基于2,5-二溴对苯二甲酸配体的锌/钴配合物合成、晶体结构及性质

将有机物2,5-二溴对苯二甲酸(H₂L₁)和2,2′-联吡啶(L₂)作为双配体,使用溶剂热法和七水合硫酸锌(ZnSO₄·7H₂O)、六水合硝酸钴(Co(NO₃)₂·6H₂O)分别反应,得到配合物[Zn(L₁)(L₂)(H₂O)]_n(1)和配合物[Co(L₁)(L₂)(H₂O)]_n(2)。采用单晶X射线衍射、元素分析、红外光谱、紫外光谱、荧光光谱、热重分析等测试方法对这两种物质进行分析研究。单晶测试结果表明配合物1是单斜晶系,以Zn²⁺配位连接L^2-₁与L₂形成一维链状结构,各条链在分子间氢键和π…π共轭作用下有规律地堆叠形成三维网络结构。配合物2是三斜晶系,Co1离子和Co1ⁱ离子由H₂L₁上的羧酸氧原子O4和O4ⁱ连接,形成双齿螯合的配位结构单元,以Co²⁺配位连接 L^2-₁和L₂形成二维网格结构,各层在O—H…O分子间氢键和范德瓦耳斯力作用下有规律的堆叠形成三维网络结构。配合物1和2均含有芳香杂环、羧基杂环和氮杂环,具有良好的荧光性质和热稳定性,最大发射波长分别为345 nm和333 nm。     

Characteristics of black carbon aerosol in Jiaxing,China during autumn 2013

We conducted measurements of black carbon（BC） aerosol in Jiaxing,China during autumn from September 26 to November 30,2013.We investigated temporal and diurnal variations of BC,and its correlations with meteorological parameters and other major pollutants.Results showed that hourly mass concentrations of BC ranged from 0.2 to 22.0 μg/m³,with an average of 5.1 μg/m³.The diurnai variation of BC exhibited a bimodal distribution,with peaks at 07:00 and 18:00.The morning peak was larger than the evening peak.The mass percentages of BC in PM_2.5 and PM₁₀ were 7.1%and 4.8%,respectively.The absorption coefficient of BC was calculated to be 44.4 Mm^-1,which accounted for 11.1%of the total aerosol extinction.BC was mainly emitted from local sources in southwestern Jiaxing where BC concentrations were generally greater than 11 μg/m³ during the measurement period.Correlation analysis indicated that the main sources of BC were motor vehicle exhaust,and domestic and industrial combustion.     

Numerical simulation and structure optimization of a liquid–vapor separation plate condenser

Journal of Thermal Analysis and Calorimetry - Based on innovative design, a liquid–vapor separation plate condenser with excellent heat transfer performance is invented. It takes less time to...     

A post curing strategy toward the feasible covalent adaptable networks in polyacrylate latex films

The implementation of covalent adaptable networks (CANs) in general resin system is becoming attractive. In this work, we propose a simple post-curing strategy based on the core-shell structured acrylate latex for the achievement on both the improved general performance and the CANs characteristics in latex films. The building to the CANs was relied on the introduction of 4,4′-diaminophenyl disulfide as the curing agent, which cured the acetoacetoxy decorated shell polymer through the ketoamine reaction. The metathesis reaction of aromatic disulfides in the crosslinking segments enabled the thermally induced dynamic behavior of the network as revealed in the stress relaxation tests by comparison with other diamine crosslinking agents without the incorporation of disulfide. The synergism of the dynamic crosslinking of the shell polymer and static crosslinking in the core polymer contributed to the improved mechanical strength (15 MPa, strain% = 250%) and the suppressed water adsorption (~1% in 24 h of soaking) of the latex film, which exhibited above 90% of recovery in both strength and strain from a cut-off film damage within 1 h at 80°C. Moreover, the cured latex film could be recycled, and 75% of the mechanical performance was regained after three fragmentation-hot-pressing cycles. These, in addition with the feasible and environmental friendly characteristics, suggest a sustainable paradigm toward the smart thermosetting latex polymers.     

