Comparative study on transport properties of N-, P-, and As-doped SiC nanowires: Calculated based on first principles

According to the one-dimensional quantum state distribution, carrier scattering, and fixed range hopping model, the structural stability and electron transport properties of N-, P-, and As-doped SiC nanowires(N-SiCNWs, P-SiCNWs, and As-SiCNWs) are simulated by using the first principles calculations. The results show that the lattice structure of NSiCNWs is the most stable in the lattice structures of the above three kinds of doped SiCNWs. At room temperature,for unpassivated SiCNWs, the doping effect of P and As are better than that of N. After passivation, the conductivities of all doped SiCNWs increase by approximately two orders of magnitude. The N-SiCNW has the lowest conductivity. In addition, the N-, P-, As-doped SiCNWs before and after passivation have the same conductivity–temperature characteristics,that is, above room temperature, the conductivity values of the doped SiCNWs all increase with temperature increasing.These results contribute to the electronic application of nanodevices.     

GaN氢化物气相外延生长系统的设计与制作

根据GaN氢化物气相外延生长(HVPE)的原理,设计制作了双温区卧式HVPE系统．根据实际生长中出现的问题和CaN样品的测试情况,对系统进行了逐步的调试和改进．     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

High-quality InAlN/GaN heterostructures grown by metal–organic vapor phase epitaxy

We fabricated high-quality InAlN/GaN heterostructures by metal–organic vapor phase epitaxy (MOVPE). X-ray diffraction measurements revealed that InAlN/GaN heterostructures grown under optimal conditions have flat surfaces and abrupt heterointerfaces. Electron mobility from 1200 to 2000 cm²/V s was obtained at room temperature. To our knowledge, this mobility is the highest ever reported for InAlN/GaN heterostructures. We also investigated the relationship between the Al composition and sheet electron density (N_s) for the first time. N_s increased from 1.0×10¹² to 2.7×10¹³ cm⁻² when the Al composition increased from 0.78 to 0.89.     

High resolution X-ray diffraction of GaN grown on Si (1 1 1) by MOVPE

High temperature GaN layers have been grown on Si (1 1 1) substrate by metalorganic vapor phase epitaxy (MOVPE). AlN was used as a buffer layer and studied as a function of thickness and growth temperature. The growth was monitored by in situ laser reflectometry. High resolution X-ray diffraction (HRXRD) revealed that optimized monocrystalline GaN was obtained for a 40 nm AlN grown at 1080 °C. This is in good agreement with the results of morphological study by scanning electron microscopy (SEM) and also confirmed by atomic force microscopy (AFM) observations. The best morphology of AlN with columnar structure and lower rms surface roughness is greatly advantageous to the coalescence of the GaN epilayer. Symmetric and asymmetric GaN reflections were combined for twist and stress measurements in monocrystalline GaN. It was found that mosaicity and biaxial tensile stress are still high in 1.7 μm GaN. Curvature radius measurement was also done and correlated to the cracks observations over the GaN surface.     

Effect of plasma treatment on interface property of BCN/GaN structure

Interface properties of BCN/GaN metal-insulator-semiconductor (MIS) structures are investigated by X-ray photoelectron spectroscopy (XPS) and capacitance versus voltage (C-V) characteristics measurements. The BCN/GaN samples are fabricated by in situ process consisting of plasma treatment and deposition of BCN film in the plasma-assisted chemical vapor deposition (PACVD) apparatus. XPS measurement shows that the oxide formation at the BCN/GaN interface is suppressed by nitrogen (N₂) and hydrogen (H₂) plasma treatment. The interface state density is estimated from C-V characteristics measured at 1 MHz using Terman method. The minimum interface state density appears from 0.2 to 0.7 eV below the conduction band edge of GaN. The minimum value of the interface state density is estimated to be 3.0 × 10¹⁰ eV⁻¹ cm⁻² for the BCN/GaN structure with mixed N₂ and H₂ plasma treatment for 25 min. Even after annealing at 430 °C for 10 min, the interface state density as low as 6.0 × 10¹⁰ eV⁻¹ cm⁻² is maintained.     

A brief semi-quantitative discussion on electrical conductance through resonant states in metallic electrochemical nanowires

Some aspects of electrical conduction through resonant states in metallic electrochemical nanowires are briefly discussed in a semi-quantitative way by means of concepts associated with electron gas, conductance quantization, and Fermi energy level. Aspects related to some experimental data are also discussed.     

一种新化合物K2Ti8O15纳米线

钛酸钾晶须通常是直径和长度在微米量级的无机晶须 ,可用Ｋ2 Ｏ·ｎＴｉＯ2 表示其组成 ,ｎ =1,2 ,4 ,6 ,8,[1] .六钛酸钾晶须具有耐高温、耐腐蚀、纤维拉伸强度高、导热系数小、红外反射率高 ,硬度低的特点 .在民用及工业方面有很多应用 .如催化剂载体、离子吸附交换材料、高温过滤器、绝热材料、耐摩擦材料等[2～ 5] .钛酸钾纳米线的合成尚未见报道 .我们在用电弧产生的Ｎ2 等离子体热解焦油时 ,生成了一种直径 9～ 2 0ｎｍ长约几百纳米线 .Ｘ射线能谱定量分析表明这种纳米线化学组成为Ｋ2 Ｔｉ8Ｏ15,是一种新的非化学计量化合物 .试验装…     

GaN基紫光LED的高反射率p型欧姆接触

研究用于GaN基大功率倒装焊(Flip-chip)紫光LED(UV-LED)的高反射率p型欧姆接触的电学和光学性能。用磁控溅射的方法在GaN基LED外延片表面沉积了不同厚度Ag,Al,Au和Pd四种金属,测量了样品的反射率和透射率。结合同步辐射高强度X射线衍射和AFM对金属薄膜的晶体结构进行分析,并对表面形貌进行了观测,对由金属薄膜构成的多层膜结构及其对光反射率的作用机理进行了研究。测量结果表明,在入射光波长为400nm时,Ni/Au/Ag和Ni/Au/Al电极的反射率比Ni/Au的反射率提高了三倍。同时与p-GaN有良好的欧姆接触特性。     

Study of the structural and optical properties of GaN/AlN quantum dot superlattices

We study GaN/AlN Quantum Dot (QD) superlattices utilizing the STREL environment which allows the building of atomistic models, relaxation of the structures, the calculation of the electronic states and optical transitions and the visualization of the results. The forces are calculated using an appropriate Keating or Stillinger–Weber interatomic potential model and the electronic states and optical transitions using a tight-binding formulation which is economical and produces realistic electronic properties. The relaxed structure has strains mainly in the GaN region which are compressive and small tensile strains in the AlN region, mainly below the QD. In the calculation of the electronic states and of the optical transitions the strains are included realistically at the atomistic level. The study of the wavefunctions close to the fundamental gap show how these strains influence the form and spatial extent of the wavefunction. Very close to the fundamental gap the valence and some conduction states are confined in the QD and have considerable oscillator strength.