Toward consistent formulation of Reynolds stress and scalar flux closures

Langevin stochastic differential equations provide a consistent basis for Reynolds stress, scalar transport and p.d.f. models. However, the stochastic equations must be capable of representing existing closures, like the General Linear Model, or the Rotta and Monin return to isotropy formulations. A consistent approach to derive both Reynolds stress and scalar flux transport equations, starting from a stochastic differential equation for velocity fluctuations, is presented here. A set of algebraic relations for the dispersion tensor is derived for homogeneous shear flow and for the log-layer.     

高温超导体磁通钉扎和磁通动力学研究简介

超导态是一个宏观量子相干态,其载流子是库珀对.在没有外加磁场和电流的时候,这些库珀对的运动行为用统一的波函数ψ=ψ0eiφ进行描述,其相位φ在宏观尺度上是相同的.当磁场低于一定值的时候,在超导体的边界处穿透深度内会出现一个屏蔽电流来对抗外磁场的侵入,样品处于迈斯纳态.然而,当磁场超过一定值的时候,磁场会进入到超导体中,迈斯纳态被破坏掉,在超导体内形成超导区和正常区及其相应的界面.根据此时这个界面处能量的正负,把超导体分成Ⅰ类和Ⅱ类超导体,分别对应正和负界面能.目前发现的绝大多数超导体都是Ⅱ类超导体,因为界面能为负值,因此进入到超导体的磁场会分离成最细小的单元,以保证最大的界面面积,降低系统能量.该最小的磁通束被称为磁通量子,其磁通量是Φ0=h/2e(h为普朗克常数, e为电子电量).这些磁通线之间有一定的排斥力,因此它们会形成点阵.当外加输运电流的时候,这些磁通线会受到一个洛伦兹力作用而运动,但是运动就会造成能量的损耗,超导体就会因此失去电阻为零的优良品质.通过在超导体中引入一些缺陷、杂质或位错,就可以把磁通钉扎住,超导体仍然可以有零损耗特性,而这个特性可以用于超导体的强电应用.本文将对磁通钉扎和磁通动力学及其研究方法做一点简单介绍.     

冬季平原河网水体溶存甲烷和氧化亚氮浓度特征及排放通量

以长江三角洲上海地区和海河流域天津地区水网为研究对象,对冬季河网表层水体溶存甲烷（CH4）和氧化亚氮（N2O）浓度、饱和度及水-气界面排放通量进行了研究.结果表明,冬季我国平原河网水体溶存CH4和N2O的浓度值都很高,呈高度过饱和状态：CH4浓度均值为0.86mol/L（饱和度：758%）,范围在（0.043±0.001）～（25.3±9.32）μmol/L之间;N2O浓度均值为86.8nmol/L（饱和度：488%）,范围在（9.71±0.41）～（691±35.2）nmol/L之间变化.天津排污河水体CH4和N2O浓度显著高于其他河流（均值分别为38.4mol/L和88.9nmol/L）.水体溶存CH4和N2O浓度、饱和度存在很大的地区差异,上海河网的CH4和N2O浓度和饱和度均值高于天津河网.河网水体水-气界面CH4和N2O排放通量变化范围很广,CH4通量在（1.35±0.22）～（665±246）mol/m2h之间,平均值为24.1mol/m2h,N2O通量在（0.19±0.02）～（22.6±5.05）mol/m2h之间,平均值为2.28mol/m2h.相关分析发现,河网水体溶存CH4浓度与DO显著负相关,与NH4＋显著正相关;N2O浓度则与NH4＋和NO3＋NO2显著正相关.河网水-气界面CH4和N2O排放通量均呈现出市区高郊区和农村低的空间分布规律,污染严重的河流已显然成为大气CH4和N2O的潜在排放源.     

