Effects of Hydrogen and Hydrogen Sulfide on Cumene Cracking Catalyzed by Pt/WO3-ZrO2. Control of Acidic and Metallic Functions

Synthesis of alumina aerogels was carried out by hydrolysis of aluminium isopropanolate and butanolate in benzene, methanol and isopropanol solutions as components of support precursors followed by gelation, drying under supercritical conditions and calcination. The influence of the type of precursor and solvent, synthesis temperature as well as drying and calcination temperature on bulk density, specific surface area and total pore volume was investigated.     

负载型Au-Pd双金属催化剂的制备及其对CO氧化的催化活性

采用改性的等体积浸渍法制备了SiO2负载的Au-Pd双金属催化剂,考察了催化剂的焙烧温度对CO氧化反应活性的影响.与623,723和773K的条件下焙烧的催化剂相比,673K焙烧的催化剂具有良好的催化CO氧化活性,CO完全转化温度低于398K.应用N2物理吸附、X射线衍射、程序升温还原、CO程序升温脱附及X射线光电子能谱等技术对催化剂进行了表征.结果表明,673K焙烧的催化剂具有最大的比表面积和最小的孔径,存在Au0,Pd0和PdO相,AuxPdy合金相很少;而773K焙烧的催化剂上除了含有Au0,Pd0和PdO相外,还存在明显的AuxPdy合金相.具有大比表面积,小孔径,Au0,Pd0和PdO多相共存的催化剂可使CO的吸附量增加,催化活性提高;而AuxPdy合金相的生成并不能提高催化剂的催化活性.     

Effects of Calcination Temperature on the Acidity and Catalytic Performances of HZSM-5 Zeolite Catalysts for the Catalytic Cracking of n-Butane

The acidic modulations of a series of HZSM-5 catalysts were successfully made by calcination at different treatment temperatures, i.e. 500, 600, 650, 700 and 800 ℃, respectively. The results indicated that the total acid amounts, their density and the amount of B-type acid of HZSM-5 catalysts rapidly decreased, while the amounts of L-type acid had almost no change and thus the ratio of L/B was obviously enhanced with the increase of calcination temperature (excluding 800 ℃). The catalytic performances of modified HZSM-5 catalysts for the cracking of n-butane were also investigated. The main properties of these catalysts were characterized by means of XRD, N2 adsorption at low temperature, NH3-TPD, FTIR of pyridine adsorption and BET surface area measurements. The results showed that HZSM-5 zeolite pretreated at 800 ℃ had very low catalytic activity for n-butane cracking. In the calcination temperature range of 500-700 ℃, the total selectivity to olefins, propylene and butene were increased with the increase of calcination temperature, while, the selectivity for arene decreased with the calcination temperature.The HZSM-5 zeolite calcined at 700 ℃ produced light olefins with high yield, at the reaction temperature of 650 ℃ the yields of total olefins and ethylene were 52.8% and 29.4%, respectively. Besides, the more important role is that high calcination temperature treatment improved the duration stability of HZSM-5zeolites. The effect of calcination temperature on the physico-chemical properties and catalytic performance of HZSM-5 for cracking of n-butane was explored. It was found that the calcination temperature had large effects on the surface area, crystallinity and acid properties of HZSM-5 catalyst, which further affected the catalytic performance for n-butane cracking.     

焙烧条件对浆态床CO甲烷化Ni-Al2O3催化剂性能的影响

结合行星式球磨机,采用机械化学法制备Ni-Al₂O₃催化剂,考察了焙烧温度和焙烧时间对Ni-Al₂O₃催化剂晶相结构、还原特征、孔道结构和浆态床CO甲烷化性能的影响。通过XRD、H₂-TPR、BET、XPS和TPH等方法对反应前后催化剂进行表征。结果表明,焙烧温度从350℃升高到700℃,活性前体NiO仍在载体表面高度分散,催化剂还原峰温向高温方向偏移。其中,450℃条件下焙烧所获得的cat-450试样比表面积最大,为350 m²/g。评价结果显示,焙烧温度从350℃升高到700℃,CO转化率、CH₄选择性和收率均呈先升高后降低的趋势,于450℃达到最大值,分别为97.8%、88.2%和86.2%。另外,焙烧时间对催化剂的还原性能影响较小,对载体Al₂O₃的晶相结构有一定影响。随焙烧时间延长,CO转化率稍有降低,而后增大;焙烧时间为4 h,CH₄选择性和收率均较大。     

