CuO-BaO/SiO2催化剂的结构表征

以XRD、XPS和EXAFS手段对CuO－BaO／Sic2催化剂及其还原态的结构进行了研究．结果表明，在CuO－BaO／SiO2体系中铜和钡都是以氧化态的形式存在，超细SiO2载体对所负载的CuO的结构有影响．随着样品负载量的逐渐降低，Cu－O和Cu－Cu睡的健长和配位数逐渐征小，而且低载量样品的健长和配位数减小的幅度最大．在总负载量＞13．39％的样品中，CuO以晶相的形式存在；总负载量＜13．39％的样品中，CUO呈现单层分布的高分出状态．还原态样品中钢以本价铜的形式存在，随负载量的降低，还原态Cu－Cu健的镇长和配位数也分别呈现出逐渐减小的趋势．还原态中心铜原子在催化剂表面的分布状态基本上保持了氧化态催化剂中CuO物相的分市状态．     

负载型Pd三效催化剂：载体CeO2-ZrO2-BaO的制备及催化性能

制备了不同BaO含量的CeO2-ZrO2储氧材料,并以此材料为载体浸渍H2PdCl6制得三效催化剂.结果表明,不论新鲜还是1 000 ℃老化状态下,以10%BaO添加CeO2-ZrO2储氧材料制备的Pd三效催化剂活性最佳,起燃和完全转化温度最低.XPS结果证实,10%BaO添加.通过稳定PdO活性组分并改变其电子环境使得催化剂有最佳活性.而随着BaO含量持续增加,Pd活件组分相对处于较氧化状态.储氧量、低温N2吸附-脱附测试以及XRD测试结果均表明10%BaO添加的材料储氧量,比表面积以及孔容均最大,而且有适应三效催化的孔径.这些结果均有助于以其制备的Pd三效催化剂获得更好的活性以及热稳定性.     

Ru(0001) 表面BaO吸附层的原子结构和氮分子的吸附性质

采用密度泛函理论研究了Ru(0001) /BaO表面的原子层结构和氮分子的吸附性质. 研究结果表明, 在低覆盖度下氧化钡倾向于以相同的构型形成Ru(0001) 表面原子层. 在此构型中, 氧原子位于表面p(1× 1) 结构的hcp谷位, 而钡原子则位于同一p(1× 1) 结构的顶位附近. 钌氧键键长等于0.209 nm, 比EXAFS的实验值大0.018 nm. 在Ru(0001) /BaO表面氮分子倾向吸附于钡原子附近. 相应位置的氮分子吸附能位于0.70到0.87 eV之间, 大于氧原子附近的氮分子吸附能. 钡原子附近的钌原子对氮分子具有更强的活化性能. 相应位置的氮分子拉伸振动频率等于1946 cm^{- 1}, 比氧原子附近的最大分子振动频率小约130 cm^-1. Ru(0001) /BaO表面氮分子键强度介于清洁Ru(0001) 和Ru(0001) /Ba表面之间. Ru(0001)/BaO表面不同位置的氮分子吸附性质差异是由钡和氧原子化学性质不同造成的. 表面钡原子的作用能够减少吸附氮分子的σ^*轨道电子密度, 增加π^*轨道电子密度, 从而增强氮分子和钌原子间的轨道杂化作用, 弱化氮分子键.     

Electrochemical Detection of 2-Nitrophenol Using a Glassy Carbon Electrode Modified with BaO Nanorods

Here, an electrochemical detection approach (differential pulse voltammetry) was employed to develop a 2-nitrophenol (2-NP) sensor probe using a glassy carbon electrode (GCE) coated by wet-chemically synthesized nanorods (NRs) of BaO. The prepared BaO NRs were characterized by field-emission scanning electron microscopy (FESEM), energy-dispersive X-ray spectroscopy (EDS), X-ray photoelectron spectroscopy (XPS) and powder X-ray diffraction (XRD) analysis. The peak currents by differential pulse voltammetric (DPV) analysis of 2-NP are plotted against the concentration to obtain the calibration curve of the 2-NP detection. It was found to be linear from 1.5 to 9.0 μM, defined as the dynamic range (LDR) for 2-NP detection in phosphate buffer solution. The sensor sensitivity was calculated from the slope of LDR by considering the active surface area of NRs coated on GCE (0.0316 cm²) and found as 17.6 μAμM⁻¹ cm⁻². The limit of detection (LOD) was calculated as 0.50±0.025 μM from the signal/noise (S/N) ratio of 3. Moreover, the sensor analytical parameters such as reproducibility, long-term performing ability (stability), response time and validity in real environmental samples were found acceptable and to give satisfactory results. The development of a nanomaterial-based electrochemical chemical sensor might be an effective approach to sensor technology to detect carcinogenic and hazardous toxins for environmental safety and healthcare fields in a broad scale.     

