排序方式: 共有30条查询结果,搜索用时 15 毫秒
1.
对以本征Si及重掺杂p型和n型Si作为中间层的Fe/Si多层膜的层间耦合进行研究,并通过退火,增大Fe,Si之间的扩散,分析界面扩散对层间耦合的影响. 实验结果表明,层状结构良好的制备态的多层膜,Fe,Si之间也存在一定程度的扩散,它是影响层间耦合的 主要因素,远远超过了半导体意义上的重掺杂,使不同种类的Si作为中间层的层间耦合基本 一致.进一步还发现,在一定范围内增大Fe,Si之间的扩散,即使多层膜的层状结构已经有了相当的退化,Fe/Si多层膜的反铁磁耦合强度基本保持不变.
关键词:
Fe/Si多层膜
层间耦合
界面扩散 相似文献
2.
3.
We give a brief introduction to the oxide (ZnO, TiO2, In2O3, SnO2, etc.)-based magnetic semiconductors from fundamental material aspects through fascinating magnetic, transport, and optical properties, particularly at room temperature, to promising device applications. The origin of the observed ferromagnetism is also discussed, with a special focus on first-principles investigations of the exchange interactions between transition metal dopants in oxide-based magnetic semiconductors. 相似文献
4.
Oscillation of coercivity between positive and negative in MnxGe1-x:H ferromagnetic semiconductor films 下载免费PDF全文
Amorphous MnxGe1-x :H ferromagnetic semiconductor films prepared in mixed Ar with 20% H2 by magnetron cosputtering show global ferromagnetism with positive coercivity at low temperatures. With increasing temperature, the coercivity of MnxGe1-x :H films first changes from positive to negative, and then back to positive again, which was not found in the corresponding MnxGe1-x and other ferromagnetic semiconductors before. For Mn0.4Ge0.6 :H film, the inverted Hall loop is also observed at 30 K, which is consistent with the negative coercivity. The negative coercivity is explained by the antiferromagnetic exchange coupling between the H-rich ferromagnetic regions separated by the H-poor non-ferromagnetic spacers. Hydrogenation is a useful method to tune the magnetic properties of MnxGe1-x films for the application in spintronics. 相似文献
5.
利用磁控溅射仪制备了高Co含量的Ti1-xCocO2磁性半导体样品,并对样品分别在200℃,300℃和400℃进行退火研究.使用透射电子显微镜(TEM)对退火前后样品的结构进行表征,并用X射线光电子能谱(XPS)对退火前后样品中Co元素的化学状态进行鉴定.结果表明高Co含量的Ti1-xCoxO2磁性半导体处于一种亚稳状态,300℃以上的温度便使其结构与成分发生巨大变化.利用超导量子干涉磁强计(SQUID)测量退火前后样品的磁特性.结果表明样品的磁性有了明显的变化,这源于磁性产生的不同机理. 相似文献
6.
Structural and physical properties of BiFeO3 thin films epitaxially grown on SrTiO3(001) and polar(111) surfaces 下载免费PDF全文
The influence of surface polarity on the structural properties of BiFeO3 (BFO) thin films is investigated. BFO thin films are epitaxially grown on SrTiO3 (STO) (100) and polar (111) surfaces by oxygen plasma-assisted molecular beam epitaxy. It is shown that the crystal structure, surface morphology, and defect states of BFO films grown on STO substrates with nonpolar (001) or polar (111) surfaces perform very differently. BFO/STO (001)is a fully strained tetragonal phase with orientation relationship (001)[100]BFOII(001)[100]STO, while BFO/STO (111) is a rhombohedral phase. BFO/STO (111) has rougher surface morphology and less defect states, which results in reduced leakage current and lower dielectric loss. Moreover, BFO films on both STO (001) and STO (111) are direct band oxides with similar band gaps of 2.65 eV and 2.67 eV, respectively. 相似文献
7.
Universal spin-dependent variable range hopping in wide-band-gap oxide ferromagnetic semiconductors 下载免费PDF全文
This paper proposes a universal spin-dependent variable
range hopping theoretical model to describe various experimental
transport phenomena observed in wide-band-gap oxide ferromagnetic
semiconductors with high transition metal concentration. The
contributions of the `hard gap' energy, Coulomb interaction,
correlation energy, and exchange interaction to the electrical
transport are considered in the universal variable range hopping
theoretical model. By fitting the temperature and magnetic field
dependence of the experimental sheet resistance to the theoretical
model, the spin polarization ratio of electrical carriers near the Fermi
level and interactions between electrical carriers can be
obtained. 相似文献
8.
[ZnO(0.5 nm)/Co(0.6 nm)]60 multilayers were fabricated by magnetron sputtering. The magnetic, transport and optical properties were studied. The ferromagnetic state at low temperature was demonstrated. Most of the grains in the samples will be unblocked when temperature is below 50K. The measured magneto-resistance at 4.8K is higher than 30%. This value is larger than any other reported data. The transport mechanism may come down to a combination of tunnelling conduction with the second-order hopping. Some small peaks on transmittance curves were found, the matter is still open. 相似文献
9.
用射频溅射法制备了FeZrBCu软磁合金薄膜.研究了不同溅射功率对FeZrBCu薄膜软磁特性和巨磁阻抗效应的影响.用电子探针显微镜测量发现,当溅射功率为240W时,薄膜样品中Fe的原子含量为8732%,Cu的原子含量为29%.这种样品的矫顽力最小,为68A/m,饱和磁化强度约为111×1055A/m,软磁性能最佳,巨磁阻抗效应最大,溅态膜在 13MHz最大巨磁阻抗比纵向为17%,横向为11%.重点分析了阻抗的电阻、电感分量及横向有 效磁导率随频率的变化,得到在低频下主要是磁电感
关键词:
铁基合金
薄膜
巨磁阻抗效应 相似文献
10.
Copper phthalocyanine junctions, fabricated by magnetron sputtering and evaporating methods, show multi-polar (unipolar and bipolar) resistance switching and the memory effect. The multi-polar resistance switching has not been observed simultaneously in one organic material before. With both electrodes being cobalt, the unipolar resistance switching is universal. The high resistance state is switched to the low resistance state when the bias reaches the set voltage. Generally, the set voltage increases with the thickness of copper phthalocyanine and decreases with increasing dwell time of bias. Moreover, the low resistance state could be switched to the high resistance state by absorbing the phonon energy. The stability of the low resistance state could be tuned by different electrodes. In Au/copper phthalocyanine/Co system, the low resistance state is far more stable, and the bipolar resistance switching is found. Temperature dependence of electrical transport measurements demonstrates that there are no obvious differences in the electrical transport mechanism before and after the resistance switching. They fit quite well with Mott variable range hopping theory. The effect of A1203 on the resistance switching is excluded by control experiments. The holes trapping and detrapping in copper phthalocyanine layer are responsible for the resistance switching, and the interfacial effect between electrodes and copper phthalocyanine layer affects the memory effect. 相似文献