Experimental investigation of supersonic radiation propagation in low-density plastic and copper-doped foams

1 Introduction The investigation of supersonic radiation wave transporting in low density foam pro-duced by thermal radiation is of crucial importance in inertial confinement fusion (ICF) research[1]. When the intense radiation flux is incident in the media, first, a supersonic heat wave is formed which propagates into the undisturbed material. In time, due to the increasing mass of heated material, it slows down and is overtaken by a shock wave,thus becoming of the ablative type. Normally, …     

MgB2超导薄膜的微波测量

报道了利用蓝宝石介质谐振器技术测量MgB2超导薄膜的微波表面电阻Rs、OK时的穿透深度λ(O)和超导能隙△(O)．λ(O)和△(O)的值是通过先测量样品穿透深度λ(T)的变化量△λ(T)，然后由BCS理论模型拟合△λ（T)的实验数据得到的．测试样品是利用化学气相沉积技术在MgO(111)基片上制备的c轴织构的MgB2超导薄膜，薄膜的超导转变温度和转变宽度分别为38K和0．1K．微波测试结果表明在10K，18GHz下MgB2薄膜的Rs约为100μΩ，可以和高质量的YBCO薄膜的Rs值相比拟；BCS理论拟合得到的MgB2超导薄膜的λ(0)=102nm，△(0)：1．13kTc．     

~2样本深度的基本性质

本文讨论由L2深度修正得到的L2深度相应的样本深度的性质,得到了样本深度的相合性和渐近正态性,并证明了它在任意紧集上的一致相合性．最后,基于上述性质简要讨论了样本深度等高的一些性质．     

机载海洋激光测深系统参量设计与最大探测深度能力分析

详细讨论了机载海洋激光测深系统最大测量深度与相关因子之间的关系，并利用最小可探测信噪比为判据，对机载海洋激光测深系统在白天和晚上工作进行了数值模拟，通过比较最大测量深度与激光脉冲峰值功率、接收视场角、接收口径和光谱接收带宽等关系，确定了系统的主要参量。以确定的参量建立的系统具有白天49m和晚上65m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要求。     

Quantitative Depth Profiling of K-Doped Fullerene Films Using XPS and SIMS

 Phenomena accompanying electrochemical doping of solid fullerene films with potassium were studied by sputter ion depth profiling (XPS and SIMS). The potassium distribution was determined, and artifacts associated with possible damage of the layer composition caused by ion impact were investigated and discussed. To compare the charge transfer while reductive doping is taking place at fullerene/solution interface with doping from gas phase, model layers were prepared and doped by potassium under UHV conditions. It was found that sputtering by Ar⁺ primary ions yields both accurate information on the alkaline metal distribution and on its concentration. Sputtering by O⁺ ions led to an enrichment of potassium, apparently due to the reactivity of oxygen with the fullerene matrix. It is shown that the reductive doping starts at the fullerene/solution interface. The concentration of potassium in the doped films was found to be lower than expected from the charge transferred during the electrochemical reduction. Other phase transformations such as hydrogenation are discussed. Received March 4, 2002; accepted July 26, 2002     

动态柱形空穴膨胀模型及其在侵彻问题中的应用

 在侵彻问题中的应用进行了研究。通过采用相似变换求解塑性区控制方程，获得了动态柱形空穴膨胀中的弹塑性界面速度、径向应力分布、空穴表面应力的解。基于柱形空穴模型，推导了侵彻方程，并将其得到的预测结果与侵彻实验数据进行了比较。结果表明，模型的理论解与现有数据吻合得很好。 结果还显示了材料的可压缩性和塑性强化模量对柱形空穴膨胀以及侵彻阻力的影响。     

