimensional GISAXS pattern was well reconstructed by using the IsGISAXS program. The results demonstrate that the hexagonal lattice formed by the Co nanowires is distorted (a ≈ 105 nm, b ≈ 95 nm). These Co nanowires are isolated into many structure domains with different orientations with a size of about 2 μm. The SAXS results have also confirmed that the nanopore structures in the AAM can be retained after depositing Co nanowires although the Co nanowires can not completely but only just fill up the nanopores. These results are helpful for understanding the global structure of the Co nanowire array.     

AlN纳米线宏观阵列的制备

借助二次模板法成功的合成了AlN纳米线宏观阵列,并进行了表征.主要研究CVD法制备有一定取向,直径均匀的AlN纳米线宏观阵列的过程.通过气相沉积法和利用PS球自组装模板制备了金属纳米颗粒模板;再以模板上的金属纳米颗粒作为催化剂,利用化学气相沉积在模板上合成AlN纳米线宏观阵列.借助SEM,TEM观察所得样品,AlN纳米线阵列面积约为0.3 mm×0.2 mm,直径和长度分布均匀,平均直径约为41 nm,平均长度为1.8 μm左右,分散密度和覆盖率大的六角结构AlN纳米线宏观阵列.得到了可控制备AlN纳米线 关键词： AlN纳米线阵列 模板法 CVD法 SEM     

碳纤维基PtPb阳极催化剂的制备及其电催化性能

以静电纺丝技术与烧结工艺相结合的方式制备了碳纤维基PtPb纳米催化剂,并采用X射线衍射（XRD）、红外光谱（FT-IR）、扫描电镜（SEM）等分析测试手段对其进行了表征。结果表明,在预氧化温度为300 ℃、碳化温度为800 ℃的条件下,所制备的PtPb阳极纳米催化剂结晶程度好、比表面积大,粒径约为3.05 nm,催化活性颗粒均匀分散在多孔碳纤维骨架上。采用循环伏安法（CV）及交流阻抗（EIS）评价了该催化剂对乙醇氧化反应的电催化性能。结果表明,最大峰电流密度达到125 mA/cm²,电荷转移电阻相较于700 ℃下降了近60%。     

Simultaneous extraction and preconcentration of copper,silver and palladium with modified alumina and their determination by electrothermal atomic absorption spectrometry

In the present work,an easy solid phase extraction method using alumina modified with polyethylenimine as a new adsorbent was applied to the simultaneous extraction of copper,silver,and palladium ions prior to their determination with electrothermal atomic absorption spectrometry.The analytical procedure involved the complex formation of these cations with polyethylenimine as a chelating agent in buffer media of pH 7.0.Under the optimum conditions,a preconcentration factor of200,150,and 200,precision of ±5.4%,±4.7%,and ±5.2%and linear calibration ranges of 15.0-140,4.0-93,and 7.5-125 ng/L(in original solution) for Cu,Ag,and Pd were obtained,respectively.Also detection limits of3.9,1.1,and 2.0 ng/L were obtained for Cu,Ag,and Pd,respectively.The proposed method was applied to the determination of copper,silver,and palladium in some real samples with satisfactory results.     

Sensitive detection of DNA methyltransferase activity based on rolling circle amplification technology

This work develops a fluorescence approach for sensitive detection of DNA methyltransferase activity based on endonuclease and rolling circle amplification （RCA） technique. In the presence of DNA adenine methylation （Dam） MTase, the methylation-responsive sequence of hairpin probe is methylated and cleaved by the methylation-sensitive restriction endonuclease Dpn 1. The products cleaved by restriction endonuclease Dpn I then function as a signal primer to initiate RCA reaction by hybridizing with the circular DNA template. Each RCA product containing thousands of repeated sequences might hybridize with a large number of molecular beacons （detection probes）, resulting in an enhanced fluorescence signal. In the absence of Dam MTase, neither methylation/cleavage nor RCA reaction can be initiated and no fluorescence signal is observed. The proposed method exhibits a dynamic range from 0.5 U/mL to 30 U/mL and a detection limit of 0.18 U/mL. This method can be used for the screening of antimicrobial drugs and has a great potential to be further applied in early clinical diagnosis.     

多壁碳纳米管修饰玻碳电极测定铜离子

以多壁碳纳米管(MWCNTs)修饰玻碳电极为工作电极,采用阳极溶出线性扫描法研究了铜离子的电化学测定方法。探讨了MWCNTs修饰层数、富集电位、富集时间、溶液pH、支持电解质对峰电流的影响。实验表明,铜离子浓度在1.0×10-8~1.0×10-5mol·L-1范围内与峰电流呈良好的线性关系,检测限为2.0×10-9mol·L-1,且该电极具有良好的稳定性和抗干扰能力。     

Electrospun CuFe2O4 nanotubes as anodes for high-performance lithium-ion batteries

Herein,we report on the synthesis and lithium storage properties of electrospun one-dimensional(1D) CuFe_2O_4 nanomaterials.1D CuFe_2O_4nanotubes and nanorods were fabricated by a single spinneret electrospinning method followed by thermal decomposition for removal of polymers from the precursor fibers.The as-prepared CuFe_2O_4 nanotubes with wall thickness of ~50 nm presented diameters of ~150 nm and lengths up to several millimeters.It was found that phase separation between the electrospun composite materials occured during the electrospinning process,while the as-spun precursor nanofibers composed of polyacrylonitrile(PAN),polyvinylpyrrolidone(PVP) and metal salts might possess a core-shell structure(PAN as the core and PVP/metal salts composite as the shell) and then transformed to a hollow structure after calcination.Moreover,as a demonstration of the functional properties of the 1D nanostructure.CuFe_2O_4 nanotubes and nanorods were investigated as anodes for lithium ion batteries(LIBs).It was demonstrated that CuFe_2O_4 nanotubes not only delivered a high reversible capacity of ~816 mAh·g~(-1) at a current density of 200 mA·g~(-1)over 50 cycles,but also showed superior rate capability with respect to counterpart nanorods.Probably,the enhanced electrochemical performance can be attributed to its high specific surface areas as well as the unique hollow structure.