Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.     

Experimental 511 W Composite Nd：YAG Ceramic Laser

We demonstrate a 511 W laser diode pumped composite Nd：YAG ceramic laser. The optical pumping system is consisted of five laser diode stacked arrays arranged in a pentagonal shape around the ceramic rod whose size is φ6.35×144mm. When the pumping power is 1600 W, the cw laser output up to 511 W at 1064nm can be obtained with a linear piano-piano cavity, and the optical-to-optical efficiency is 31.9%. To our knowledge, this is the highest value of laser output by using a newly invented composite Nd：YAG ceramic rod as the gain medium.     

Optical characterization of CdTe/ZnSe fractional monolayer structures grown by atomic layer epitaxy

Luminescence properties of CdTe/ZnSe fractional monolayer grown by atomic layer epitaxy have been investigated. To investigate the origin of the highly efficient luminescence, various optical spectroscopic methods such as, photoluminescence (PL), temporal/spatial resolved PL, temperature dependence PL, and excitation power dependence PL have been used. It is found that structural inhomogeneities affect dominant influence on the line width and line shape of luminescence. The luminescence intensity greatly enhanced by the localization of exciton at the disorder induced localized states.     

Lanthanide Complexes for Oligomerization of Phenyl Isocyanate

IntroductionThestudyonthereactivitiesoflanthanidecomplexesto wardisocyanateshasattractedmuchattention .Ithasbeenre portedthatlanthanidealkoxides,1anddivalentdiaza pentadi enyllanthanidecomplexes2 canbeusedasthesinglecompo nentinitiatorsforisocyanatespolymerization .Recentlyourre searchgrouphasalsofoundthatlanthanoceneamide ,3diva lentaryloxideofsamarium4 ,5anddivalentsamarocene6 areallactivefortheoligomerizationofphenylisocyanate,andtheactivespeciesforthesethreesystemswereallsuccessfullyisolat…     

KF-Al2O3催化合成2-甲基-1-苄基苯并咪唑

苯并咪唑类杂环化合物具有杀菌、消炎、抗癌、抗氧化的活性,广泛用于食品的防虫和防腐,用于动、植物病毒的防治,人体疾病和肿瘤的防治[1-3],本文用KF Al2O3作催化剂,用DMF为溶剂,利用2 甲基苯并咪唑与苄基溴反应合成2 甲基 1 苄基苯并咪唑的新型方法,考察了诸因素对产率的影响,找出了最佳的反应条件。合成路线如下:1　实验部分1 1　仪器与试剂Brurer AM 500超导核磁共振波谱仪(溶剂CDCl3);CarloErbal1106型元素分析仪,NicoletIm pact410型红外光谱仪,KBr压片,HP1100型和Finnigan FTMS 2000型质谱仪(以上均由华东理工大学分析…     

热线法测定气体导热系数实验的探讨与改进

在准静态低气压下测量气体的热传导系数时，理论上在低压强范围内应得到Q^-1低-p^-1线性关系图象，但实验数据所绘出的图象出现明显的非线性．本文着重分析出现非线性的原因，并提出实验改进的方法。