Li2O-B2O3-P2O5系统非晶态混合骨架效应的NMR研究

用核磁共振对非晶态中B³⁺离子的微观结构进行了测定,结合Raman光谱的研究,对Li₂O-B₂O₃-P₂O₅系统非晶态的性能(电导率、密度等)在P₂O₅/B₂O₃比约等于1时产生极值的原因从理论上作了阐明。     

粉煤灰与复合添加剂的固相反应过程分析

煤灰分中主要矿物质之间的反应对灰分特性有着重要影响。本文在具有温控的小型高温反应器中对粉煤灰和复合添加剂所组成的混合灰样进行了静态煅烧试验，并对煅烧后的灰样进行了X射线衍射分析（XRD），着重讨论了温度和时间以及复合添加剂量对灰分矿相组成特性的影响。试验结果表明：当温度低于1200℃时，灰色中主要是游离态的氧化物和部分新生成的矿物如钙黄长石，硅酸二钙；当温度在1200℃-1300℃时，灰分中的主要矿物是钙黄长石，当温度在1320℃－1350℃时，灰分主要矿物是硅酸二钙，同时存在一定量的硅酸三钙、铝酸三钙、铁铝酸四钙以及硫铝酸钙。随着灰分中氧化钙的含量增加，高碱性矿物含量逐渐增大，同时高温下加热持续时间过长，部分新生成的矿物将发生分解。     

Structural Change in Au^3＋-Doped BK7 Glass Irradiated by Femtosecond Laser

We report on structural change in an Au^3＋-doped BK7 glass irradiated by an infrared femtosecond laser at 800 nm. A grating structure is inscribed in the glass sample. The glass sample is then annealed at various temperatures. Structural change of the grating is observed by an optical microscope. Absorption spectra indicate that colour centres are induced after the laser irradiation, and they decrease with increasing annealing temperature. Au nanoparticles are precipitated at high temperatures （≥ 600℃）. The mechanisms of the phenomena are discussed.     

偏振对飞秒激光辐照LiF晶体的影响

飞秒激光聚焦到LiF晶体内部, 晶体的加工形貌随偏振改变. 实验表明, 偏振方向平行于<110> 晶向时, 加工起点到表面的距离是<100>偏振下的1.08 倍; 而<110>偏振下加工终点到表面的距离是<100> 偏振下的1.01 倍. 为了解释加工形貌的偏振依赖, 建立了逆韧致辐射、雪崩电离和无辐射跃迁的模型, 首先, 价带电子通过强场电离和雪崩电离, 从激光中吸收能量跃迁到导带, 该过程用电子密度演化方程和傍轴非线性薛定谔方程描述, 求解方程得到导带电子密度; 其次, 导带电子通过无辐射跃迁过程释放能量给晶格, 由能量守恒计算出晶格温度沿激光传播方向的分布; 最后, 晶格温度超过熔点以上的区域被加工. 模拟结果显示, <110>偏振下加工起点到表面的距离是<100> 偏振下的1.03倍, 而<110>偏振下加工终点到表面的距离是<100>偏振下的0.981 倍, 与实验结果基本一致. 虽然Z扫描技术测量的非线性折射率随偏振方向变化, 但是非线性折射率的变化趋势与实验结果相反. 模拟和实验证明逆韧致辐射导致加工形貌随偏振变化.     

氧燃烧方式下痕量元素形态转化的试验和模拟研究

结合热重试验及XRF测量,采用化学热平衡分析方法对煤中易挥发的有毒痕量元素砷、铬、锑和汞在不同燃烧方式下的化学形态及分布进行了研究。计算表明,在常规燃烧方式下,痕量元素在400-1800 K的温度范围内容易蒸发,生成气相单质或氧化物。富氧燃烧条件下,高浓度的CO2(g)以及碳颗粒温度的降低在一定程度上会抑制痕量元素的蒸发,同时CO2(g)也会抑制痕量元素向气相次氧化物及单质的转化。     

混煤煤灰熔融特性及矿物质形态的研究

本文对混煤熔融特性温度进行测定，并利用X-射线衍射分析对混煤煤灰的矿物组成进行试验分析，结果表明：混煤可改变原煤的结渣程度；混煤灰熔点与混煤比不成线性关系变化是混煤煤灰的低温共熔现象所致；在变形温度T1下煤灰中矿物质莫来石对煤灰熔融特性温度影响较大，莫来石含量越高，灰熔点越高．     

新型脉冲CO2激光器预电离测量参量研究

对5 kW横流CO₂激光器脉冲预电离过程进行理论分析和实验研究.表明了预电离过程中电子密度的重要作用,它能为下一步的主放电提供良好的条件.结果表明理论分析与实验结果相符合.     

Space-Selective Precipitation of Ba2TiSi2O8 Crystals in Sm3^＋-Doped BaO-TiO2-SiO2 Glass by Femtosecond Laser Irradiation

The ferroelectric crystal Ba2TiSi2O8 with high second-order optical nonlinearity is precipitated in Sm^3＋-doped BaO-TiO2-SiO2 glass by a focused 800hm, 250 kHz and 150fs femtosecond laser irradiation. No apparent blue and red emissions are observed at the beginning, while strong blue emission due to second harmonic generation and red emission due to the f-f transitions of Sm^3＋ are observed near the focal point of the laser beam after irradiation for 25s. Micro-Raman spectra confirm that Ba2 TiSi2O8 crystalline dots and lines are formed after laser irradiation. The mechanism of the phenomenon is discussed.     

Blue-to-Orange Tunable Luminescence from Europium Doped Yttrium--Silicon--Oxide--Nitride Phosphors

Europium-doped yttrium-silicon-oxide-nitride phosphors are synthesized by carbothermal reduction and nitridation method. The crystal structure of the phosphors changed gradually from oxide Y2Si2O7 to nitride YSi3N5 state with increasing dosage of Si3N4 and carbon powder. The Y2Si2O7：Eu phosphor shows a blue emission at 465 nm with 300 nm excitation and a characteristic red emission of Eu^3＋ at 612 nm with 230 nm excitation. The YSi3N5：EU phosphor shows a broad emission band centred at 595nm with some sharp peaks of Eu^3＋ with 325nm excitation. The absorption of the studied phosphors increases from 450 to 700hm with an increment in nitrogen content. Blue-to-orange tunable luminescence is observed with 390 nm excitation.     

模拟城市生活垃圾热处理过程中Cd与Pb挥发特性研究

以Cd与Pb为研究对象,在流化床反应器上对模拟城市生活垃圾Al₂O₃热处理过程中重金属的动力学挥发特性进行了研究。分析了氧化还原条件、H₂O、HCl、SO₂及基体Al₂O₃对重金属的挥发特性影响。研究结果表明,Cd具有较强的挥发性,尤其是在通入HCl的情况下,而Pb的挥发程度则较低,同时氧浓度的增加会降低重金属的挥发。Al₂O₃颗粒中重金属的物理化学吸附以及重金属的扩散效应则同样在一定程度上抵制了重金属的释放,而SO₂的通入则在一定程度上促进了Cd与Pb的释放。