Distribution patterns of gamma radiation dose rate in the high background radiation area of Odisha,India

Journal of Radioanalytical and Nuclear Chemistry - Absorbed dose rates in air for 20 residential areas in Odisha were measured using a vehicle-mounted NaI(Tl) scintillation spectrometer. The...     

Phase behavior of binary mixtures composed of ethylene carbonate and various organic solvents

Phase behaviors of the binary mixtures composed of ethylene carbonate (EC) and aliphatic alcohols, ω-phenyl alcohols, and alkylbenzenes were investigated. In addition, heat of solution of EC into these organic solvents was measured. The EC/methanol and EC/ethanol systems gave homogeneous solution at the temperature above their liquidus lines, while the mixtures of EC and alcohols with longer alkyl chain showed a miscibility gap in a liquid phase and provided the monotectic-type phase diagram. The liquid–liquid phase separation region expanded with the increase in the alkyl chain length. A similar phase behavior was also observed for the mixtures of EC and alkylbenzenes. On the other hand, the EC mixtures with ω-phenyl alcohols showed no miscibility gap in a liquid phase at least up to 4-phenylbutan-1-ol which has C4 alkyl chain intervening between phenyl and hydroxyl groups. This result demonstrates that both of the hydroxyl and phenyl groups act to facilitate the mixing of aliphatic compounds with EC. The phase behavior of these EC mixtures was analyzed applying the modified regular solution model in which the pair interaction energy was regarded as free energy. The model calculation with the use of heat of solution of EC at infinite dilution as the pair interaction enthalpy reproduced well both of the experimentally obtained liquidus line and mutual solubility curve as well as monotectic point.     

Radiation in a hypersonic shock layer generated around a projectile

Radiation emitted from the shock layer generated around a hypersonic flight model is experimentally investigated by using a ballistic range (two-stage light-gas gun). A polyethylene projectile of 1.2 cm in diameter is launched in this facility at the velocity of 5 km/sec (M=15), and the emission from the induced shock layer around the projectile is observed with a spectroscope. As a result, molecular band-spectra from NO and N₂ are detected along with those from carboncontaining molecules. Total emission power is measured with a diode-type powermeter. In addition, dimension effect of the flight model is theoretically and numerically examined, and a scaling law on thermochemical structure of the shock layer is developed. It shows that the thickness of thermal boundary-layer formed on the model surface does not follow the conventional scaling law based on the reaction distance and on the energy relaxation distance. Finally, the radiative field around the projectile is numerically computed, and the total power emitted from the shock layer is estimated. From the comparison between computed and measured results, the validity of the calculation model is discussed.     

Evaluation of influence of anisotropic diffusion near a wall in near-field fluorescence correlation spectroscopy of nanoparticles

Fluorescence correlation spectroscopy (FCS) of colloidal nanoparticles using a near-field fiber probe was numerically simulated. The near-wall dynamics was simulated by accounting for the anisotropic mobility of nanoparticles owing to hydrodynamic interaction with a wall (Stokes viscous force). By comparing the simulation results with theoretical model calculations, we found that the influence of anisotropic diffusion is insignificant in near-field FCS autocorrelation analysis.     

A regiocontrolled synthesis of substituted indoles by palladium-catalyzed coupling of 2-bromonitrobenzenes and 2-bromoacetanilides

The palladium-catalyzed cross-coupling reaction of 2-bromonitrobenzenes or 2-bromoacetanilides with ethylene has been used to produce a variety of substituted indoles. The mild reaction conditions and selectivity inherent in the coupling reaction have been utilized to produce regiochemically pure 4-, 5-, 6-, and 7-substituted indoles.     

Sorption and partial molar volume of gases in poly (dimethyl siloxane)

Sorption of N₂, O₂, Ar, CH₄, CO₂, C₂H₄, and C₂H₆ in poly (dimethyl siloxane) liquid and rubber and the dilation of the polymers due to sorption of the gases are studied at 25°C under pressures up to 50 atm. In the liquid, the sorption isotherms for low-solubility and high-solubility gases are described by Henry's law and the Flory–Huggins equation, respectively. Gas sorption in the rubber, which contains a 29 wt % silica filler, follows the dual-mode sorption model, though marked hysteresis is observed in the sorption of O₂ and CH₄. The dilation isotherms increase linearly or exponentially in both polymers with increasing pressure. Considering that gas molecules adsorbed into micropores of the filler particles do not participate in the dilation, partial molar volumes of the dissolved gases in the rubber are determined from data of sorption and dilation. The values are nearly equal to the partial molar volumes in the liquid (48–60 cm³/mol).     

Neuere Methoden zum Nachweis, zur Isolierung und quantitativen Bestimmung des Eiwei?es sowie seiner h?heren und tieferen Abbauprodukte

Ohne Zusammenfassung     

Gas sorption in poly(vinyl benzoate)

High-pressure sorption (up to 50 atm) for CO₂, N₂, and Ar in poly(vinyl benzoate) (PVB) was studied at temperatures from 25 to 70°C by a gravimetric method utilizing an electromicrobalance. The results are described by Henry's law above the glass transition temperature T_g for all gases. The dual-mode sorption model, Henry's law plus a Langmuir isotherm, applies to the sorption isotherms of N₂ and Ar in the glassy state, and the dual-mode parameters are given. For CO₂, a new type of sorption isotherm is observed below T_g. The isotherm is concave to the pressure axis in the low-pressure region and turns into a straight line with increasing CO₂ pressure which can be extrapolated back to the coordinate origin. The linear part of the isotherm is characteristic of the rubbery state, while the nonlinear part stems from glassystate behavior. The “glass transition solubility” of CO₂, at which PVB film changes from the glassy to the rubbery state, decrease as the temperature increases. The disappearance of microvoids, that is, the decrease of the Langmuir capacity, may be due to a large plasticizing effect of sorbed CO₂. The difference between the N₂ and Ar isotherms and the CO₂ isotherm is discussed from this standpoint.     

Iodonium Metathesis Reactions

A metathesis reaction occurs when a diaryliodonium triflate is heated with an aryl iodide, resulting in the formation of a new diaryliodonium triflate.