室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

高压下液态Ag-20 at%Ge合金的凝固及密排六方亚稳相的形成

 利用高压淬火方法，在液态Ag-20at%Ge合金的凝固过程中，对比液态急冷低四个数量级的冷却速率得到了单相密排六方结构亚稳相，其点阵参数为a=0.289 8 nm，c=0.470 8 nm，c/a=1.625。     

高压处理对BiSrCaCu2Oy超导电性的影响

 本文在高T_c超导体BiSrCaCu₂O_y常压制备的基础上，研究了热压烧结和冷压处理对其形成、结构及超导电性的影响，并与常压结果进行了比较。结果表明，高压可以使样品的合成时间缩短，合成温度降低。但同时它也抑制了晶格参数较大的相（高T_c相）的形成，使小晶格参数的杂相含量增多。对于提高样品的超导电性而言，1.5 GPa时一个较好的压力点。     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

X波段介质和金属膜片混合加载行波加速结构的传播特性计算及模型腔的有关研究

计算了X波段(f=9.37GHz)介质和金属膜片混合加载行波加速结构的TM₀₁模和HEM₁₁模的色散曲线, 结果表明HEM₁₁模的截止频率比TM₀₁模的低, 说明与盘荷波导相比, 该种新加速结构单束团的BBU效应得到改善.实验研究优选得到了适用于该种新加速结构的介质(ε_r=5.812). 采用MAFIA程序优化设计了模型腔, 测试频率与设计的数值吻合得很好.     

碳化硅压腔和高压下的中子衍射

使用宝石级碳化硅晶体作为压砧材料，成功研制出了碳化硅压腔（MAC），并应用全景式MAC进行了高压下物质的中子衍射实验研究。结果表明，MAC是一种既能产生高的压力又具有大的高压样品室的装置，特别适合于高压下的中子衍射研究。     

一种新的磷化铟复合沟道高电子迁移率晶体管小信号物理模型

针对磷化铟(InP)复合沟道高电子迁移率晶体管(HEMT)的特点，对常规单沟道HEMT的小信号物理模型进行了修正，提出了一种新的用于复合沟道HEMT的小信号物理模型，用商用器件模拟软件ISE(integrated systems engineering)对其进行了仿真验证，对比了实测和仿真的I-V特性及转移特性曲线，重点研究了在InGaAs/InP双层沟道中考虑量子效应后的电场和电流密度随着不同栅电压的变化趋势，研究结果表明，由于在沟道中存在量子效应，在栅下靠源端低电场区域，电流主要分布在InGaAs沟道 关键词： 高电子迁移率晶体管 复合沟道 物理模型 磷化铟     

Molecular dynamics of MgSiO3 perovskite melting

The melting curve of MgSiO分子动力学 MgSiO3钙钛矿 熔化温度 高压melting temperature, molecular dynamics, high pressureProject supported by the National Natural Science Foundation of China (Grant Nos 10274055 and 10376021),the Natural Science Foundation of Gansu Province, China (Grant No 3ZS051-A25-027) and the Scientific Research Foundation of Education Bureau of Gansu Province, China (Grant No 0410-01).2005-01-125/8/2005 12:00:00 AMThe melting curve of MgSiO3 perovskite is simulated using molecular dynamics simulations method at high pressure. It is shown that the simulated equation of state of MgSiO3 perovskite is very successful in reproducing accurately the experimental data. The pressure dependence of the simulated melting temperature of MgSiO3 perovskite reproduces the stability of the orthorhombic perovskite phase up to high pressure of 130GPa at ambient temperature, consistent with the theoretical data of the other calculations. It is shown that its transformation to the cubic phase and melting at high pressure and high temperature are in agreement with recent experiments.     

全固态高功率连续单横模Nd:YVO4/LBO绿光激光器

报道了激光二极管泵浦的高功率连续单横模绿光激光器。考虑到激光晶体因吸收泵浦光而产生的热透镜效应,我们选择低掺杂浓度Nd:YVO4激光晶体,设计了V字型热不灵敏折叠式驻波谐振腔,利用I类非临界相位匹配LBO非线性晶体,当泵浦功率为23 W时,得到7 W单横模532 nm绿光输出功率,光-光转化效率为33%,长期功率稳定性优于1.6%(自由运转3小时)。     

DESIGN OF A NOVEL 2-D UNIPLANAR CRLH-TL STRUCTURE

A novel uniplanar 2-D composite right/left-handed transmission line (CRLH-TL) structure is proposed based on a general transmission line theory and the way to increase the relative operating bandwidth in the left-handed (LH) region and lower the LH operating frequency is illustrated. In addition, a new method to extract parameters and calculate the Bloch impedance of the structure is presented. Numerical results of the dispersion as well as the extracted parameters are given, which are calculated based on full-wave simulation. The present 2-D uniplanar CRLH-TL structure is applicable to 2-D left-handed materials in lower and wider LH frequency range. Supported by the National Natural Science Foundation of China (No. 60371010) (No. 60471037) (No. 63531020)