Lanthanum trilactate: Vibrational spectroscopic study − infrared/Raman spectroscopy

In this study lanthanum trilactate was prepared by neutralization reaction of lactic acid and lanthanum oxide, purified and identified by X-ray powder diffraction. Infrared spectra (Mid-IR region 4000–650 cm⁻¹) and Raman spectra (Stokes region 4000–100 cm⁻¹) of the high quality crystalline samples have been recorded and presented for the first time. For comparison DFT calculations were performed using Gaussian 09 D.01 and agreement between predicted and measured spectral data has been achieved. Acquired information can be utilized for substance identification for example in various industrial applications or in biological systems.     

Determination of lanthanum and cerium in cmsx-4 nickel-based superalloys by inductively coupled plasma mass spectrometryEI北大核心CSCD

CMSX-4 is the second-generation nickel-based single crystal superalloy used widely in the world. The oxidation resistance and corrosion resistance of CMSX-4 alloy can be improved by adding trace lanthanum (La), cerium (Ce) and other rare earth elements. A method for the simultaneous determination of La and Ce in CMSX-4 nickel-based superalloy by wet dissolution-inductively coupled plasma mass spectrometry was established. The sample was heated and dissolved under normal pressure by aqua regia and hydrofluoric acid, and the interference of fluorine ion was eliminated by using perchloric acid. The amount of dissolved acid and the digestion conditions were optimized. The limits of detection were 0.23 μg/g for La and 0.85 μg/g for Ce under optimized conditions. The spiked recoveries were 95.0%–98.9% with the relative standard deviations of 1.3%–3.9%, which can meet the requirements of accurate and rapid determination of La and Ce in CMSX-4 nickel-based superalloy. © 2023, Youke Publishing Co.,Ltd. All rights reserved.     

A Further Extension of Pnictide Oxide Chemistry – Synthesis and Structure of La2AuP2O

The phosphide oxide La₂AuP₂O was synthesized from lanthanum filings, dried La₂O₃, gold pieces, and ground red phosphorus in the ideal 1.33:0.33:1:2 ratio in an evacuated silica tube at 1473 K. Small single crystals were obtained by recrystallization in a NaCl/KCl flux. The structure was determined on the basis of single‐crystal X‐ray diffractometer data: new type, C2/m, a = 1537.3(3), b = 427.39(8), c = 1009.2(2) pm, β = 131.02(1) °, wR₂ = 0.046, 1102 F² values, 38 variables. La₂AuP₂O contains two striking structural motifs: The oxygen atoms are located in La₄ tetrahedra. The latter are cis‐edge‐shared forming polymeric cationic [La₂O]⁴⁺ chains. These cationic units are separated and charge‐balanced by [AuP₂]^4– polyanions which have monovalent gold in distorted trigonal planar phosphorus coordination. Two crystallographically independent phosphorus sites occur in the polyanion, i.e. isolated P^3– besides dumb‐bells P₂^4– (P2–P2 223 pm). La₂AuP₂O, which crystallizes in the form of ruby red transparent crystals, is an electron precise phosphide oxide (4La³⁺)(2Au⁺)(2P^3–)(P₂^4–)(2O^2–).     

Study on the interaction of La with bovine serum albumin at molecular level

The interaction of La³⁺ to bovine serum albumin (BSA) has been investigated mainly by fluorescence spectra, UV-vis absorption spectra, and circular dichroism (CD) under simulative physiological conditions. Fluorescence data revealed that the quenching mechanism of BSA by La³⁺ was a static quenching process and the binding constant is 1.75×10⁴ L mol⁻¹ and the number of binding sites is 1 at 289 K. The thermodynamic parameters (ΔH=−20.055 kJ mol⁻¹, ΔG=−23.474 kJ mol⁻¹, and ΔS=11.831 J mol⁻¹ K⁻¹) indicate that electrostatic effect between the protein and the La³⁺ is the main binding force. In addition, UV-vis, CD, and synchronous fluorescence results showed that the addition of La³⁺ changed the conformation of BSA.     

Ce0.8Nd0.2O1.9-La0.95Sr0.05Ga0.9Mg0.1O3-δ固体复合电解质的结构和电性能

采用溶胶-凝胶法分别制备La_0.95Sr_0.05Ga_0.9Mg_0.1O_3-δ (LSGM)和Ce_0.8Nd_0.2O_1.9 (NDC)电解质,并在NDC溶胶中加入0-15% (w,质量分数)的LSGM预烧粉体制得NDC-LSGM复合电解质,研究不同质量比复合电解质的结构和电性能. 采用X射线衍射(XRD)、场发射扫描电子显微镜(FE-SEM)和X能量色散谱仪(EDS)对样品进行结构表征,交流(AC)阻抗谱测试样品导电性能. 结果表明：NDC-LSGM复合体系主要由立方萤石结构相、钙钛矿结构相和杂质相组成;LSGM的添加可促进晶粒的生长,产生大量相界面,清除或降低SiO₂有害影响,明显提高晶界导电性;LSGM质量分数为10%的样品NL10 具有最高晶界电导率和总电导率,400 ℃时NL10 的晶界电导率σ_gb和总电导率σ_t分别为12.15×10^-4和3.49×10^-4 S·cm^-1,与NDC的σ_gb (1.41×10^-4 S·cm^-1)和σ_t (1.20×10^-4 S·cm^-1)相比分别提高了7.62和1.91倍,总电导率的提高主要归因于晶界电导率的影响.     