BaO对Pd/Al2O3上CH4催化燃烧性能的影响

以醋酸钯为前身盐, BaO-Al2O3复合氧化物为载体制备了系列负载型钯催化剂. BET和XRD表征结果表明,复合氧化物在制备过程中发生固相反应所生成的BaAl2O4 可以阻止γ-Al2O3向α相的转变,显著增强Al2O3的热稳定性.以甲烷燃烧为模型反应的评价结果表明, BaO的引入提高了催化剂上甲烷燃烧反应的活性和稳定性.     

温度对GaN(0001)表面生长吸附SrO、BaO和TiO_2影响的理论研究

采用基于第一性原理的从头计算分子动力学方法,模拟了300、400、500、600和700℃下SrO、BaO和TiO_2分子在GaN(0001)表面吸附的动力学过程,研究了温度对原子运动轨迹、吸附能、界面电荷分布、稳定吸附方位和扩散系数的影响.温度不同,O-Ga成键时间不同,SrO分子中的O原子与GaN基底成键的Ga原子不同; TiO_2分子中O原子与GaN表面Ga原子成键的顺序也不同.温度对SrO、BaO和TiO_2分子在GaN(0001)表面的最终吸附形态和吸附方位有显著的影响.温度对不同吸附体系吸附能的影响也不相同;小分子在GaN(0001)基片表面优先吸附的顺序依次为TiO_2、SrO和BaO分子.数据分析显示SrO和BaO分子的最优生长温度是600℃,TiO_2分子的最优生长温度是500℃.     

制备方法对镧钡共改性氧化铝性能的影响

The effect of preparation method on the properties of alumina modified by La₂O₃ and BaO was investigated by means of Low temperature nitrogen adsorption-desorption, NH₃-TPD, NO-TPD and XRD. The results show that alumina prepared by peptizing method exhibits the best textural properties, alumina obtained by co-precipitation method presents the strongest surface acidity and alumina derived from impregnation method shows the best ability of NO adsorption. After calcination at 1 100 ℃, all alumina except that from impregnation method have excellent thermal stability. When the specific surface area and pore volume of alumina are large enough, the activity of catalyst Pd/alumina is affected primarily by the surface acidity of alumina.     

Rare earth oxide doping in oxide cathodes

The effect on life performance and poisoning with O₂ by doping oxide cathodes with rare earth oxides and pseudo rare earth oxides, notably yttria, is qualitatively explained in terms of electrolysis of BaO during emission of electrons. Doped cathodes show less electrolysis and consume therefore less Ba during life: consequently, doped cathodes have a better life performance. However, the lower Ba-production makes doped cathodes more sensitive to oxygen poisoning. The experimentally found relation between conductivity and yttria concentration was the motive to propose a new model for the crystal imperfections in BaO. In this new imperfection model most Y³⁺-ions will combine with barium vacancies, therefore, the increase of the conductivity is modest and also the effect on the position of the Fermi level is modest. By assuming a combination of bulk and surface conductivity, the agreement between experiment and theory can be improved further.     

Synthesis and Raman study on needlelike silicates in ancient Chinese Pb‐Ba glass in Qin and Han dynasties

Two ancient green Chinese Pb‐Ba glass (Qin and Han dynasties) were studied with Raman microspectroscopy, scanning electron microscopy, and energy dispersive X‐ray spectrometry. Some needlelike silicates were found in the samples and inferred as BaSiO₃, BaSi₂O₅, and PbSiO₃ according to the results of energy dispersive X‐ray spectrometry analysis. Then BaSiO₃, BaSi₂O₅, and PbSiO₃ were synthetized in laboratory in order to obtain their Raman spectra. Through comparative study, the needlelike silicates in the ancient Pb‐Ba glass samples were proved to be PbSiO₃, BaSiO₃, and Al₂O₃. According to the ternary phase diagram analysis, a mechanism of local element enrichment was put forward for the barium silicate needlelike silicates (by‐products) formation in the ancient Pb‐Ba glass. Copyright © 2014 John Wiley & Sons, Ltd.