Biogenic aldehyde determination by reactive paper spray ionization mass spectrometry

Ionization of aliphatic and aromatic aldehydes is improved by performing simultaneous chemical derivatization using 4-aminophenol to produce charged iminium ions during paper spray ionization. Accelerated reactions occur in the microdroplets generated during the paper spray ionization event for the tested aldehydes (formaldehyde, n-pentanaldehyde, n-nonanaldehyde, n-decanaldehyde, n-dodecanaldehyde, benzaldehyde, m-anisaldehyde, and p-hydroxybenzaldehyde). Tandem mass spectrometric analysis of the iminium ions using collision-induced dissociation demonstrated that straight chain aldehydes give a characteristic fragment at m/z 122 (shown to correspond to protonated 4-(methyleneamino)phenol), while the aromatic aldehyde iminium ions fragment to give a characteristic product ion at m/z 120. These features allow straightforward identification of linear and aromatic aldehydes. Quantitative analysis of n-nonaldehyde using a benchtop mass spectrometer demonstrated a linear response over 3 orders of magnitude from 2.5 ng to 5 μg of aldehyde loaded on the filter paper emitter. The limit of detection was determined to be 2.2 ng for this aldehyde. The method had a precision of 22%, relative standard deviation. The experiment was also implemented using a portable ion trap mass spectrometer.     

Direct drug analysis from oral fluid using medical swab touch spray mass spectrometry

Fourteen common drugs of abuse were identified in spiked oral fluid (ng mL⁻¹ levels), analyzed directly from medical swabs using touch spray mass spectrometry (TS-MS), exemplifying a rapid test for drug detection. Multiple stages of mass analysis (MS² and MS³) provided identification and detection limits sought by international forensic and toxicological societies, Δ⁹-THC and buprenorphine excluded. The measurements were made using a medical swab as both the sampling probe and means of ionization. The adaptation of medical swabs for TS-MS analysis allows non-invasive and direct sampling of neat oral fluid. Data acquisition was rapid, seconds per drug, and MS³ ensured reliable identification of illicit drugs. The reported data were acquired to investigate (i) ionization of common drugs from commercial swabs, (ii) ion intensity over spray duration, and (iii) dynamic range, all as initial steps in development of a quantitative method. The approach outlined is intended for point-of-care drug testing using oral fluid in clinical applications as well as in situ settings, viz. in forensic applications. The proof-of-concept results presented will require extension to other controlled substances and refinement in analytical procedures to meet clinical/legal requirements.     

Ambient dependence of visible emissions in SrTiO3

We investigated the visible emission property of SrTiO₃ (STO) single crystals with high temperature annealing in some ambient conditions. We found that the green emission in STO, which should be associated with intermediate states originating from functional ionic defects inside the samples, such as cation/oxygen vacancies, showed strong ambient dependence. While high temperature annealing in the O₂ atmosphere suppressed the intensity of visible emission, annealing in an O₂-free atmosphere, such as N₂ or H₂, increased it. The broad visible emissions were fitted with three sub-modes, whose intensities showed different evolutions with respect to the ambient condition. Our study demonstrated the systematic development of defect states with the amount of the oxygen vacancies in STO.     

Rapid detection of pesticide residues in Chinese herbal medicines by molecularly imprinted membrane electrospray ionization mass spectrometry

Chinese herbal medicines(CHMs) play an increasingly important role in the field of medicine and affects public health in the world.Although more and more strict has been employed to ensure the quality and safety of CHMs,pesticide residues in CHMs remain a serious issue and are the bottleneck for the global development of CHMs.In this work,we applied molecularly imprinted membrane electrospray mass spectrometry(MIM-ESI MS) for rapid detecting 4 classes of pesticide residues in CHMs,including organophosphorus(OPP),carbamates,pyrethroids and neonicotinoids in CHMs.Compared with our previous ambient ionization method MESI,MIM-ESI is capable of achieving a ～50-fold increase in the detection limit of conventional analytical methods owing to the specificity recognition and unique enrichment of MIM.The optimal experimental conditions were determined,and the method was further validated for its sensitivity and specificity.Our data showed that MIM-ESI MS is applicable for the direct quantitation of pesticide residues in CHMs.This detection technology may help to ensure the quality of CHMs in the future.     