MgF2对Mn4+掺杂锗酸盐红色荧光粉发光的影响

3.5MgO·0.5MgF₂·GeO₂∶Mn⁴⁺作为优异热稳定性和良好发光性能的红色荧光粉而被市场应用,然而,该粉体中MgF₂的作用影响机理尚不明晰,阻碍其性能进一步优化和发展。采用高温固相法制备了系列Mn⁴⁺激活的锗酸盐荧光粉,通过对比加入MgF₂、H₃BO₃(助熔剂),研究了该粉体的结构、形貌、发光性能等变化规律,阐明了MgF₂的发光影响作用。研究表明,加入MgF₂、H₃BO₃和不加任何助熔剂时的样品,其最佳烧结温度分别为1 150、1 250和1 350 ℃,上述温度下发光强度均为最佳值,其中加入MgF₂、H₃BO₃的样品在最佳温度处生成了纯相。MgF₂的添加,一方面同H₃BO₃一样作为助熔剂对生成纯相、提高样品结晶度起了积极的作用;另一方面,通过研究分析,确认F^-离子成功掺杂进入晶格,促使样品生成的晶体结构为Mg₁₄Ge₅(O,F)₂₄。加入MgF₂、H₃BO₃在最佳烧结温度的样品的荧光寿命分别为0.93和0.75 ms。     

Solvent flux behavior and rejection characteristics of hydrophilic and hydrophobic mesoporous and microporous TiO2 and ZrO2 membranes

This paper describes solvent flux and rejection behavior of different hydrophilic TiO₂ membranes and a hydrophobic ZrO₂ membrane. Solvents and solutes used range from polar to non-polar. Additionally, the temperature effect on permeability and rejection of solutes through these membranes was examined.     

Optical characterization of polycarbonate: Influence of additives on optical properties

In laser transmission welding of thermoplastics the optical properties of the joining parts determine the quality of the welding result. Especially, the scattering of laser radiation in the transparent welding part has an impact on weld seam properties. This scattering is caused by additives. For polycarbonate (PC) with different additives the transmittance, the reflectance and the collimated transmittance are measured with a UV‐VIS‐NIR spectrometer. From this data, the optical properties, such as scattering coefficient, absorption coefficient, and anisotropy factor are calculated. The calculations are made with the aid of the four‐flux model of radiation transport in the diffusive approximation. The results show that the additives have a significant influence on the scattering coefficient. For most additives under consideration the scattering is forward directed, which means that most of the radiation is transmitted into the absorbing welding part. However, the power density distribution of the transmitted radiation may differ significantly from PC without additives. So, the weld seam may also differ due to different additives. © 2010 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 48: 451–455, 2010     

A well‐balanced upstream flux‐splitting finite‐volume scheme for shallow‐water flow simulations with irregular bed topography

This study extends the upstream flux‐splitting finite‐volume (UFF) scheme to shallow water equations with source terms. Coupling the hydrostatic reconstruction method (HRM) with the UFF scheme achieves a resultant numerical scheme that adequately balances flux gradients and source terms. The proposed scheme is validated in three benchmark problems and applied to flood flows in the natural/irregular river with bridge pier obstructions. The results of the simulations are in satisfactory agreement with the available analytical solutions, experimental data and field measurements. Comparisons of the present results with those obtained by the surface gradient method (SGM) demonstrate the superior stability and higher accuracy of the HRM. The stability test results also show that the HRM requires less CPU time (up to 60%) than the SGM. The proposed well‐balanced UFF scheme is accurate, stable and efficient to solve flow problems involving irregular bed topography. Copyright © 2009 John Wiley & Sons, Ltd.     

植物样品中痕量碘的测定

研究了植物样品中痕量碘的测定条件.样品用艾斯卡熔剂于550 ℃灰化分解,以乙酸-乙酸钠缓冲体系,控制适当的酸度,利用4,4′-四甲基二胺基甲烷(简称四碱)-氯胺T体系进行催化比色测定,通过对实验温度的严格控制,以及增加样量,较大地改善了催化光度法测定痕量碘的稳定性和灵敏度.结果表明,在选定实验条件下,测定精密度(n=1...