Second order effects in an elastic half-space acted upon by a non-uniform normal load

A closed form solution to the second order elasticity problem, when an isotropic compressible elastic half-space undergoes a deformation owing to a non-uniformly distributed normal load, is presented. The method of integral transform is employed and the case when loading is distributed, in accordance with Hertz's law, is discussed. The limiting solution for incompressible isotropic elastic material is also derived. Numerical calculations for the second order elastic material for the displacement and the normal stress in thez-direction are carried out. It is found that, in comparision to the linear elastic case, the displacement increases and the normal stress decreases in the second order elastic material

---

Sommario Si presenta una soluzione del secondo ordine in forma chiusa del problema di un semi-spazio elastico isotropo compressibile soggetto a un carico normale distribuito non uniformemente, ottenuta mediante il metodo delle trasformate integrali. Si discute il caso del carico distribuito secondo la legge di Hertz; si deriva anche la soluzione limite per materiale elastico isotropo incompressibile. Si ottengono numericamente alcuni risultati relativi a spostamenti e tensioni normali nella direzione z: si trova che, a paragone del caso elastico lineare, gli spostamenti aumentano e le tensioni diminuiscono nel materiale elastico del secondo ordine.

     

STOCHASTIC MODELLING OF FATIGUE CRACK GROWTH UNDER CONSTANT AMPLITUDE LOADING

Two stochastic models of fatigue crack growth under constant amplitude cyclic loadingare proposed and studied by using the stochastic averaging method and total probability theorem to ac-count for high frequency component and low frequency component, respectively, of the irregular na-ture of fatigue crack growth observed in Virkler's experiment. Particular attention is paid to the predic-tion performance of the models under a change in the initial crack length. It is shown that the modelsproposed in the present paper yields better agreement with experimental data than other models avail-able in literature.     

不同边界条件正交各向异性中厚板的振动与稳定分析

本文采用高阶剪切变形理论对正交各向异性中厚矩形板进行振动与稳定分析,数值计算采用样条有限点法,得出了六种不同边界条件矩形板的自振频率和屈曲载荷,并与相应的经典板理论的结果进行比较.结果说明横向剪切变形对复合材料层合板的影响与板的各向异性程度、板的宽厚比(b/h)、层合板的层数和板的支承条件有关,它随着层合板各向异性程度的增加而增加,随着层合板宽厚比的增加而逐渐消失.     

水工混凝土S-N和P-S-N曲线特性研究

在已知混凝土静压强度分布的基础上使用S－N曲线模型推导出一种疲劳寿命满足的分布，并对水工混凝土做了大量的等幅抗压疲劳试验。通过分析发现，实验数据能较好地符合该分布，同时得出了该种混凝土的S－N曲线和P－S－N曲线。     

A new photoelastic model for studying fatigue crack closure

The photoelastic analysis of crack tip stress intensity factors has been historically developed for use on sharp notches in brittle materials that idealize the cracked structure. This approach, while useful, is not applicable to cases where residual effects of fatigue crack development (e.g., plasticity, surface roughness) affect the applied stress intensity range. A photoelastic model of these fatigue processes has been developed using polycarbonate, which is sufficiently ductile to allow the growth of a fatigue crack. The resultant stress field has been modeled mathematically using the stress potential function approach of Muskhelishvili to predict the stresses near a loaded but closed crack in an elastic body. The model was fitted to full-field photoelastic data using a combination of a generic algorithm and the downhill simplex method. The technique offers a significant advance in the ability to characterize the behavior of fatigue cracks with plasticity-induced closure, and hence to gain new insights into the associated mechanisms.     

静载荷作用下柔韧圆板的大幅度振动

本文首先给出了均布载荷作用下柔韧圆板的大幅度振动方程，按文中给出的时间模态假设导了该问题的非线性耦合的代数和微分特征方程组，利用修正迭代法求出了该方程组的近似解析解，得到了柔韧圆振动的幅频－载荷特征关系，讨论了静载荷对其振动性态的影响。     

爆炸载荷作用下地下拱形结构动态分析

应用有限元方法分析了爆炸载荷作用下地下拱形结构与土介质的动力相互作用问题。结构与介质均假定为弹塑性，并用Ｍｉｓｅｓ屈服准则描述，且考虑其几何非线性的影响。使用了人为阻尼边界，并使计算模型的几何尺寸满足限制性条件，从而大大提高了计算精度。还对几种解进行了比较，对影响结构应力场的因素也进行了讨论。     

平面刚架弹塑性大位移分析的多刚体离散元法

本文基于多刚体－弹簧系统模型，给出了求解平面刚架结构弹塑性、大位移极限承载力分析的多刚体离散元法。文中首先推导了多刚体离散元法在总体坐标下的切线刚度阵，建立多刚体离散元法的增量平衡方程；而后推导了多刚体离散元的弹塑性弹簧系数矩阵，建立了多刚体离散元内力屈服面塑性铰法的增量求解格式，成功地进行了平面钢框架的弹塑性、大位移极限承载力分析。计算结果与其他数值方法或实验结果吻合良好，显示了多刚体离散元方法进行结构极限承载力分析这一复杂问题的优越性     

吊车荷载作用下钢结构吊车梁的疲劳可靠寿命评估

从Miner累积损伤的定义出发，视累积损伤为随机过程，临界损伤为随机变量，基于疲劳动态可靠性理论，提出了在役钢结构吊车梁疲劳剩余寿命的可靠寿命评估法。之后与现行《钢结构检测评定与加固技术规程》(YB9257-96)中安全期限寿命评估法进行了分析比较，说明了安全寿命评估方法的概率意义。算例分析结果表明，本文提出的可靠寿命评估方法更加合理。     

Optimum Gas Journal Bearing with Open Bearing Ends and Feeder Slot

The optimum design of the cylindrical outer contours of a gas journal bearing is obtained using the methods of the calculus of variations with allowance for the lubricant leakage through the bearing ends and the feeder slot when the lubricant mass in the working gap is conserved. The variational problem of designing the clearance shape giving the maximum bearing load capacity is formulated and solved. A modified Elrod-Burgdorfer condition for the pressure is used.