Static and dynamic analysis of side-mode suppression of widely tunable sampled grating DBR (SG-DBR) lasers

Side-mode suppression is an important issue for widely tunable laser design and applications. In this paper, we have developed a relatively simple algorithm to analyze side-mode suppression of widely tunable sampled grating distributed Bragg reflector (SG-DBR) lasers by using the Transfer Matrix Method (TMM) in combination with multimode rate equations. The dependence of gain spectrum on wavelength is also included in this model, and its effects on tuning characteristics of the devices are investigated for the first time. Static tuning characteristics and dynamic behaviors of wavelength switching are simulated. Results agree well with the experimental results reported.     

Growth and photorefractive properties of near-stoichiometric In:Fe:Cu:LiNbO3 crystals

The near-stoichiometric LiNbO₃ crystal co-doped with In₂O₃, Fe₂O₃, and CuO has been grown from a Li-rich melt (Li/Nb = 1.38, atomic ratio) by the Czochralski method in air atmosphere for the first time. The OH⁻ absorption spectra were characterized to investigate the structure defects of the crystals. The appearance of the 3506 cm⁻¹ absorption peak manifests that the composition of the grown crystal is close to the stoichiometric ratio. The photorefractive properties were also measured by the two-wave coupling experiments. The results show that the near-stoichiometric In:Fe:Cu:LiNbO₃ crystal has a larger refractive index change, higher recording sensitivity and larger two-wave coupling gain coefficient than those obtained in the congruent In:Fe:Cu:LiNbO₃ crystal under the same experimental conditions. The material of near-stoichiometric In:Fe:Cu:LiNbO₃ crystal is a promising candidate for blue photorefractive holographic recording.     

Triaxial rotation in atomic nuclei

The Projected Shell Model has been developed to include the spontaneously broken axial symmetry so that the rapidly rotating triaxial nuclei can be described microscopically. The theory provides an useful tool to gain an insight into how a triaxial nucleus rotates, a fundamental question in nuclear structure. We shall address some current interests that are strongly associated with the triaxial rotation. A feasible method to explore the problem has been suggested.     

关于第n布里渊区体积等于倒格子原胞体积的证明

通过证明Wigner-Seitz原胞的体积等于原胞体积,说明第一布里渊区体积等于倒格子原胞体积;对于第n布里渊区和第n-1布里渊区建立保长同胚映射证明两者体积相等.     

卡塞格伦光学天线偏轴及性能分析

设计了具有抛物面结构的卡塞格伦光学天线.通过对偏轴下的卡塞格伦光学天线系统的分析,得到了不同偏转角所对应的接收光斑面积表达式和功率衰减曲线.讨论了偏轴下的接收天线增益与波长及偏转角的关系,仿真出在偏轴与轴对准两种情形下的增益曲线.仿真结果表明,〖JP2〗最大偏轴比轴对准情形增益降低了6.564dB.最后分别针对轴对准与某种偏轴情形下的系统做了光斑测试实验与天线耦合效率测试实验.结果为：偏轴下天线耦合效率降低了26.966%.这些研究为星间光通信中控制系统实现光轴的精确对准提供了理论依据,具有重要的实用价值 关键词： 偏轴 卡塞格伦光学天线 偏转角 增益     

强超短脉冲抽运下半导体光放大器中的非线性过程

建立了包含载流子浓度脉动(CDP)、自由载流子吸收(FCA)、受激辐射(SE)、双光子吸收(TPA)、光谱烧孔(SHB)和超快非线性折射(UNR)过程的半导体光放大器(SOA)理论模型,通过与已报道的实验结果的比较对模型进行了验证,实现了对已有 SOA模型的修正,并对UNR,FCA和TPA效应对强超短光脉冲传输特性的影响进行了分析.当脉宽为几个皮秒的强光脉冲注入工作于透明电流下的SOA时,其强度特性主要受FCA和TPA效应的影响.由于加入了FCA效应,使模型对200fs脉冲强度传输特性的仿真结果与实验结果 关键词： 非线性过程 强超短光脉冲 SOA理论模型 增益透明     

有气流扰动下管流油水混合物粘度实验测量与计算模型

采用局部即时取样方法对水平管内油气水三相流动情况下各种混合比例的复杂混合物的流动粘度进行了实验研究,实验工质采用46号机械油、自来水和空气。以实验数据为基础提出了考虑流动参数变化影响的反相点预测关联式。考虑到管内油水两相的混合发展过程,以局部即时取样的实验数据为基础,提出了一个气流扰动下管内流动条件下油水混合物粘度的预测关系式,该模型考虑了油水两相本身的物性以及流动因素的影响。指出考虑流动参数影响的粘度预测模型能大大提高油气水三相流动情况下油水混合物实测粘度的预测精度。     

基于半导体激光器的全光波长转换的理论研究

全光波长转换是全光网络的关键技术之一。利用多模半导体激光器的速率方程,建立了基于半导体激光器的全光波长转换器的理论模型,该模型不仅考虑了注入信号光对激光腔内载流子的消耗,而且考虑了激光腔对注入信号光的放大作用。利用该模型分析了半导体激光器工作电流、注入信号光功率以及码率各参数对波长转换特性的影响。结果对于确定基于半导体激光器的全光波长转换器件的最佳工作条件有一定的参考价值。     

光纤参量放大饱和增益特性研究

通过数值分析的方法推导出光纤参量放大饱和信号增益和信号输出功率的数学表达式.计算分三步, 首先数值求解描述参量放大过程的非线性耦合方程得出一系列数值, 然后用控制变量法找到饱和信号增益的函数形式, 最后用最小二乘法拟合出系数（与数字积分结果比较, 最大相对误差不超过0.46‰）.同样也得出了饱和信号输出功率的表达式.计算结果与已有实验结果相吻合.     

带有锥形增益区14xxnm量子阱激光器的研制

利用MOCVD生长了14xxnm AlGaInAs/AlInAs/InP应变量子阱外延片.采用带有锥形增益区脊型波导结构和普通条形脊型波导结构在相同的实验条件下制作800 μm腔长激光器管芯,在相同的驱动电流下前者可以获得更高的输出光功率,而且P-Ⅰ曲线线性度较好、饱和电流高. 1200 μm腔长带有锥形增益区脊型波导结构管芯功率达到500 mW,饱和电流3 A以上,峰值波长1460 nm,远场发散角为39°×11°.