新型酞菁的光致发光性质研究

研究了2,3-四-(2-异丙基一5-甲基苯氧基)氢酞菁在10,77,177和300 K下石英衬底上的浇铸膜和单晶硅衬底上真空镀膜(约200 nm厚)在300 K下光致发光光谱.氢酞菁的浇铸膜光致发光光谱在上述温度下均出现荧光发射和磷光发射峰,在177和300 K下出现了1 673 nm激基缔合物峰.该峰的出现与分子抗聚集能力的强弱有关,在300 K激基缔合物峰比在177 K下的峰强,从氢酞菁分子结构特点讨论了形成激基缔合物的原因.随着温度的升高,可以观察到荧光发射峰渐渐减弱而激基缔合物峰变强.由于浇铸膜和真空镀膜的酞菁分子聚集态不同导致了斯托克司位移的差异,真空镀膜的发光峰峰值在1 140 nm左右,与酞菁浇铸膜的峰值差别较大.浇铸膜的发光峰的半高宽为300 nm,而真空镀膜发光峰的半高宽为100 nm左右.     

2(3)-四-(2-异丙基-5-甲基苯氧基)钛氧酞菁的合成及其近红外发光特性

通过分步合成的方法,在钛氧酞菁的外围引入了四个苯氧基团,合成了一种2(3)-四-(2-异丙基-5-甲基苯氧基)钛氧酞菁.通过质谱、核磁、元素分析、紫外可见吸收光谱、近红外光荧光谱和循环伏安法对其结构和性质进行了表征,并利用旋涂加真空热蒸发的方法制得了该材料的电致发光器件(ITO/PVK:TiOPc/BCP/LiF/Al).结果表明,四取代的钛氧酞菁固态的近红外光荧光峰值在1080nm左右;其近红外电致发光的峰值波长落在1050nm左右.在PVK掺杂的器件中,钛氧酞菁的质量分数为30%时有较强的发光强度.     

氮杂酞菁铜aza-CuPc的合成与晶体结构

本文报道在固相条件下合成氮杂酞菁铜原料, 借助同步辐射光源进行单晶结构测试, 通过物理方法获得了其单晶结构数据.     

溶剂热法直接合成酞菁铜晶体

以喹啉为溶剂, 在反应釜中将1,3-二异吲哚、钼酸铵和二水乙酸铜在喹啉中反应, 降至室温后得到长10.5 mm针状的酞菁铜单晶, 最佳的反应条件: 以10 mL喹啉为溶剂, 于270 ℃反应8 h, 产率为51.3%.     

Organic Thin Film Field Effect Transistors with PMMA-GMA Gate Dielectric

We fabricate organic thin films using the copolymer of methyl methacrylate and glycidyl methacrylate （PMMA- GMA） as a gate dielectric with a simple top-contact structure. Copper phthalocyanine （CuPc） TFTs are fabricated and the influences of annealing on the performance are studied. The mobilities increase from 2.5 × 10^3 cm^2/Vs to 4.2 × 10^3 cm^2/Vs and threshold voltages decrease from -18 V to -10 V after annealing. The good performances of the devices approach those obtained with inorganic gate dielectric materials such as silicon dioxide under the same technical conditions. It is fully proven that PMMA-GMA is a competitive candidate as an excellent gate insulation layer.     

Near-infrared electroluminescent diodes based on copper hexadecafluorophthalocyanine CuPcF16

We demonstrate the near-infrared （NIR） organic light-emitting devices （OLEDs） based on copper hexade-cafluorophthalocyanine （CuPcF16） doped into 2,2,2”-（1,3,5-benzenetriyl）tris-[1-phenyl-1H-benzimidazole] （TPBI）. The device structure is ITO/ NPB/ TPBI：CuPcF16/BCP/Alq3/Al. Room-temperature electro- luminescence is observed at about 1106 nm due to transitions from the first excited triplet state to the ground state （T1-S0） of CuPcF16. The result indicates that FSrster and Dexter energy transfers play a minor role in these devices, while the direct charge trapping is the dominant mechanism. The absorption spectra of CuPeF16 solution in pyridine and vacuum sublimed films on quartz have also been investigated.     

Near-Infrared Emission from Organic Light-Emitting Diodes Based on Copper Phthalocyanine with a Periodically Arranged Alq3：CuPc/DCM Multilayer Structure

We demonstrate near-infrared organic light-emitting devices with a periodically arranged tris（8-quinolinolato）aluminum （Alq3）：copper phthalocyanine （CuPc）/4-（dicyanomethylene）-2-methyl-6-（4-dimethylaminost-yry）-4H-pyran （DCM） multilayer structure. DCM and Alq3 doped with CuPc were periodically deposited. Room-temperature electrophosphorescence was observed at about 1.1 μm due to transitions from the first excited triplet state to the singlet ground state （T1 - S0） of CuPc. In this device, we utilize the overlap between the Q band πr - π^＊ at about 625nm of the absorption spectra of CuPc and the PL spectra of the DCM. The near-infrared emission intensity of the CuPc-doped Alq3 device with DCM increases about 2.5 times larger than that of the device without DCM. We attribute the efficiency enhancement to the better overlap between the PL spectra of DCM and the absorption spectra of CuPc.