首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   25篇
  免费   12篇
物理学   37篇
  2023年   2篇
  2022年   2篇
  2021年   4篇
  2019年   2篇
  2017年   1篇
  2015年   1篇
  2014年   5篇
  2013年   2篇
  2012年   1篇
  2009年   4篇
  2008年   4篇
  2003年   2篇
  2000年   2篇
  1999年   1篇
  1998年   1篇
  1997年   1篇
  1996年   1篇
  1995年   1篇
排序方式: 共有37条查询结果,搜索用时 15 毫秒
1.
提出了一种用于单纵模激光器选模的基于光纤耦合器的光纤复合环腔(CRC)滤波器的仿真方法,利用该方法对两种新型双耦合器双环CRC(DCDR-CRC)滤波器及三耦合器双环CRC(TCDR-CRC)滤波器进行了理论仿真,通过引入游标原理,分析了两种滤波器在不同环长差下的滤波特性,并通过调整DCDR-CRC及TCDR-CRC的耦合比、环长及环长差,对有效自由光谱范围(FSR)、抑制比(SR)及主透射峰带宽进行优化,计算结果表明优化后环腔的有效FSR可有效抑制波长选择器传输通带内的增益竞争,较低的SR可以抑制CRC滤波器相邻透射峰之间的增益竞争,较窄的主透射峰可以保证仅有一个激光器的纵模被选择。  相似文献   
2.
We demonstrate the continuous wave p-polarized single longitudinal mode (SLM) operation of an Er:YAG laser at 1617.6nm pumped by a diode-laser with three inserted Fabry-Perot (FP) etalons at room temperature. The Brewster angle inserted FP is applied to obtain the p-polarized laser. For free running, the maximum output power is 570 m W with a pump power of 12.5 W. An incident pump power of 12.5 W is used to generate the maximum p-polarized single longitudinal mode output power of 78.5 m W, corresponding to a slope efficiency of 1.6% and an optical-to-optical efficiency of 0.61%. The beam quality M2 is measured to be 1.15 at the highest SLM output power. This stable polarized SLM oscillation is encouraging due to its application for an injection-locked system used as a master laser.  相似文献   
3.
设计并研制了全固态调Q脉冲单纵模Nd:YVO4环形激光器。利用880nm激光二极管端面抽运Nd:YVO4晶体,通过四镜环形谐振腔中插入声光调Q晶体、标准具,并优化激光谐振腔的结构,获得了重复频率为200Hz、脉宽为26.6ns的单纵模脉冲1.064μm激光输出。当泵浦功率为15 W时,单纵模激光输出的单脉冲能量为570μJ、脉冲能量稳定性优于3%。  相似文献   
4.
We present a stable linear-cavity single longitudinal mode (SLM) erbium-doped silica fiber laser. It consists of four fiber Bragg gratings (FBGs) directly written in a section of photosensitive erbium-doped fiber (EDF) to form an asymmetric three-cavity structure. The stable SLM operation at a wavelength of 1545.112 nm with a 3-dB bandwidth of 0.012 nm and an optical signal-to-noise ratio (OSNR) of about 60 dB is verified experimentally. Under laboratory conditions, the performance of a power fluctuation of less than 0.05 dB observed from the power meter for 6 h and a wavelength variation of less than 0.01 nm obtained from the optical spectrum analyzer (OSA) for about 1.5 h are demonstrated. The gain fiber length is no longer limited to only several centimeters for SLM operation because of the excellent mode-selecting ability of the asymmetric three-cavity structure. The proposed scheme provides a simple and cost-effective approach to realizing a stable SLM fiber laser.  相似文献   
5.
An electrically driven, single-longitudinal-mode GaAs based photonic crystal (PC) ridge waveguide (RWG) laser emitting at around 850 nm is demonstrated. The single-longitudinal-mode lasing characteristic is achieved by introducing the PC to the RWG laser. The triangle PC is etched on both sides of the ridge by photolithography and inductive coupled plasma (ICP) etching. The lasing spectra of the RWG lasers with and without the PC are studied, and the result shows that the PC purifies the longitudinal mode. The power per facet versus current and current-voltage characteristics have also been studied and compared.  相似文献   
6.
利用琼斯矩阵对一种三环嵌套的无源谐振腔的选频特性进行了分析,并根据无源谐振腔选频的原理,设计了一种基于三环嵌套无源谐振腔的掺铒光纤激光器。实验结果表明:三环嵌套的无源谐振腔具有良好的选频特性,当泵浦功率为159 mW时,得到了稳定的单纵模激光信号输出;输出功率的最大波动为0.04 dB,输出中心波长最大漂移为0.016 nm;耦合器的耦合比减小时,激光器会处于多纵模振荡状态。  相似文献   
7.
提出和证实了一种光纤环形激光器. 将一个带通滤波器与一个带阻滤波器级联,用一段保偏掺铒光纤作为饱和吸收体,得到了一种单纵模双波长光纤激光器. 结果表明,该激光器波长间隔为0.4 nm,边模抑制比大于49 dB.如果将两个波长进行差拍,该激光器有潜力得到49.85 GHz的微波信号.  相似文献   
8.
LD抽运Cr,Tm,Ho∶YAG微片激光器单纵模运转特性的研究   总被引:1,自引:0,他引:1       下载免费PDF全文
研究了LD抽运的单纵模Cr,Tm,Ho∶YAG微片激光器,激光器厚度为1?mm,在用波长785?nm的LD进行端面抽运时,激光器阈值为1060?mW,单纵模激光最大输出功率为31?mW. 对激光器输出功率随温度变化特性进行了研究,验证了CTH∶YAG晶体的温度敏感性. 还研究了激光器的温度调谐特性,实验测得激光器的温度调谐系数为14?GHz/℃. 关键词: 激光光学 CTH∶YAG微片激光器 LD抽运 单纵模运转  相似文献   
9.
邢俊红  焦明星 《光子学报》2015,44(2):142-147
为了产生频差可调谐1 064nm双频激光输出,设计了一种扭转模结构双腔双频Nd∶YAG激光器,其两个驻波谐振腔共用相同的Nd∶YAG增益介质,以扭转模结构消弱增益空间烧孔效应,使Nd∶YAG激光器的两个驻波腔均以单纵模振荡,从而获得正交线偏振1 064nm双频激光输出.理论分析了扭转模结构激光单纵模选择原理和双频激光同时振荡原理,实验研究了双频激光振荡特性和频差调谐特性.研究结果表明:双频Nd∶YAG激光器的两个谐振腔能够同时以线偏振单纵模稳定振荡输出,其频差大小可随激光腔长的改变而调谐,频差调谐范围可达1个纵模间隔,实验观察到的频差调谐范围为0.3GHz~3GHz.  相似文献   
10.
张森  石顺祥  马琳 《光子学报》2008,37(5):896-900
基于光折变晶体中自泵浦与互泵浦相位共轭共存效应,利用新型光折变自适应光外差探测系统进行了调Q脉冲激光的光折变自适应光外差探测技术研究.结果表明,该系统可以用来实现单纵模调Q脉冲激光的自适应光外差探测,并可以通过提高本振光强度有效地提高外差探测灵敏度.进一步的实验和理论分析表明,对于一般的调Q脉冲激光,由于其各个纵模频谱分量之间不相关,难于实现光外差探测.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号