新型显微成像光谱仪系统中线阵针孔离焦研究

显微成像光谱仪技术是最近新兴的一种生物组织检测方法,它可以广泛应用在生物医学检测,疑难病症分析、预防、诊断中,已经成为当今生物组织检测领域研究的热点。提出了一种新型的基于线阵针孔阵列的激光扫描共焦显微成像光谱仪系统LP-LSCMIS方案,介绍了其工作原理及优点,讨论了该装置中线阵针孔阵列离焦对系统性能的影响,分析了离焦对生物组织荧光图像的光谱分辨和自体荧光光谱的调制深度的影响。推导出了光谱分辨和调制深度与离焦量的关系式。结果表明,离焦对仪器的性能有较大的影响,因此在装置装调时要求有更高精度的调整机构。     

3D HYBRID DEPTH MIGRATION AND FOUR-WAY SPLITTING SCHEMES

The alternately directional implicit （ADI） scheme is usually used in 3D depth migration. It splits the 3D square-root operator along crossline and inline directions alternately. In this paper, based on the ideal of data line, the four-way splitting schemes and their splitting errors for the finite-difference （FD） method and the hybrid method are investigated. The wavefield extrapolation of four-way splitting scheme is accomplished on a data line and is stable unconditionally. Numerical analysis of splitting errors show that the two-way FD migration have visible numerical anisotropic errors, and that four-way FD migration has much less splitting errors than two-way FD migration has. For the hybrid method, the differences of numerical anisotropic errors between two-way scheme and four-way scheme are small in the case of lower lateral velocity variations. The schemes presented in this paper can be used in 3D post-stack or prestack depth migration. Two numerical calculations of 3D depth migration are completed. One is the four-way FD and hybrid 3D post-stack depth migration for an impulse response, which shows that the anisotropic errors can be eliminated effectively in the cases of constant and variable velocity variations. The other is the 3D shot-profile prestack depth migration for SEG/EAEG benchmark model with two-way hybrid splitting scheme, which presents good imaging results. The Message Passing Interface （MPI） programme based on shot number is adopted.     

An effect of residual gas component on detected secondary ions during TOF‐SIMS depth profiling and a method to estimate contained component

With regard to Secondary Ion Mass Spectroscopy (SIMS) measurement of atmospheric gas elements, a problem occurs that the detected signal includes background components caused by residual gas along with contained components. Relating to this issue, an available method to quantify the contained components by separating the background ones had been established for Dynamic SIMS. Time‐of‐Flight SIMS with sputtering ion gun has also applied for depth profiling as well as Dynamic SIMS. However, few studies have attempted to investigate the secondary ion behavior of the atmospheric gas elements for depth profiling by Time‐of‐flight SIMS, especially for low concentration levels. In this study, experimental examinations of the secondary ions of the atmospheric gas elements, such as oxygen, hydrogen, and carbon in the silicon substrate, has been conducted in various analytical conditions of TOF‐SIMS depth profiling mode. Under the analytical conditions of our study, it has been proved that the background intensity of these elements was correlated to the sputtering rate. For the analysis of Floating Zone Silicon substrate, the oxygen intensity of the background component was proportional to the inverse number of the sputtering rate. Based on these facts, the total detected intensity of the atmospheric gas elements was able to be separated into the contained components and background ones by changing the sputtering rate during TOF‐SIMS measurement. An experimental result has shown that the contained oxygen concentration in the Czochralsk Silicon substrate estimated by the “TOF‐SIMS Raster Change Method” has successfully agreed with the result by the Dynamic SIMS.     

带有波前编码板的虹膜采集光学系统的设计

设计了一款采用波前编码技术的虹膜采集光学系统,以实现大景深、自然非约束状态下的成像.以传统的光学系统评价指标斯特利尔比和能量集中度作为波前编码系统的成像特征,利用ZEMAX软件对波前编码系统进行设计,权衡了离焦不敏感性和图像可恢复性.比较了带有立方相位编码板和带有修正项的立方相位编码板的虹膜采集系统以及传统系统的焦深延拓效果.发现采用立方相位编码板的虹膜采集光学系统的焦深延拓效果最佳,其焦深是传统系统的8倍.该系统增大了虹膜采集的距离,对于自然状态虹膜成像系统设计有一定的参考价值.