框架结构主动控制最优时滞研究

在结构振动主动控制中,时滞的大小对结构控制能量和响应均产生影响。在允许时滞的范围内,把结构控制能量和响应作为目标函数,数值仿真发现目标函数随着时滞的变化呈现曲线状态,这说明存在最优时滞。在目标函数处理方面,考虑到控制能量和响应数量级不一致,本文采用了无量纲化处理。同时,考虑到地震波的随机性,本文还推导了含控制力的改进的随机Newmark方法。最后给出了一个计算实例。实例表明本文所提出的方法是有效的。     

钢框架中组合楼盖的面内变形

为了研究影响钢-混凝土组合框架中组合楼盖隔板性能的因素,以楼板厚度、框架侧移刚度以及结构平面刚度布置为参数对钢框架中的组合楼盖进行了弹性有限元分析．分析结果表明,除长宽比外,组合楼盖的隔板性能还与其面内刚度以及支撑体系的特性有关．根据分析结果提出了组合楼盖隔板性能的评价方法, 并与试验结果进行了验证．该方法可以为工程实践中评价组合楼盖的隔板性能作参考．     

Side Information Generation Scheme Based on Coefficient Matrix Improvement Model in Transform Domain Distributed Video Coding

In order to effectively improve the quality of side information in distributed video coding, we propose a side information generation scheme based on a coefficient matrix improvement model. The discrete cosine transform coefficient bands of the Wyner–Ziv frame at the encoder side are divided into entropy coding coefficient bands and distributed video coding coefficient bands, and then the coefficients of entropy coding coefficient bands are sampled, which are divided into sampled coefficients and unsampled coefficients. For sampled coefficients, an adaptive arithmetic encoder is used for lossless compression. For unsampled coefficients and the coefficients of distributed video coding coefficient bands, the low density parity check accumulate encoder is used to calculate the parity bits, which are stored in the buffer and transmitted in small amount upon decoder request. At the decoder side, the optical flow method is used to generate the initial side information, and the initial side information is improved according to the sampled coefficients by using the coefficient matrix improvement model. The experimental results demonstrate that the proposed side information generation scheme based on the coefficient matrix improvement model can effectively improve the quality of side information, and the quality of the generated side information is improved by about 0.2–0.4 dB, thereby improving the overall performance of the distributed video coding system.     

Stress memory polymers

Like shape memory polymers, a novel phenomenon of stress memory was shown in which the stress of a material can respond to an external stimulus. This concept was further enlightened by a switch‐spring‐frame model that would eliminate the limitation of existing models which overlooked the stimulus responsive nature of such polymers. The discovery being reported in this article was stemmed from a real case study into shape memory polymer fibers in compression stocking for varicose veins. The breakthrough of stress memory enabled researchers to develop applications needing stimuli‐responsive forces, which can broaden the horizon of such smart polymers in emerging smart products in many multidisciplinary fields such as sensors, stress garments, and massage devices, electronic skins, and artificial muscles. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 893–898     

A 3D mesh deformation technique for irregular in‐flight ice accretion

Aircraft holding around busy airports may be requested to sustain as much as 45 min of icing before landing or being diverted to another airport. In this paper, a three‐dimensional mesh deformation scheme, based on a structural frame analogy, is proposed for the numerical simulation of ice accretion during extended exposure to adverse weather conditions. The goal is to provide an approach that is robust and efficient enough to delay or altogether avoid re‐meshing while preserving (enforcing) nearly orthogonal elements at the highly distorted ice surface. Robustness is achieved by suitably modifying the axial and torsional stiffness components of the frame elements in order to handle large and irregular grid displacements typical of in‐flight icing. Computational efficiency is obtained by applying the mesh displacement to an automatically selected small subset of the entire computational domain. The methodology is validated first in the case of deformations typical of fluid‐structure interaction problems, including wing bending, a helicopter rotor in forward flight, and the twisting of a high‐lift wing configuration. The approach is then assessed for aero‐icing on two swept wings and compared against experimental measurements where available. Copyright © 2015 John Wiley & Sons, Ltd.     

Tb-MOFs在荧光检测方面的研究进展

镧系离子特殊的电子排布使镧系有机骨架材料（Ln-MOFs）具有独特的发光性质,通过骨架和不同客体分子间的相互作用,可实现对诸多物质的荧光检测。其中,以铽离子（Tb3+）为中心构筑的Tb-MOFs具有更优良的光学性能和更高的检测灵敏度,是一种极具潜力的高效荧光探针。本文以稀土Tb3+为主线,综述了近年来国内外Tb-MOFs材料在阴阳离子、有机小分子、生物分子荧光检测方面的研究进展,并对未来发展趋势进行了展望。     

Weak type heterodimensional cycle bifurcation with orbit-flip

In this paper, we study the weak type heterodimensional cycle with orbit-flip in its non-transversal orbit by using the local moving frame approach. For the first two subcases, we present the sufficient conditions for the existence, uniqueness and non-coexistence of the homoclinic orbit, heteroclinic orbit and periodic orbit. Based on the bifurcation analysis, the bifurcation surfaces and the existence regions are located. And for the third subcase, we theoretically established both the coexistence conditio...     

某一类控制系统中发生的指数偏差现象

我们考虑在某类控制系统中,以Lyapunov指数作为观测量,远离给定遍历测度的那些周期测度.对于这类周期测度的数量关于周期的指数增长率,我们将用测度熵在某个集合上的上界给出它的一个上限控制.     

关于Parseval框架小波的刻画

In this paper,we characterize all generalized low pass filters and MRA Parseval frame wavelets in L 2 （R n ） with matrix dilations of the form （Df）（x） =√ 2f（Ax）,where A is an arbitrary expanding n × n matrix with integer coefficients,such that ｜det A｜ = 2.We study the pseudo-scaling functions,generalized low pass filters and MRA Parseval frame wavelets and give some important characterizations about them.Furthermore,we give a characterization of the semiorthogonal MRA Parseval frame wavelets and provide several examples to verify our results.