微波椭偏法测量不透明材料的厚度

在传统的激光椭偏法测量厚度的基础上,用微波取代激光测量了不透明材料的厚度.分析了偏转角及反射干扰产生的误差,并提出了修正方法.测量结果表明:该方法可以比较精确地测量铝板和塑料板的厚度;由于散射的影响,表面磨砂的有机玻璃板的厚度测量误差很大.     

Evaluation of thermal resistance constitution for packaged A1GaN/GaN high electron mobility transistors by structure function method＊

The evaluation of thermal resistance constitution for packaged A1GaN/GaN high electron mobility transistor （HEMT） by structure function method is proposed in this paper. The evaluation is based on the transient heating measurement of the A1GaN/GaN HEMT by pulsed electrical temperature sensitive parameter method. The extracted chip-level and package-level thermal resistances of the packaged multi-finger A1GaN/GaN HEMT with 400μm SiC substrate are 22.5 K/W and 7.2 K/W respectively, which provides a non-invasive method to evaluate the chip-level thermal resistance of packaged A1GaN/GaN HEMTs. It is also experimentally proved that the extraction of the chip- level thermal resistance by this proposed method is not influenced by package form of the tested device and temperature boundary condition of measurement stage.     

Effect of substrate temperature on microstructure and optical properties of single-phased Ag20 film deposited by using radio-frequency reactive magnetron sputtering method

Using a radio-frequency reactive magnetron sputtering technique, a series of the single-phased Ag20 films are deposited in a mixture of oxygen and argon gas with a flow ratio of 2：3 by changing substrate temperature （Ts）. Effects of the Ts on the microstructure and optical properties of the films are investigated by using X-ray diffractometry, scanning electron microscopy and spectrophotometry. The single-phased Ag20 films deposited at values of Ts below 200℃ are （111） preferentially oriented, which may be due to the smallest free energy of the （111） crystalline face. The film crystallization becomes poor as the value of Ts increases from 100℃ to 225℃. In particular, the Ag20 film deposited at Ts=225℃ loses the （111） preferential orientation. Correspondingly, the film surface morphology obviously evolves from a uniform and compact surface structure to a loose and gullied surface structure. With the increase of Ts value, the transmissivity and the reflectivity of the films in the transparent region are gradually reduced, while the absorptivity gradually increases, which may be attributed to an evolution of the crystalline structure and the surface morphology of the films.     

带孔片状不良导体导热系数测试方法探究

推导出稳态法测量带孔片状不良导体导热系数的适用公式,并采用有效的方法对光盘进行了测试分析.     

验证辐射强度与距离平方反比率的实验

利用Nal闪烁谱仪测量了在探测器与放射源间某个距离下对应的计数率.对测量的数据分别利用等精度最小二乘法和未知参数逼近法进行了处理,观察到在某些未知参数下,最小二乘法引起的误差很大,利用未知参数逼近法得到的值能和真实值较好接近,从而验证了辐射强度与距离平方反比率.     

扭摆法测物体转动惯量的不确定度分析

扭摆法是测量物体转动惯量的有效方法,其不确定度分析是关键.本文推导了扭摆法测物体转动惯量准确的不确定度传递公式,得到各直接测量量及其不确定度对转动惯量不确定度的影响.并进行了算例分析.结果表明,扭摆法比三线摆测得物体的转动惯量的误差以及不确定度要小很多.这对实验方法的选择和仪器的研制具有重要的实际意义.     

调强放射治疗子野权重优化方法研究

由于子野分割带来的误差, 使得调强放疗(Intensity Modulated Radiation Therapy, 简称IMRT)计划系统所制作的计划往往不能满足临床要求。 本研究将采用基于共轭梯度法的子野权重优化方法来减小此误差, 提高制作计划的效率和效果。 采用共轭梯度法优化子野权重和微调子野形状, 最终使得子野分割前后强度误差最小。 在精确放疗系统中对常见的临床病例（鼻咽癌和周围性肺癌）进行测试, 通过对比靶区和危及器官的剂量体积直方图以及CT片上的等剂量线, 发现子野权重优化后靶区的平均剂量分别从87.0%提高到100.2%和从90.0%提高到98.4%, 更好地满足临床要求。     

不良导体导热系数与温度关系研究

采用稳态平板法测量不良导体的导热系数时,关键是得到稳态时不良导体的传热速率。根据稳态时传热速率与散热铝盘的散热速率相等,可以测定自然冷却过程中,稳态时散热铝盘温度T2所对应的冷却速率。基于Matlab软件,分析并绘制曲线直观反映出温度、时间、冷却速率三者之间的关系,用拟合法研究了不良导体导热系数随温度变化的关系。     

无约束优化的一个充分下降共轭梯度算法

在修正PRP共轭梯度法的基础上,提出了求解无约束优化问题的一个充分下降共轭梯度算法,证明了算法在Wolfe线搜索下全局收敛,并用数值实验表明该算法具有较好的数值结果.     

一类四阶变系数振动问题的复合解

以一类斜拉索模型为背景,讨论了一类四阶变系数振动问题.用匹配法导出了方程的复合解,从而较简捷地得出了一类斜拉索的振幅的渐近表达式,并为解决相关类型的变系数问题提供了一种有效的方法.