相变光盘介电薄膜ZnS-SiO2 的微结构和光学特性

采用射频磁控溅射法制备了ZnS-SiO₂ 介电薄膜,利用透射电镜和椭偏仪研究了溅射条件对ZnS-SiO₂薄膜微结构和折射率n的影响.研究表明,ZnS-SiO₂薄膜中存在微小晶粒,大小为2～10 nm的ZnS颗粒分布在SiO₂基体中,当溅射功率和溅射气压变化时,ZnS-SiO₂薄膜的微结构和折射率n发生显著变化,微结构的变化是导致折射率n变化的主要原因,通过优化溅射条件可以制备适用于相变光盘的高质量ZnS-SiO₂介电薄膜.     

Yb:FAP和Yb:C3S2-FAP晶体光谱的温度特性和选择激发

关键词：     

蓝光相变光盘的多层膜结构设计

为了使光盘获得优良的记录／读出性能并能够长期稳定地使用，必须优化设计相变光盘的多层膜结构。采用自行设计的模拟分析相变光盘读出过程设计软件，从光学角度出发模拟计算了蓝光(405nm)相变光盘的膜层结构，研究了多层膜系的反射率和反射率对比度等光学参量与各层膜厚度和槽深的关系。研究得出的最佳多层膜结构为：下介电层／记录层／上介电层／反射层的厚度对于台记录为100nm／10nm／25nm，／60nm，而对于槽记录则为140nm／15nm／30nm，／60nm，槽深为50nm。模拟计算结果对于将来高密度蓝光相变光盘的制备具有一定的指导意义。     

一种新的超分辨记录点的读出技术

提出一种新的超分辨记录点的读出技术—超分辨反射膜技术，详细分析了其原理。用该技术，以Sb为超分辨反射膜，SiN为介电层，在激光波长为632．8nm和光学头的数值也径为0．40的读出光学系统中实现了直径为380nm的超分辨记录点的读出。同时研究了Sb薄膜厚度对读出信噪比的影响规律，发现最佳的Sb薄膜厚度为28～30nm，所得的信噪比为38～40dB。     

High-Density Read-Only Memory Disc with Ag11In12Sb51Te26 Super-Resolution Mask Layer

A novel read-only memory (ROM) disc with an Ag11ln12Sb51Te26 super-resolution mask layer is proposed and investigated for the first time to our knowledge. The carrier-to-noise ratio of more than 40 dB could be obtained from small pits (380nm), which are below the readout resolution limit (400nm), in our dynamic setup with a wavelength of 632.8 nm and numerical aperture of 0.40. Dependences of carrier-to-noise ratio on readout power,readout velocity and film thickness are studied. The results show that the optimum film thickness is 20-50nm and the corresponding carrier-to-noise ratio is more than 40dB at readout power of 4mW and readout velocity of 2m/s in our experiment. The super-resolution readout mechanism for this ROM disc is also discussed.     

Optical Recording Properties of Metal-Azo Dye as Recording Medium with Super-Resolution Near-Field Structure

A novel metallized azo dye has been synthesized. The absorption spectra of the thin film and thermal characteristic are measured. Static optical recording properties with and without the Bi mask layer super-resolution near-field structure （Super-RENS） of the metal-azo dye are investigated. The results show that the metal-azo dye film has a broad absorbance band in the region of 450-650 nm and the maximum absorbance wavelength is located at 603 nm. It is also found that the new metallized azo dye occupies excellent thermal stability, initiatory decomposition temperature is at 270℃ and the mass loss is about 48% in a narrow temperature region （15℃）. The complex refractive index N （N = n ＋ iκ） is measured. High refractive index （n = 2.45） and low extinction coefficient （κ = 0.2） at the recording wavelength 65Ohm are attained. Static optical recording tests with and without Super-RENS are carried out using a 65Ohm semiconductor diode laser with recording power of 7mW and laser pulse duration of 200ns. The AFM images show that the diameter of recording mark on the dye film with the Bi mask layer is reduced about 42%, compared to that of recorded mark on the dye film without Super-RENS. It is indicated that Bi can well performed as a mask layer of the dye recording layer and the metallized azo dye can be a promising candidate for recording media with the super-resolution near-field structure.     

K2O-ZnO-Al2O3-B2O3-SiO2系掺Cr3+透明莫来石微晶玻璃的研究

采用了X射线衍射、透射电镜和吸收光谱及荧光光谱技术研究了K2O－ZnO-Al2O3-B2O3－SiO2系掺Cr^3 玻璃的析晶性能和光谱。研究结果表明：在K2O－Al2O3-B2O3-SiO2系掺Cr^3 玻璃的基础上引入ZnO后，析晶性能明显改善；析晶温度降低，析出的纳米莫来石微晶均匀、规则；微晶玻璃的发光强度明显增强。     

The changes of holographic characteristics of photopolymer induced by temperature

The changes of holographic characteristics of photopolymer induced by temperature are studied experi-mentally. The results show that the exposure sensitivity increases with the increase of temperature. Themaximum diffraction efficiency and the final maximum diffraction efficiency increase with the increaseof temperature when the temperature is lower than Tg (glass transition temperature), while they decreasewith the increase of temperature when the temperature is higher than Tg. The effect of the change oftemperature on the saturation refractive index modulation is very weak.     

激光剥蚀-电感耦合等离子体-原子发射光谱/质谱法分析中国古代钾玻璃组分

利用激光剥蚀电感耦合等离子体原子发射光谱(LA-ICP-AES)和激光剥蚀电感耦合等离子体质谱(LA-ICP-MS)分析了一批中国古代钾玻璃。样品表面磨去100μm以上,并通过预剥蚀去除风化影响,设计剥蚀路径以消除元素分布不均匀影响。通过钙铝及其它微量元素将钾玻璃分成3个亚类,它们可能有不同的配方及制造中心;研究发现,钾玻璃着色剂类型多样化,有单质Cu,Mn2+,Cu2+,Co2+等;系统研究了钾玻璃的稀土元素特征,成功区分了九只岭地区及风门岭地区的钾玻璃;对两种方法在古代玻璃分析中的特点进行了探讨。     

近年来光学玻璃的发展(综述)

随着光学仪器和装置的发展,对光学玻璃提出更多和更新的要求。不仅希望玻璃具有更特殊的光学常数,以利于改进和简化光学系统的设计,同时由于近来红外及紫外光学仪器飞快的发展,要求玻璃能透过特定的红外及紫外