Theoretical study of (e,2e) triple differential cross sections of pyrimidine and tetrahydrofurfuryl alcohol molecules using multi-center distorted-wave method

We report theoretical studies of electron impact triple differential cross sections of two bio-molecules,pyrimidine and tetrahydrofurfuryl alcohol,in the coplanar asymmetric kinematic conditions with the impact energy of 250 eV and ejected electron energy of 20 eV at three scattering angles of-5°,-10°,and-15°.Present multi-center distorted-wave method well describes the experimental data,which was obtained by performing(e,2e)experiment.The calculations show that the secondary electron produced by the primary impact electron is strongly influenced by the molecular ionic multi-center potential,which must be considered when the low energy electron interacts with DNA analogues.     

高压下β-InSe弹性常数、电子结构的第一性原理研究

基于密度泛函理论的第一性原理计算方法,本文研究了高压对β-InSe弹性常数、机械性能和电子结构的影响.在0～20 GPa范围内,随着压力的增大,β-InSe的晶格常数、晶胞体积逐渐减小,结构参数a/a_0、c/c_0、V/V_0单调减小.在0～12 GPa范围内,弹性模量G、E、B和泊松比v随着压力增大而增大,在16 GPa时大幅减小,G、E、B分别减小了34.9%、53.3%、82.9%.随着压力增大,Se-In和In-In原子之间的电荷密度增大,Se-In原子之间的共价键增强,层间距减小.而且,β-InSe在20 GPa时带隙消失,发生了半导体向半金属的相变.     

Comparative study on transport properties of N-, P-, and As-doped SiC nanowires: Calculated based on first principles

According to the one-dimensional quantum state distribution, carrier scattering, and fixed range hopping model, the structural stability and electron transport properties of N-, P-, and As-doped SiC nanowires(N-SiCNWs, P-SiCNWs, and As-SiCNWs) are simulated by using the first principles calculations. The results show that the lattice structure of NSiCNWs is the most stable in the lattice structures of the above three kinds of doped SiCNWs. At room temperature,for unpassivated SiCNWs, the doping effect of P and As are better than that of N. After passivation, the conductivities of all doped SiCNWs increase by approximately two orders of magnitude. The N-SiCNW has the lowest conductivity. In addition, the N-, P-, As-doped SiCNWs before and after passivation have the same conductivity–temperature characteristics,that is, above room temperature, the conductivity values of the doped SiCNWs all increase with temperature increasing.These results contribute to the electronic application of nanodevices.     

砂岩方梁断裂过程区范围的实验确定方法

裂纹前端的断裂过程区是引起岩石非线性断裂及尺寸效应的主要原因。利用数字图像相关技术对砂岩开展了三点弯曲梁实验,获得观测区域高精度的全场位移和应变数据,根据断裂韧带区域水平位移和水平应变的分布特征,结合裂尖岩石颗粒变化的微观分析,提出采用裂纹尖端水平位移波动性和水平应变突变性所得到的波动系数和水平应变突变值,确定断裂过程区形状和临界尺寸的方法。结果表明:砂岩断裂过程区的形状为不规则的狭长带状区域,断裂过程区的临界长度为11~13mm,临界宽度为1.58~2.36mm。断裂过程区区域内形变在趋向裂尖时呈指数增加,但其单位区域内的形变增量呈波动状态。该方法能够更加准确判断岩石断裂过程区的范围,有助于分析岩石的非线性断裂特性。     

Comparative absorption kinetics of seven active ingredients of Eucommia ulmoides extracts by intestinal in situ circulatory perfusion in normal and spontaneous hypertensive rats

Eucommia ulmoides Oliv. (E. ulmoides) is a valuable and nourishing medicinal herb in China that has been used in the treatment of hypertension. Given the fact that most traditional Chinese medicine is mainly used to treat disease, investigating the pharmacokinetics of traditional Chinese medicines in the pathological state is more useful than that in the normal state. However, the differences in the absorption kinetics of active ingredients of E. ulmoides extract between pathological and physiological conditions have not been reported. Therefore, in this study, the rat intestinal in situ circulatory perfusion model was used to investigate the differences in absorption kinetics of seven active ingredients of E. ulmoides extract in normal and spontaneously hypertensive rats, namely, genipinic acid, protocatechuic acid, neochlorogenic acid, chlorogenic acid, cryptochlorogenic acid, (+)-pinoresinol di-O-β-D -glucopyranoside and (+)-pinoresinol 4′-O-β-D -glucopyranoside. Our results indicate that the pathological state of spontaneous hypertension may change the absorption of active components of E. ulmoides extracts, and these findings may provide a reference for improving the rational use of E. ulmoides in the clinic.