聚(St-DVB)型整体柱的制备及其对蛋白质的色谱分离性能

苯乙烯(St)为单体,二乙烯基苯(DVB)为交联剂,在致孔剂甲苯和十二醇存在下,直接以Ф4.6×50mm色谱柱管为模具,同时在整个反应过程中通过氩气对反应混合物施加一个恒定的压力,通过原位聚合制备了聚(苯乙烯-二乙烯基苯)(PSD)型整体柱。在聚合过程中对反应混合物施加一定的压力,使制备的整体柱表面光滑无凹痕现象,并且使柱子的两头平整不凹陷,有利于提高柱效。本文对整体柱的孔结构及其对蛋白质的分离性能进行了研究。实验结果表明,整体柱内部含有大量类似渠道的大孔,孔径为2μm~3μm,在流速为5ml/min时,背压为7MPa。而且流速对色谱分离效率的影响小,流速从1ml/min增大到3ml/min时,牛血清白蛋白和溶菌酶这两种蛋白质的总分离效能指标K1的值基本保持不变,保持在3.35左右,说明可以通过提高流速实现蛋白质的快速分离。     

Carboxylation of styrene in the N(C4H9)4Br—heptane system

The carboxylation of styrene into carboxylic acids in the N(C₄H₉)₄Br—heptane system in the presence of phosphine complexes and palladium acetate was studied. In the absence of phosphine, the Pd catalyst seems to be stabilized in solution by forming anionic complexes with NBu₄Br; the stabilization depends on the acidity of the reaction medium. The catalytic system can be used repeatedly, its activity being reduced only slightly.__________Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 11, pp. 2458–2461, November, 2004.     

Complete Oxidation of Methane over Palladium Supported on Alumina Modified with Calcium,Lanthanum,and Cerium Ions

The activity and thermal stability of Pd/Al_2O_3 and Pd/(Al_2O_3 MO_x)(M=Ca,La,Ce) palladium catalysts in the reaction of complete oxidation of methane are presented in this study.The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide.Then they were impregnated with palladium nitrate solution.The catalysts with unmodified alumina had a high surface area.The activity and thermal stability of the alumina- supported catalyst was also very high.The introduction of calcium,lanthanum,or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method.These modifiers decreased the activity of palladium catalysts,and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al_2O_3.The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.     

从α－蒎烯直接催化酯化高选择性地合成乙酸正龙脑酯的研究－催化剂与反应机理初探

本文提出了新的硼酸类催化剂体系ＨＢ，用该体系对α－蒎烯与无水乙酸相互作用直接合成乙酸正龙脑酯作了较系统的研究。反应得到两种系列产物－酯化产物和异构化产物，酯化产物主要是乙酸正龙脑酯，葑醇酯和松油酯，异构化产物主要是莰烯、烯和松油烯等，总酯化产率为５０％以上，其中乙酸正龙脑酯为２０％以上，是至今从α－蒎烯直接合成乙酸正龙脑酯的最好结果。通过对产物的￣１ＨＮＭＫ图谱分析及动力学考察，确证反应主产物是正龙脑酯而不是异龙脑酯。文章对Ｈ＿２ＳＯ＿４、ＨＣｌＯ＿４、多聚磷酸（ＰＰＡ）和杂多酸（１２－磷钨酸）等催化剂进行了实验考察、对比和评述，表明了自制的ＨＢ催化剂体系具有高选择性合成乙酸正龙脑酯的显著优点，并对其反应机理作了初步探讨。     

Surface solid-state interactions in copper-nickel-cement catalysts for hydrogenation of oxygen

The surface phase composition of alumocalcium cement-supported CuO and CuO-NiO catalysts prepared by chemical mixing has been studied using the method of thermo-vacuum curves of electric conductivity. The deactivation of these catalysts due to overheating to 800 °C under conditions of hydrogenation of oxygen is rationalized by the partial extraction of CuO (and NiO) from the stabilizing structure of the support solid solutions and by sintering of the extracted oxides and the reduced metallic phase. Complete regeneration of the CuO-NiO-talum catalysts can be achieved if a considerable amount (20%) of copper hydroxocarbonate is added.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1559–1562, September, 1994.     