焙烧温度对乙苯脱氢催化剂Fe2O3-K2O性能的影响

用混合法制备了Fe2O3-K2O乙苯脱氢催化剂,并用压汞法、X射线衍射、穆斯堡尔谱、程序升温还原和热重-差热分析等表征手段,考察了焙烧温度对催化剂的催化活性、比表面积、体相结构和还原性能的影响.结果表明,随着焙烧温度的升高,催化剂的比表面积逐渐减小,平均孔径逐渐增大;尖晶石K2Fe22O34中正四面体Fe3 的含量逐渐减少,正八面体Fe3 的含量逐渐增多,催化剂逐渐变得容易被还原;催化剂的催化活性差别不大,但达到平稳时所需的诱导期逐渐缩短.过高的焙烧温度不利于催化剂的稳定性.     

焙烧温度对CuCe/AC催化剂甲醇氧化羰基化性能的影响

采用先浸渍Ce后浸渍Cu的方法制备了活性炭(AC)负载CuCe催化剂,考察了焙烧温度对CuCe/AC催化剂表面结构及其催化甲醇气相氧化羰基化合成碳酸二甲酯(DMC)性能的影响,并采用XRD、XPS和H2-TPR等表征分析了活性组分含量和价态等性质。结果表明,催化剂中高价态的Cu~(2+)逐渐被还原为低价态的Cu~+和Cu~0,催化剂中发生Cu~(2+)→Cu~+→Cu~0的还原变化过程。催化剂经450℃焙烧处理后,催化剂中仍然存在一定量的Cu_2O晶相,表明Ce与Cu的相互作用抑制了部分Cu_2O的还原。当焙烧处理温度为300℃时,催化剂中的Cu~+含量达到最高,此时催化剂的活性达到最优,DMC的时空收率、选择性以及甲醇转化率分别为143.4mg/(g·h)、85.2%和4.1%。     

STUDY ON TPR OF NICKEL OXIDE CATALYSTS CALCINED AT HIGH TEMPERATURES

TPR technique has been used, to investigate the reducibilities of three types of nickel oxide catalysts calcined in air between 650℃and 1050℃: NiO/Al2O3, NiO/MgAl2O4and NiO/(CaO, MgO) · A12O3· xSiO2. The results indicate that the TPR peaks of all the catalysts were shifted toward high temperature and peak areas were gradually reduced with increasing calcination temperature. Particularly, the main TPR peaks almost disappeared at 1050℃-It was also observed that NiO/(CaO, MgO)· Al2O3 · xSiO2 catalyst was the easiest to be reduced of these catalysts, and there was a small shoulder peak before the main peak for each catalyst. Examination of these catalysts by XPS showed that there were two forms of nickel oxides on support surface .     

Inside Cover: Self‐Template‐Directed Formation of Coordination‐Polymer Hexagonal Tubes and Rings,and their Calcination to ZnO Rings (Angew. Chem. Int. Ed. 8/2009)

Hexagonal tubes and rings with unusual shapes were generated through a unique self‐template‐directed growth mechanism. As described by M. Oh and co‐workers in the Communication on page 1459 ff., initially formed solid coordination polymer particles (CPPs) act as templates for the growth of the final hexagonal tubes and rings. Simple calcination of these unusually shaped CPPs results in the spontaneous formation of ZnO particles while the unique shape is maintained.

     

煅烧温度对Li4Ti5O12的电化学性能的影响

用溶胶-凝胶法制备了尖晶石型锂钛复合氧化物L i4Ti5O12,并研究了煅烧温度对其电化学性能的影响。结果表明,在800℃煅烧12 h得L i4Ti5O12,晶型良好,粒度较均匀。并且表现出良好的电化学性能,循环10次后比容量仍保持在160 mAh.g-1左右。