不同退火条件对PEALD制备的Ga2O3薄膜特性的影响

利用等离子增强原子层沉积技术(PEALD)在c面蓝宝石衬底上制备了氧化镓(Ga₂O₃)薄膜,研究了退火气氛(v(N₂)∶v(O₂)=1∶1(体积比)、空气和N₂)及退火时间对Ga₂O₃薄膜晶体结构、表面形貌和光学性质的影响。研究结果表明,退火前的氧化镓处于亚稳态,不同退火气氛下退火后晶体结构发生明显改变,而且退火气氛中N₂比例增加有利于Ga₂O₃重结晶。在N₂气氛下退火达到30 min,薄膜结构已由亚稳态转变成择优取向的β-Ga₂O₃。而且表面形貌分析表明,退火30 min后表面形貌开始趋于稳定,表面晶粒密度不再增加。另外实验样品在 400~800 nm的平均透射率几乎是100%,且光吸收边陡峭。采用N₂气氛退火,对于富氧环境下沉积的Ga₂O₃更利于薄膜表面原子迁移,以及择优取向Ga₂O₃重结晶。     

配合参数对单晶炉驱动系统的影响分析

光伏产业的发展使得对硅材料的需求日益增加,同时硅单晶生产行业竞争也日趋激烈。作为生产硅单晶的重要装备,单晶炉的稳定性和可靠性关系到硅单晶生产效率的提升和成本的下降,因此其驱动系统的设计和优化成为装备制造的关键环节。本文以NVT-HG2000-V1型硅单晶生长炉的驱动系统为研究对象,用SolidWorks三维建模实现虚拟装配,采用ADAMS建立其动力学仿真模型,并对驱动系统的运动过程进行仿真模拟。采用控制变量法定量分析了铜套与升降轴的配合间隙及丝杠参数对驱动力和驱动力矩的影响规律,进而在提高硅单晶生长炉装备稳定性和可靠性方面给出合理的技术建议。结果表明,铜套与升降轴的配合间隙达到0.071 mm后能有效降低驱动系统运行所需驱动力矩,丝杠倾斜度、螺纹螺距与螺纹间摩擦系数的增大均会导致驱动系统运行所需力矩大幅增加。     

石墨烯负载的氧配位钴单原子稳定金属锂负极

Lithium (Li)-based batteries are the dominant energy source for consumer electronics, grid storage, and electrified transportation. However, the development of batteries based on graphite anodes is hindered by their limited energy density. With its ultrahigh theoretical capacity (3860 mAh∙g⁻¹), low redox potential (−3.04 V), and satisfactorily low density (0.54 g∙cm⁻³), Li metal is the most promising anode for next-generation high-energy-density batteries. Unfortunately, the limited cycling life and safety issues raised by dendrite growth, unstable solid electrolyte interphase, and "dead Li" have inhibited their practical use. An effective strategy is to develop a suitable lithiophilic matrix for regulating initial Li nucleation behavior and controlling subsequent Li growth. Herein, single-atom cobalt coordinated to oxygen sites on graphene (Co-O-G SA) is demonstrated as a Li plating substrate to efficiently regulate Li metal nucleation and growth. Owing to its dense and more uniform lithiophilic sites than single-atom cobalt coordinated to nitrogen sites on graphene (Co-N-G SA), high electronic conductivity, and high specific surface area (519 m²∙g⁻¹), Co-O-G SA could significantly reduce the local current density and promote the reversibility of Li plating and stripping. As a result, the Co-O-G SA based Li anodes exhibited a high Coulombic efficiency of 99.9% at a current density of 1 mA∙cm⁻² with a capacity of 1 mAh∙cm⁻², and excellent rate capability (high current density of 8 mA∙cm⁻²). Even at a high plating capacity of 6 mAh∙cm⁻², the Co-O-G SA electrode could stably cycle for an ultralong lifespan of 1300 h. In the symmetric battery, the Co-O-G SA based Li anode (Co-O-G SA/Li) possessed a stable voltage profile of 18 mV for 780 h at 1 mA∙cm⁻², and even at a high current density of 3 mA∙cm⁻², its overpotential maintained a small hysteresis of approximately 24 mV for > 550 h. Density functional theory calculations showed that the surface of Co-O-G SA had a stronger interaction with Li atoms with a larger binding energy, −3.1 eV, than that of Co-N-G SA (−2.5 eV), leading to a uniform distribution of metallic Li on the Co-O-G SA surface. More importantly, when matched with a sulfur cathode, the resulting Co-O-G SA/lithium sulfur full batteries exhibited a high capacity of 1002 mAh∙g⁻¹, improved kinetics with a small polarization of 191 mV, and an ultralow capacity decay rate of 0.036% per cycle for 1000 cycles at 0.5C (1C = 1675 mA∙g⁻¹) with a steady Coulombic efficiency of nearly 100%. Therefore, this work provides novel insights into the coordination environment of single atoms for the chemistry of Li metal anodes for high-energy-density batteries.     

