Pointwise Stabilization for a Chain of Coupled Vibrating Strings

For the system representing a chain of coupled vibrating strings,we show that the associated semigroup satisfies the assumptionof spectrum-determined growth, and hence obtain conditions forenergy to decay strongly or exponentially. We examine in detailthe three-string case, and our results include those obtainedby others for the two-string case. Permanent address: Beijing Institute of Information and Control,Beijing, China.     

[Co(2,3-tri)(ibn)Cl][ZnCl4]体系一经式异构体的晶体结构及体系异构体的理论计算研究

用单晶X-射线衍射分析方法解析了[Co(2,3-tri)(ibn)Cl]²⁺(2,3-tri=N-(2-氨基乙基)-1,3-丙二胺,ibn=1,2-二氨基-2-甲基丙烷)体系中一经式异构体(m2-[Co(2,3-tri)(ibn)Cl][ZnCl₄])。该晶体属单斜晶系,空间群P2₁/c,a=11.317(3)?,b=14.931(4)?,c=11.646(3)?,β=1     

苯部分加氢制环己烯的非晶态Ru-M-B/ZrO2催化剂的表征

采用化学还原法，制备了高活性，高选择性非晶态RU-M-B/ZRO2催化剂，并将其用于催化苯部分加氢制环己烯，在140℃、5.0Mpa氢压下，苯转化40%时，环己烯选择性达到85%左右。环己烯最高收率达到52.1%，用XRD、SEM、BET比表面积测定等手段对摧化剂进行表征，XRD和SEM测试表明，RU-U-B/ZRO2属于非晶态，活性组分高度分散，XRD结果证实，在加氢过程中，非晶分解，RU晶化；温度愈高，RU晶化愈快，催化剂的活性、选择性与RU微晶的粒径有关，RU微晶粒径应控制在5nm左右，BET比表面积测定表明，ZRO2的负载提高了催化剂的比表面积，从而有利于活性组分的高度分散，并可阻止RU微晶的长大，讨论了B和ZRO2对提高选择性的作用。     

丙环唑配合物的合成、缓释性能及生物活性研究

Five propiconazole(L) complexes (ML₂Cl₂, M=Zn(Ⅱ), Cu(Ⅱ), Co(Ⅱ); ML₄Cl₂, M=Ni(Ⅱ), Mn(Ⅱ)) were prepared and characterized by elemental analysis and IR. These complexes exhibited favorable controlled release property, it took 40 to 120 hours to release 85% amount of ligand in the water. The toxicity determination to Botrytis cinera, Rhizoctonia cerealis, Gibberella zeae, Fussrium moniliforme and Colletotrichum orbiculare indicated that the fungicidal activities of the complexes were better than that of the ligand except Mn-complex to Rhizoctonia cereali. The EC50 of Zn-propiconazole were 0.045 2～0.144 1 μg·mL^-1, Co- and Ni-propiconazole were 0.066 3～0.210 4 μg·mL^-1 and 0.183 9～0.340 7 μg·mL^-1, respectively, and Mn-propiconazole were only 0.353 6～0.538 0 μg·mL^-1. The growth regulation experiment to wheat seeding by dressing treating indicated that inhibiting activities of the complexes to root length and stem height were weaker than that of the ligand.     

近临界水中苄叉乙酰苯的合成研究

以近临界水作为反应介质,在无外加催化剂的条件下,苯甲醛与苯乙酮可顺利反应生成苄叉乙酰苯。在最佳条件下,苄叉乙酰苯的收率可达31.4%。该方法避免了常规合成方法中有机溶剂的使用以及NaOH催化剂的加入,产物后处理简单,是一种绿色合成新过程。     

聚乙二醇作造孔剂制备大孔溶胶凝胶生物活性玻璃

Two kinds of macroporous bioglasses were prepared via sol suspension and precipitate using Polyethylene Glycol particles as pore former. The samples were characterized using scanning electron microscopy (SEM), BET, X-ray diffraction (XRD), Intrusion Mercury Porosimetry, mechanical strength test and in vitro bioactivity test. These glasses exhibited a hierarchical structure with interconnected macropores (10～300 μm) and mesopores (2～50 nm) framework. In vitro tests showed that the samples had excellent bioactivity. The samples derived from precipitate showed better macroporous structure and much higher mechanical strength.     

尼龙1010骤冷退火样品的晶体结构

尼龙1010的晶体结构属三斜晶系.作者最近导出了X射线衍射法(WAXD)测定尼龙1010结晶度的公式,进而考查了等温结晶时结晶温度T_C对结晶度X_C、晶粒尺寸L_(100)和氢键面相对衍射强度R的影响.发现X_C和L_(100)均随T_C升高而增大,达196℃后又减小;而R与T_C的关系则相反,呈线性降低.结晶速率快有利于分子链在垂直于氢键面的(100)晶面生长,但R值却降低了.本文利用WAXD考查了尼龙1010不同骤冷退火条件样品的晶体结构.     

Williamson法合成两亲性聚醚砜酮-聚乙二醇接枝共聚物

含二氮杂萘酮结构的聚醚砜酮(PPESK)是一种新型的耐热可溶解工程塑料,其玻璃化温度高达263~305℃,可用来制造耐高温气体分离、超滤和纳滤膜,表现出优异的综合性能[1~4].然而,膜材料本身的疏水特性使PPESK膜在过滤操作中易遭受膜污染,导致膜性能下降,对膜材料进行亲水化改性以抑     

STUDIES ON ION IMPLANTATION AND ELECTRICAL PROPERTIES OF POLYACETYLENE FILMS

The effects of ion implantation on ployacetylene films PA have been studied with Ar~+, Fe~+, C1~+, I~+, Na~+ and K~+ ions in the energy range of 15—30 keV. The changes of PA films in the electrical conductivity, due to chemical doping and ion implantation in relation to their structure and depth profiles of impurities, were measured through infrared (ATR/FTIK), Rutherford backscattering spectrometry (RBS) and the four probe technique. In all cases, ion implantation of active ions exhibits the same effects as chemical doping. The formation of p-n junction is observed at the interface of implanted region and chemical doped PA substrate. The mechanism of interaction process between ion beam and polymer is also discussed.