The high-temperature durability of Rh-free threeway catalysts used for automoble emission control

The high-temperature durability of cordierite honeycomb Rh-free three-way catalysts (TWC) containing additives has been studied by calcining catalysts at various temperatures in the interval of 600≈1100°C. The three-way performances of these catalysts were evaluated for the reaction of carbon monoxide(CO), hydrocarbon(HC) and nitrogen oxides(NOx) at given conditions by using a fixed bed reactor. The results show that after Rh-free TWC are thermally aged in air at 1100°C for 5h and 950°C for 104 h, the TWC still have better three-way activity compared with Rh-containing TWC.     

固体磷酸催化剂的活性相

研究了固体磷酸催化剂活性与其自由磷酸聚合态及磷酸硅晶型的关系，指出高活性磷酸催化剂应具备的条件，即自由磷酸中应为正磷酸和焦磷酸的混合物，结合态磷应具有“Ｃ”晶型。     

New stage in living cationic polymerization: An array of effective Lewis acid catalysts and fast living polymerization in seconds

Our recent extensive research on Lewis acid catalysts with a weak base for the cationic polymerization of vinyl ethers led to unprecedented living reaction systems: fast living polymerization within 1–3 s; a wide choice of metal halides containing Al, Sn, Fe, Ti, Zr, Hf, Zn, Ga, In, Si, Ge, and Bi; and heterogeneously catalyzed living polymerization with Fe₂O₃. The use of added bases for the stabilization of the propagating carbocation and the appropriate selection of Lewis acid catalysts were crucial to the success of such new types of living polymerizations. In addition, the base‐stabilized living polymerization allowed the quantitative synthesis of star‐shaped polymers with a narrow molecular weight distribution via polymer‐linking reactions and the precision synthesis and self‐assembly of stimuli‐responsive block copolymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 1801–1813, 2007.     

CeO2-ZrO2-Y2O3对Pt-Rh型三效催化剂性能的影响

采用共沉淀法技术制备了Ce0.35Zr0.55Y0.10固溶体,并对其进行了比表面积、储氧量的测试和XRD的表征.将其用于低贵金属Pt-Rh型三效催化剂的制备,考察了CeO2-ZrO2-Y2O3对三效催化剂性能的影响.结果表明,Ce0.35Zr0.55Y0.10具有与Ce0.50Zr0.50O2相似的立方结构和相近的储氧量,经高温(1000 ℃)后仍能保持较大的比表面积(38.66 m2·g-1).和含Ce0.50Zr0.50O2的三效催化剂相比,含CeO2-ZrO2-Y2O3的三效催化剂经高温老化后,C3H8,CO,NO仍具有较高的转化率和较低的起燃温度.     

Polymerised bicontinuous microemulsions as stationary phases for capillary electrochromatography

Summary Polymerisation of bicontinuous microemulsions yields porous monolithic structures with well defined pore sizes that are potentially suitable for use as stationary phases for capillary electrochromatography (CEC). A variety of pore sizes can be achieved by altering the composition of the microemulsion, which typically consists of butyl methacrylate (BMA) and ethylene glycol dimethacrylate (EGDMA) as the polymerisable oil phase. The aqueous phase consists of water, a surfactant (sodium dodecyl sulphate, SDS) and a co-surfactant (1-propanol). 2-acrylamido-2-methyl-1-propane sulfonic acid (AMPS) is also added to provide charges along the polymer backbone to allow electroosmotic flow (EOF) to occur. SEM analysis shows that in-situ polymerisation yields a monolithic structure with a porous topography. Investigations have shown that these monoliths are easy to prepare, robust and suitable for the separation of phthalates. They generate higher linear velocities than are achieved using the silica based HPLC packings normally used for CEC.