Ternary Solid Nano Organic/Inorganic Composite of Lanthanum with Acetic Acid and Curcumin/ Hydroxyapatite and Its Antibacterial Activity

Ternary solid complex was synthesized via hybridization of curcumin（Cur）, hydroxyapatite（HAP）, lanthanum（La） and acetic acid（HAc）. The nano-scale hybrid composite of La-Cur/HAP was directly prepared by the wet method. The morphologies and structures of the composite were characterized by scanning electron microscopy （SEM）, infrared（IR） spectroscopy, X-ray diffraction（XRD）, transmission electron microscopy（TEM） and energy dispersive X-ray spectroscopy. The antibacterial activities were tested by methods of minimum inhibitory concentration （MIC） and minimum bactericidal concentration（MBC）. The results show that the size of the La-Cur/HAP composite is less than 100 nm, and the composite exhibits strong bacteriostatic activity against Escherichia coli（E, colt） and Staphylococcus aureus（S, aureus） at low concentrations（in the range of 26-92μg/mL）. The composite can exhibit both of the bacteria and shows higher antibacterial activity against S. aureus than against E. colt. At the same time, La-Cur/HAP shows stronger antibacterial efficiency than ampicillin/HAP.     

Dielectric behaviour of La substituted BPZT ceramics

Here, we report dielectric behaviour of lanthanum substituted Ba_0.80Pb_0.20Ti_0.90Zr_0.10O₃ (BPZT) ceramics. The material series with compositional formula Ba_0.80−xLa_xPb_0.20Ti_0.90Zr_0.10O₃ (BLPZT) with x varying from 0 to 0.01 in the steps of 0.0025 was chosen for investigations. The material was synthesized by solid state reaction method. Reacted powder compacted in form of circular discs were sintered at 1325 °C. All the samples were subjected to X-ray diffraction (XRD) analysis and found to be single phase. Dielectric behaviour was studied as a function of frequency and temperature and Curie temperature (T_c) was determined. T_c was found to decrease with increasing x. The details are discussed and presented in this paper.     

Electrochemical Detection of Schistosoma Japonicum Antibody Using Biocatalytic Deposition

Abstract

An ultrasensitive electrochemical immunoassay based on biocatalytic deposition has been proposed for the detection of Schistosoma japonicum antibody (SjAb) in infected rabbit serum. Schistosoma japonicum antigen (SjAg) was immobilized on the gold electrode surface via glutaraldehyde crosslink and then incubated with infected rabbit serum containing SjAb; finally, the goat anti-rabbit IgG labeled with alkaline phosphatase was sandwiched to form the immunocomplex on the gold electrode surface. The alkaline phosphatase converted nonelectroactive substrate into the reducing agent and the latter, in turn, reduced metal ions to form electroactive metallic product on the electrode surface. Linear sweep voltammetry (LSV) was used to quantify the amount of the deposited silver and give the analytical signal for SjAb. Assay conditions such as the antigen concentration and enzymatic silver deposition time were optimized. The electrochemical immunosensor was able to realize a reliable determination of SjAb in the dilution range from 1:5000 to 1:100 with a detection limit of 1:6457 of dilution ratio. The feasibility of the proposed immunosensor for possible clinical applications was also investigated by analyzing real serum samples.     

Influence of processing variables on the formation of La2Zr2O7 in transferred arc plasma torch processing

The transferred arc plasma (TAP) torch process has various noteworthy features such as extremely high temperatures, low environmental impact and short processing time which makes it the most suitable technique for synthesizing ceramic composite materials. Furthermore, it is a direct two-step technique which by its virtue of high temperature and power density paves way for high production rate. Hence in this study, an effort has been made to utilize the TAP torch processing technique for the bulk production of La₂Zr₂O₇ with time effectiveness from the mixture of La₂O₃ and ZrO₂ powders (1:2 mol ratios) which were ball milled for 4 h. For this purpose, transferred arc plasma torch was specially designed in laboratory scale level and the operating parameters were optimized in order to achieve maximum La₂Zr₂O₇ formation efficiency. In this study, the phase and microstructure formation of the processed samples was analyzed via X-ray diffraction (XRD) and scanning electron microscope (SEM) images respectively. Moreover, EDX analysis was incorporated to highlight the superior influence of the longer processing time on the stoichiometric ratio of ZrO₂/La₂O₃ in the processed sample as against input power and the gas flow rate.     

Perovskites as Precursors for Ni/La2O3 Catalysts in the Dry Reforming of Methane: Synthesis by Constant pH Co‐Precipitation,Reduction Mechanism and Effect of Ru‐Doping

LaNiO₃ perovskite is an interesting precursor for Ni/La₂O₃ catalysts for the dry reforming of methane at high temperatures. Precursors have been synthesized by co‐precipitation without, with 2.5 at %, and with 5 at % Ru doping. The presence of Ru leads to a stabilization of the perovskite structure and hinders the decomposition into NiO and Ruddlesden‐Popper mixed oxides La_n+1Ni_nO_3n+1, which was observed for the Ru‐free sample upon calcination at 1000 °C (n = 3). Upon reduction in hydrogen, a mechanism involving at least two steps was observed and the first major step was identified as the partial reduction of the precursor leading to a LaNiO_2.5‐like intermediate. The second major step is the reduction to Ni metal supported on La₂O₃ independent of the Ru content of the catalyst. In the presence of Ru, indications for Ni‐Ru alloy formation and for a higher dispersion of the metallic phase were found. The catalytic activity in DRM of the catalyst containing 2.5 % Ru was superior to the catalysts with more or without Ru. Furthermore, the propensity of coke formation was reduced by the presence of Ru.