网间交联型增韧环氧树脂/蓖麻油聚氨酯互穿网络聚合物的动态力学性能和形态结构

以增韧环氧树脂(TEP)和蓖麻油聚氨酯[PU(CO)]形成的互穿网络聚合物(IPN),两网络间具有一定数量的交联点,在一定组成下,该IPN的tanδ-T曲线半峰宽达100℃,tanδ最大值接近1,阻尼性能良好。形态研究表明,该IPN既有增韧环氧树脂本身的两相结构,又有IPN的两相结构。     

形状记忆聚氨酯研究进展

对形状记忆聚合物(主要以聚氨酯为例)的总体研究概况、合成方法、表征手段、数学模型等方面进行了综述。     

Bestimmung wasserlöslicher Polyelektrolyte in Polyurethan-Dispersionen

Zusammenfassung Die Bestimmung wasserlöslicher Polyelektrolyte, die bei der Synthese segmentierter Polyurethanionomerer entstehen, erfolgte durch konduktometrische und potentiometrische Titrationsverfahren nach Abtrennung des Serums durch Ultrazentrifugieren oder Ausfrieren des Polymeren bzw. Abtrennung der wasserlöslichen Elektrolyte mit einem gemischten Ionenaustauscher. Diese Elektrolyte enthielten abhängig von der Rezeptur zwischen 25 und 72% der vorgegebenen Ionenkonzentration. Unterstellt man glatte, kugelförmige Latexpartikeln, so beträgt die Fläche pro festhaftende ionische Gruppe nur 60–170 Ų, wodurch eine erhebliche gegenseitige Beeinflussung der Ionen resultiert.Herrn Prof. Dr. Ing. Dr. h.c. mult. H. Zahn zum 65. Geburtstag gewidtmet (O. L.).     

SYNTHESIS, CROSSLINKING MECHANISM AND PROPERTIES OF A POLYACRYLATE/POLYURETHANE COMPOSITE COATING

A polyacrylate/polyurethane (P(A) / P(U)) composite coating has been prepared bycrosslinking an acetoacetylated polyacrylate with a vinylic group terminated polyurethaneat room temperature. A model Michael reaction between ethyl acetoacetate (EAA) andmethyl acrylate (MA) was designed to study the crosslinking mechanism. It was foundthat the two active hydrogen atoms in acetoacetyl group can both add to vinylic groupsand the yield of mono- and bis-adducts are much affected by the molar ratio of acetoacetylto vinylic groups. Higher crosslinking degree and better properties could be obtained withdecreasing the molar ratio of the two active groups from 1/1 to 0.6/1 in the compositecoatings.     

聚醚聚氨酯双离子型离聚物的介电性能研究

以4,4＇-二苯基甲烷二异氰酸酯(MDI)、N-甲基二乙醇胺(MDEA)和聚四氢呋喃(PTMD)以2:1:1(mol比)合成聚醚型聚氨酯,MDEA的叔胺基与γ-丙磺内酯反应,制备了不同磺化程度的双离子型离聚物.在不同温度与频率(-150-30℃,20Hz—100KHz)下,测定了其介电性能.结果表明,随离子化程度的提高,ε＇增大,α弛豫介电损耗峰移向低温,说明相分离越趋完善;β弛豫单元的活化能(△Hβ)基本不变;α弛豫单元的活化能(△Hα)依次变小.介电测量结果与动态力学方法研究结果相吻合.     

聚环氧氯丙烷氨酯阻尼材料的阻尼性能研究

<正> 一般来讲,聚合物材料的阻尼性能来源于分子链运动带来的内摩擦力以及分子间物理键的破坏与再生,分子链运动所产生的阻尼在聚合物的玻璃化转变温度范围内最为有效。因此具有极性较强、体积较大的一CH_2Cl侧基的环氧氯丙烷聚合物应具有优异的阻尼性能,专利文献[1—2]报道过由多羟基(官能度≥2)聚环氧氯丙烷预聚物为原料制得的聚氨酯泡沫具有良好的阻燃性能,作者在聚环氧氯丙烷氨酯阻尼材料方面进行了尝试。     

聚氨酯(PU)/聚乙烯醇(PVA)共混体系的有关性能及其模型研究

本文研究了聚氨酯(PU)-聚乙烯醇(PVA)共混体系的动态力学性质、相逆转现象和透气性能.发现当PVA重量含量为30-50％时,共混体系发生了连续相与分散相的逆转.进一步,通过力学模型描述了该共混体系的模量-组成关系、动态力学温度谱以及透气系数与PVA含量的关系曲线.所有实验数据都落在理论预测的范围内,并分别与改进的Kerner模型和组合Kerner模型相符合.     

Infrared microspectroscopic study of the thermo-oxidative degradation of hydroxy-terminated polybutadiene/isophorone diisocyanate polyurethane rubber

Hydroxy-terminated polybutadiene/isophorone diisocyanate (HTPB/IPDI) polyurethane rubber which was aged in air at elevated temperatures has been studied by infrared microspectroscopy. Spectra were collected in transmission mode on microtomed samples. Analysis of sets of spectra taken across the sectioned material showed that most of the degradation occurred in the polybutadiene part of the polymer and that the urethane linkage was essentially unchanged. The trans isomer of the polybutadiene appears to be preferentially degraded compared with the vinyl isomer. The IR technique does not provide significant information about the cis isomer. The IR spectra indicated that likely degradation products included acids, esters, alcohols, and small amounts of other products containing a carbonyl functional group. Band area ratios, supported by a principal components analysis, were used to derive degradation profiles for the material. These profiles were steep-sided indicating an oxygen diffusion limited process.     

Preconcentration and separation of iron, zinc, cadmium and mercury, from waste water using Nile blue a grafted polyurethane foam

The present work describes a novel method for the incorporation of Nile blue A into polyurethane foam matrix. This foam material was found to be very suitable for the extraction of metal ions from aqueous solutions. The characterization of Nile blue A grafted foam and the effect of halide concentration, pH, shaking time, extraction isotherm and capacity have been investigated. This foam material was found to be suitable for the separation and preconcentration of iron (III), zinc (II), cadmium (II) and mercury (II) from waste water. The extraction was accomplished in (15-20) minutes. Iron was separated from acid medium (2-4 M HCl), zinc from (3-5 M HCl), cadmium from (4-6 M HCl) as thiocyanate complexes and mercury was separated from (1-2 M HCl) as chloride.     

超支化聚氨酯固体电解质导电性能的光谱学研究

用超支化聚氨酯 +线性聚氨酯作为基体 ,LiClO4作为离子源制得聚合物固体电解质 .用Raman光谱 ,FTIR光谱等光谱学方法研究了聚合物电解质中盐离子和聚合物基团之间的相互作用 .研究表明超支化聚氨酯对盐有较好的溶解作用 .研究还表明超支化聚氨酯加入有利于提高体系的电导率