钯（0）／离子交换树脂对有机锡试剂和有机卤化物偶联反应的催化性能和结构表征

制备了强碱性阴离子交换树脂（）负载钯（０）催化剂，发现它对有机锡试剂和有机卤化物的偶联反应有很高的催化活性，分离容易，可重复使用．起催化作用的是金属态把．ＸＰＳ等实验结果表明，在催化剂中钯作为桥将功能基－Ｎ（ＣＨ３）３与ＯＨ－联结起来．催化剂中的把可以看作是两配位的和配位不饱和的，经过氧化加成、金属交换、还原消除过程完成催化反应．     

时间分辨激光荧光光谱分析方法研究——Ⅰ.铽、镝配合物共存时的分辨原理实验

本文对镝存在时铽的测定,进行了时间分辨激光荧光光谱分析方法的原理性实验。选择Tb、Dy-Sal乙醇溶液体系,测量了Tb~(3+)离子浓度范围为0.01～10μg/ml。Dy~(3+)离子浓度为0.1～100μg/ml范围内的荧光寿命。并得到了此范围内配合物离子浓度与荧光强度具有线性关系的结果。     

内噪声作用下的随机共振算法对弱信号的检测

基于随机共振理论提出了一种简便、有效地检测弱信号的方法。在内噪声协同作用下，通过调节输入噪声信号的大小能较好地提高系统输出信号的信噪比，从而实现检测背景噪声很强的弱信号的目的。应用于模拟信号和实验信号的结果证明了方法是可行的。     

Improved synthesis of functionalized 5,6-dihydro-pyrimido[4,5-b][1,4]oxazepines

Novel synthetic approaches toward 5,6-dihydro-pyrimido[4,5-b][1,4]oxazepines were reported that led to successful introduction of poorly reactive anilines and various 2-hydroxybenzaldehydes to this therapeutically relevant scaffold. More extensive SAR studies on this scaffold hence became possible.     

Separation and determination of protocatechuic aldehyde and protocatechuic acid in Salivia miltorrhrza by capillary electrophoresis with amperometric detection

Capillary electrophoresis with amperometric detection was applied to separate and determine protocatechuic aldehyde and protocatechuic acid in Salivia miltorrhrza preparations. The electrode used was a 0.3 mm diameter carbon disk electrode fixed in a wall-jet with amperometric detection. Under the optimum conditions, the two analytes were separated completely within 8 min. Excellent linearity was obtained in the concentration ranges of 0.25-100.0 microg ml(-1) and 0.50-100.0 microg ml(-1) for protocatechuic aldehyde and protocatechuic acid, respectively. The detection limits were 0.10 microg ml(-1) of protocatechuic aldehyde and 0.25 microg ml(-1) of protocatechuic acid, which were found to be lower than those of other methods that determine protocatechuic aldehyde (3,4-dihydroxybenzaldehyde) and protocatechuic acid (3,4-dihydrobenzoic acid) simultaneously. The mean recoveries of protocatechuic aldehyde and protocatechuic acid were 97.4% and 103.3%. This method has been successfully applied to monitor these two components in real samples such as Salivia miltorrhrza and its two traditional Chinese medicinal preparations.     

Aqueous two-phase extraction as an effective tool for isolation of geniposide from gardenia fruit

Natural products are normally obtained by organic solvent extraction and many subsequent chromatographic separations. Compounds of interest are often isolated with very low yield and limited purity. An aqueous two-phase extraction process combined with a simple ethanol treatment, for removing excess inorganic salt, has been developed for preparation of geniposide from gardenia. The system was comprised of PE62, a random copolymer composed of 20% ethylene oxide and 80% propylene oxide, KH2PO4 and ethanol. To find optimal conditions, the partition behavior of geniposide under an aqueous two-phase system was investigated. Various factors were considered, including the concentration of salt, the concentration of polymer, the sample loading, and the addition of ethanol. The experimental results demonstrated that increasing salt concentration or decreasing PE62 concentration results in enhancement of the geniposide partition in the salt-rich phase. The addition of ethanol and higher sample loading also promoted the partition efficiency of geniposide. Based on this study, an optimized system containing 5% PE62, 7.5% KH2PO4, and 10% ethanol was tested on a large-scale extraction. A 39.0-g aliquot of final product (in powder form) with 77% purity of geniposide can be effectively extracted from 500 g of gardenia fruit. This process is proved to be useful for industrial application of geniposide preparation.     

A copper- and amine-free sonogashira reaction employing aminophosphines as ligands

An efficient Pd-catalyzed Sonogashira coupling reaction was achieved in the absence of a copper salt or amine with an inorganic base and easily prepared, air-stable aminophosphine ligands in commonly used organic solvents; good to excellent yields were obtained. Under optimized reaction conditions, the Sonogashira coupling reaction occurred selectively when an enyne substrate was employed and no Heck reaction product was detected; acetone-masked acetylene and trimethylsilylacetylene can also be efficiently coupled, providing a method to make terminal alkynes.     

Over 18% binary organic solar cells enabled by isomerization of non-fullerene acceptors with alkylthiophene side chains

Side-chain engineering has been demonstrated as an effective method for fine-tuning the optical, electrical, and morphological properties of organic semiconductors toward efficient organic solar cells (OSCs). In this work, three isomeric non-fullerene small molecule acceptors (SMAs), named BTP-4F-T2C8, BTP-4F-T2EH and BTP-4F-T3EH, with linear and branched alkyl chains substituted on the α or β positions of thiophene as the side chains, were synthesized and systematically investigated. The results demonstrate that the size and substitution position of alkyl side chains can greatly affect the electronic properties, molecular packing as well as crystallinity of the SMAs. After blending with donor polymer D18-Cl, the prominent device performance of 18.25% was achieved by the BTP-4F-T3EH-based solar cells, which is higher than those of the BTP-4F-T2EH-based (17.41%) and BTP-4F-T2C8-based (15.92%) ones. The enhanced performance of the BTP-4F-T3EH-based devices is attributed to its stronger crystallinity, higher electron mobility, suppressed biomolecular recombination, and the appropriate intermolecular interaction with the donor polymer. This work reveals that the side chain isomerization strategy can be a practical way in tuning the molecular packing and blend morphology for improving the performance of organic solar cells.

     

人γ晶体蛋白的一级结构测定 1.γ晶体蛋白的分离提纯及其顺序测定方法(GC/MS法)的研究

成功地从人眼晶体中分离出单纯组分的γ晶体蛋白,对γ晶体蛋白的纯度、相对分子质量、氨基酸组成、N末端氨基酸组成等进行了测定,利用酸水解法和酶解法对γ晶体蛋白进行了水解和酶解条件的摸索、找出了使γ晶体蛋白断裂成适合于GC/MS联用仪进行结构测定的肽段的裂解条件。对进行氨基酸顺序测定的GC/MS法化学衍生化条件作了一系列的摸索,找出了化学衍生化的合适条件。对衍生化过程中的一些影响因素也进行了探讨。