不同波长条件KDP晶体的非线性光学性质研究

采用Z扫描方法系统的研究了KDP晶体在不同激光波长条件下的非线性光学性质.当λ=355 nm,功率密度为57.92 GW/cm2和λ=532 nm,功率密度为105.94 GW/cm2时,KDP晶体均呈现强烈的反饱和吸收和自聚焦效应,其非线性吸收系数和非线性折射率分别为6.50×10 -2cm/GW,1.17×10 -2cm/GW和8.02×10 -7cm2/GW,6. 14×10 -7cm2/GW;而在1064 nm波长,功率密度为347.95 GW/cm2时KDP晶体并未表现出明显的非线性性质.结果表明,在短波长的激光作用下,KDP晶体更容易产生非线性效应,双光子吸收是KDP晶体非线性吸收的主要机制.     

催化热解-冷原子吸收分光光度法测定大米中的汞含量

建立冷原子吸收分光光度法测定大米中汞含量的方法。采用DMA–80直接测汞仪,大米样品经干燥、分解灰化、还原等过程,直接进入冷原子吸收光谱仪进行测量。干燥温度为200℃,热解温度为650℃。该方法的检出限为0.001 ng/g,加标回收率为85.0%～99.2%,测定结果的相对标准偏差为0.25%～3.70%(n=6)。利用标准物质和原子荧光法进行比对试验,测定结果均在误差范围内。该方法测定结果准确,灵敏度高,重现性好,适用于大米中汞含量的测定。     

正电子冲击下氦电离三重微分截面的理论计算

我们发展了一种正电子碰撞原子电离的畸变波Born近似方法， 在这个方法中，正负电子偶素通道通过一个ab initio的光学势附加到入射粒子和靶的相互作用势上，且通道对电离作用被第一次被考虑在正电子碰撞原子电离的过程中. 应用这个方法计算了在50 eV入射能量范围氦的电离的三重微分截面，计算结果和实验数据很好的符合.     

三能级钾原子气体三维傅里叶变换频谱的解析解

利用投影切片定理、傅里叶位移定理和误差函数给出三能级钾原子气体三维傅里叶变换频谱在T=0界面的解析解.固定均匀线宽,非均匀展宽和对角线相关系数可以定量地识别,通过在适当方向上拟合三维傅里叶变换频谱谱峰的切片来确定.结果表明,非均匀展宽增大,频谱图沿着对角线方向延伸,对角线相关系数增大,频谱图逐渐变圆,振幅也逐渐变小.     

还原偶氮分光光度法测定水中硝基苯方法的改进

<正>还原偶氮分光光度法测定水中硝基苯[1-3],是污水、废水污染监测中一个重要的分析方法,具有仪器简单、灵敏度高和普及性强等特点,是硝基苯类有机化学污染物监测不可缺少的方法之一。但在运用该方法进行实际样品分析时,发现该方法在样品氧化还原前处理过程中操作比较繁琐,且易造成样品损失。针对这个问题,本工作对氧化还原前处理装置进行了改进[4],取消了前处理装置,使样品的氧化还原前处理和定容一步到位;简化了操作,提高了试验