LPE GaxIn1-xAs1-ySby/InP和GaxIn1-xAs1-ySby/InAs的生长及其估价

将电负性差法估算的Ga_xIn_1-xAs_1-ySb_y/InP和Ga_xIn_1-xAs_1-ySb_y/InAs的固相和液相组份数据应用于液相外延生长,均获得了晶格匹配的材料,并首次获得了波长λ>3.5μm的Ga_xIn_1-xAs_1-ySb_y/InAs异质外延材料。Ga_xIn_1-xAs_1-ySb_y/InP的固体组份为...     

自发有序Ga0.5In0.5P合金的静压光致发光研究

在０—７ＧＰａ静压范围内测量了自发有序Ga_0.5In_0.5P合金的室温光致发光谱．三块样品的常压带隙能量分别比无序样品低１１５，９２和４３ｍｅＶ，它们的压力系数也从无序样品的９２ｍｅＶ／ＧＰａ分别减小到７５，８１和８３ｍｅＶ／ＧＰａ．用Γ-Ｌ相互作用模型可以同时解释有序合金的带隙能量的降低以及压力系数的减小．得到的Γ-Ｌ相互作用势分别为０.１９，０.１５和０.１０ｅＶ．表明在自发有序Ga_0.5In_0.5P合金中存在着的     

硅的低温电学性质

本文在20°—300°K研究了室温载流子浓度2×10¹²—1×10²⁰cm^-3含硼或磷(砷)Si的电学性质。对一些p-Si样品用弱场横向磁阻法及杂质激活能法进行了补偿度的测定,并进行了比较。从霍尔系数与温度关系的分析指出,对于较纯样品,硼受主能级的电离能为0.045eV,磷施主能级为0.045eV,在载流子浓度为10¹⁸—10¹⁹cm^-3时发现了费米简并,对载流子浓度为2×10¹⁷—1×10¹⁸cm^-3的p-Si及5×10¹⁷—4×10¹⁸cm^-3的n-Si观察到了杂质电导行为。从霍尔系数与电导率计算了非本征的霍尔迁移率。在100°—300°K间,晶格散射迁移率μ满足关系式AT^-a,其中A=2.1×10⁹,α=2.7(对空穴);或A=1.2×10⁸,α=2.0(对电子)。另外,根据我们的材料(载流子浓度在5×10¹¹—5×10²⁰cm^-3间),分别建立了一条电阻率与载流子浓度及电阻率与迁移率的关系曲线,以提供制备材料时参考之用。     

Terahertz Quantum Cascade Laser Operating at 2.94THz

The development of quantum cascade laser at 2.94 THz is reported. The laser structure is based on a bound-to-continuum active region and a semi-insulating surface-plasmon waveguide. Lasing is observed up to a heat-sink temperature of 70 K in pulsed mode with light power of 4.75 mW at 10 K and 1 mW at 70 K. A threshold current density of 296.5 A/cm2 and an internal quantum efficiency of 1.57 × 10-2 per cascade period are also observed at 10 K. The characteristic temperature of this laser is extracted to be T0 = 57.5 K.     

InAs/GaAs submonolayer quantum-dot superluminescent diodes with active multimode interferometer configuration

With a chirped InAs/GaAs SML-QD (quantum dot) structure serving as the active region, the superluminescent diodes emitting at wavelength of around 970nm are fabricated. By using an active multimode interferometer configuration, these devices exhibit high continue-wave output powers from the narrow ridge waveguides. At continue-wave injection current of 800mA, an output power of 18.5mW, and the single Gaussian-like emission spectrum centered at 972nm with a full width at half maximum of 18nm are obtained.     

Electronic Energy Levels in an Asymmetric Quantum-Dots-in-a-Well Structure for Infrared Photodetectors

Theoretical calculation of electronic energy levels of an asymmetric InAs/InGaAs/GaAs quantum-dots-in-a-well （DWELL） structure for infrared photodetectors is performed in the framework of effective-mass envelope-function theory. Our calculated results show that the electronic energy levels in quantum dots （QDs） increase when the asymmetry increases and the ground state energy increases faster than the excited state energies. Furthermore, the results also show that the electronic energy levels in Q Ds decrease as the size of QDs and the width of quantum well （QW） in the asymmetric DWELL structure increase. Additionally, the effects of asymmetry, the size of QDs and the width of QW on the response peak of asymmetry DWELL photodetectors are also discussed.     

A Simple Route of Morphology Control and Structural and Optical Properties of ZnO Grown by Metal-Organic Chemical Vapour Deposition

Employing the metal-organic chemical vapour deposition （MOCVD） technique, we prepare ZnO samples with different morphologies from the film to nanorods through conveniently changing the bubbled diethylzinc flux （BDF） and the carrier gas flux of oxygen （OCGF）. The scanning electron microscope images indicate that small BDF and OCGF induce two-dimensional growth while the large ones avail quasi-one-dimensional growth. X-ray diffraction （XRD） and Raman scattering analyses show that all of the morphology-dependent ZnO samples are of high crystal quality with a c-axis orientation. From the precise shifts of the 20 locations of ZnQ （002） face in the XRD patterns and the E2 （high） locations in the Raman spectra, we deduce that the compressive stress forms in the ZnO samples and is strengthened with the increasing BDF and OCGF. Photoluminescence spectroscopy results show all the samples have a sharp ultraviolet luminescent band without any defects-related emission. Upon the experiments a possible growth mechanism is proposed.     

多晶AlN光学性质研究

运用X射线衍射仪和拉曼光谱仪,测量了物理气相输运(PVT)方法生长的AlN多晶材料的X射线衍射和常温拉曼光谱。常温拉曼光谱研究了晶界、晶面方向与拉曼频率的关系,观察到了E和E峰位基本不随测量位置变化,与晶界无关,但是E1(TO),A1(LO)和Quasi-LO声子峰位却明显与晶界有关,为研究晶粒间、晶粒内应力提供了有效手段。     

大功率短波长InAlGaAs/AlGaAs量子点超辐射发光管

为了满足超辐射发光管的短波长应用,采用InAlGaAs/AlGaAs量子点有源区和干法刻蚀工艺制备了短波长弯曲波导超辐射发光管。在1.6A脉冲电流注入下,器件峰值输出功率为29mW,中心波长为880nm,光谱半高宽为20.3nm。比较了干法刻蚀工艺和湿法腐蚀工艺对超辐射发光管器件性能的影响。在1.6A脉冲电流注入下,湿法腐蚀制备的器件峰值输出功率仅为7mW。与湿法腐蚀相比,干法刻蚀可以精确控制波导形状和参数,降低波导损耗,有效增大器件输出功率。     

1.5μm LUMINESCENCE CHARACTERISTIC OF ERBIUM IN B, P DOPED a-SiO:H FILMS

Hydrogenated amorphous silicon films co-doped with oxygen (O), boron (B) and phosphorus (P) were fabricated using PECVD technique. The erbium (Er) implanted samples were annealed in a N₂ ambient by rapid thermal annealing. Strong photoluminescence (PL) spectra of these samples were observed at room temperature. The incorporation of O, B and P could not only enhance the PL intensity but also the thermal annealing temperature of the strongest PL intensity. It seems that the incorporation of B or P can decrease the grain boundary potential barriers thus leading to an easier movement of carriers and a stronger PL intensity. Temperature dependence of PL indicated the thermal quenching of Er-doped hydrogenated amorphous silicon is very weak.