Mechanism of BPh3-Catalyzed N-Methylation of Amines with CO2 and Phenylsilane: Cooperative Activation of Hydrosilane

BPh₃ catalyzes the N-methylation of secondary amines and the C-methylenation (methylene-bridge formation between aromatic rings) of N,N-dimethylanilines or 1-methylindoles in the presence of CO₂ and PhSiH₃; these reactions proceed at 30–40 °C under solvent-free conditions. In contrast, B(C₆F₅)₃ shows little or no activity. ¹¹B NMR spectra suggested the generation of [HBPh₃]⁻. The detailed mechanism of the BPh₃-catalyzed N-methylation of N-methylaniline ( 1 ) with CO₂ and PhSiH₃ was studied by using DFT calculations. BPh₃ promotes the conversion of two substrates (N-methylaniline and CO₂) into a zwitterionic carbamate to give three-component species [Ph(Me)(H)N⁺CO₂⁻⋅⋅⋅BPh₃]. The carbamate and BPh₃ act as the nucleophile and Lewis acid, respectively, for the activation of PhSiH₃ to generate [HBPh₃]⁻, which is used to produce key CO₂-derived species, such as silyl formate and bis(silyl)acetal, essential for the N-methylation of 1 . DFT calculations also suggested other mechanisms involving water for the generation of [HBPh₃]⁻ species.     

Improvement in flow-sheet of extraction chromatography for trivalent minor actinides recovery

Journal of Radioanalytical and Nuclear Chemistry - Extraction chromatography flow-sheet employing octyl(phenyl)-N,N-diisobutylcarbonoylmethylphosphine oxide and bis(2-ethylhexyl) hydrogen phosphate...     

Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Classification for dimethylarsenate-decomposing bacteria using a restrict fragment length polymorphism analysis of 16S rRNA genes.

A new monitoring system for bacterial communities involving dimethylarsinic acid (DMAA) decomposition was provided by combining the MPN (Most Probable Number) method and RFLP (restriction-fragment-length polymorphism analysis). The abundance of DMAA decomposing bacteria was estimated by the MPN method using a bacterial culture medium, which included DMAA as the sole carbon source, indicating bacterial cell densities of 1700 cells/ml in Lake Kahokugata and 330 cells/ml in Lake Kibagata. After isolating the dominant bacteria using agar plates, the isolates were classified into some genotype groups by RFLP analysis using 16S rDNA sequences. Classification of the RFLP analysis indicated that 14 isolates of Lake Kahokugata were classified into 6 types, which included 2 dominant types related to genus Pseudomonas, while 8 isolates of Lake Kibagata displayed 6 types including one or two isolates. Moreover, the RFLP types were unique for each lake, suggesting that DMAA decomposing bacteria were specific for the aquatic environment related to the arsenic cycle. The activities of DMAA decomposition mostly matched with the RFLP type category of the isolates. Accordingly, combining the MPN method with the RFLP analysis will play an important role in elucidating the distributions and dynamics of the DMAA-decomposing bacterial community.     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

High-throughput characterization of local conductivity of Nd0.9Ca0.1Ba2Cu3O7−δ thin film by the low-temperature scanning microwave microscope

We developed a scanning microwave microscope (SμM) designed for high-throughput electric-property screening as well as for rapid construction of electronic phase diagrams at low temperatures. As a sensor probe, we used a high-Qλ/4 coaxial cavity resonator to which a thin needle with ball-tip end was attached. The sensor module was mounted on the low-temperature XYZ stage, which allowed us to map out the change of resonance frequency and quality factor due to the local tip-sample interaction at low temperatures. From the measurements of combinatorial thin films, such as Ti_1−xCo_xO_2−δ and Nd_0.9Ca_0.1Ba₂Cu₃O_7−δ (NCBCO), it was demonstrated that this SμM system has enough performance for the high-throughput characterization of sample conductance under variable temperature conditions.     

Discrimination of carbonyl groups of meso-α-diketones with Horner-Wadsworth-Emmons reagent of chiral binaphthyl esters

Asymmetric Horner-Wadsworth-Emmons reactions of selected meso-α-dicarbonyl compounds with chiral phosphonate reagents, which possessed axially dissymmetric 1,1′-bi-2- or 8-naphthol at the carboxylate moiety as a chiral auxiliary, were examined. The reactions proceeded smoothly with good chemical yields as well as with high diastereoselectivities. Z-olefins were preferentially formed, and it was found that the free hydroxy group at the 2′- or 8′-position on the naphthalene ring plays a crucial role in the high diastereoselectivity, probably due to a complex-induced proximity effect. Mechanistic considerations are also described.     

FMS scheduling based on timed Petri Net model and reactive graph search

This paper presents a new scheduling method for manufacturing system based on the Timed Petri Net model and a reactive fast graph search algorithm. The following two typical problems are addressed in this paper. (1) Minimization of the maximum completion time. (2) Minimization of the total tardiness. As for the problem (1), a new search algorithm which combines the RTA^∗ and a rule-based supervisor is proposed. As for problem (2), the original Petri Net model is converted to its reverse model and the algorithm developed for the problem (1) is applied, regarding the due date as the starting time in the reverse model. Some numerical experiments are carried out to demonstrate usefulness of our algorithm.