Sulfamic Acid: Efficient,Cost-Effective Catalyst for Facile Synthesis of Deazaoxaflavin at Ambient Temperature

A facile, ecofriendly procedure has been developed for the synthesis of substituted 5-deaza-10-oxaflavins by sulfamic acid–catalyzed two-component condensation of salicylaldehyde and barbituric acid at ambient temperature. Mild reaction conditions, short reaction time, ambient temperature, ecofriendly solvent system, wide substrate scope, simple workup procedure, no need for chromatographic separation, and good yields are auxiliary advantages of the present protocol.     

Ambient ionisation mass spectrometry for the characterisation of polymers and polymer additives: A review

The purpose of this review is to showcase the present capabilities of ambient sampling and ionisation technologies for the analysis of polymers and polymer additives by mass spectrometry (MS) while simultaneously highlighting their advantages and limitations in a critical fashion. To qualify as an ambient ionisation technique, the method must be able to probe the surface of solid or liquid samples while operating in an open environment, allowing a variety of sample sizes, shapes, and substrate materials to be analysed. The main sections of this review will be guided by the underlying principle governing the desorption/extraction step of the analysis; liquid extraction, laser ablation, or thermal desorption, and the major component investigated, either the polymer itself or exogenous compounds (additives and contaminants) present within or on the polymer substrate. The review will conclude by summarising some of the challenges these technologies still face and possible directions that would further enhance the utility of ambient ionisation mass spectrometry as a tool for polymer analysis.     

Direct analysis of anabolic steroids in urine using Leidenfrost phenomenon assisted thermal desorption-dielectric barrier discharge ionization mass spectrometry

Rapid detection of trace level anabolic steroids in urine is highly desirable to monitor the consumption of performance enhancing anabolic steroids by athletes. The present article describes a novel strategy for identifying the trace anabolic steroids in urine using Leidenfrost phenomenon assisted thermal desorption (LPTD) coupled to dielectric barrier discharge (DBD) ionization mass spectrometry. Using this method the steroid molecules are enriched within a liquid droplet during the thermal desorption process and desorbed all-together at the last moment of droplet evaporation in a short time domain. The desorbed molecules were ionized using a dielectric barrier discharge ion-source in front of the mass spectrometer inlet at open atmosphere. This process facilitates the sensitivity enhancement with several orders of magnitude compared to the thermal desorption at a lower temperature. The limits of detection (LODs) of various steroid molecules were found to be in the range of 0.05–0.1 ng mL⁻¹ for standard solutions and around two orders of magnitude higher for synthetic urine samples. The detection limits of urinary anabolic steroids could be lowered by using a simple and rapid dichloromethane extraction technique. The analytical figures of merit of this technique were evaluated at open atmosphere using suitable internal standards. The technique is simple and rapid for high sensitivity and high throughput screening of anabolic steroids in urine.     

疏水介孔SiO2的制备与性能表征

以廉价的工业级正硅酸乙酯为原料,经过酸碱两步催化制备二氧化硅凝胶,以三甲基氯硅烷/六甲基二硅氧烷混合液对凝胶进行直接表面改性,常压干燥下得到高比表面积疏水性二氧化硅气凝胶.用SEM、IR、N2吸脱附、TG-DTA、接触角的测定等分析方法对二氧化硅化学成分、结构形貌、比表面积、热稳定性和疏水性能进行了研究.结果表明,经改...     

大流量采样-GC-NCI-MS测定环境空气中的多溴联苯醚

建立了大流量采样-气相色谱负化学电离质谱法测定环境空气中痕量多溴联苯醚的方法.用PS-1型大流量空气采样器采集环境空气样品,样品经提取、纯化后采用气相色谱负化学电离质谱法测定环境空气中多溴联苯醚.方法的线性范围在5～10000 pg/m3之间,检出限1～50 pg/m3.用于检测2006年5月在广州市采集的环境空气样品,多溴联苯醚组分含量在5.4～4989 pg/m3范围.该方法适合用于监测环境空气中的痕量PBDEs.     

Radiation background due to radioactive sources in a luminescence dating laboratory

For practical reasons, usually, luminescence dating laboratories contain in the same room (or in adjacent rooms) the equipment and the radioactive sources, as well as the storage cabinet for the samples. It is generally assumed that the absorbed dose due to ambient radioactivity is null or at least negligible in terms of human health (below the dose limit).To test the actual dose rate inside our laboratory room, an investigation combining portable dose rate meter, portable NaI(Tl) gamma spectrometry, and blue-OSL dosimetry using Al₂O₃:C pellets was made. Although our measurements show the presence of X-rays as far as 3 m from the sources, the dose rates are below the safety regulation and does not affect the dating of the sample stored in the same room as the radioactive sources.