Development of a Chitosan/Nickel Phthalocyanine Composite Based Conductometric Micro-sensor for Methanol Detection

Thin-film composite of chitosan/nickel phthalocyanine (NiPc) was electrochemically deposited on the fingers of interdigitated gold electrodes, applying chronoamperometric polymerization technique. The presence of crystallized NiPc in the chitosan was confirmed by EDX and FTIR analysis. Acetone, ethanol, and methanol gas-sensing properties of the films prepared at optimum conditions were studied at atmospheric temperature, through differential measurements at an optimized frequency of 10 kHz, using a lock-in amplifier. The conductometric sensor presents the highest sensitivity of 60.2 μS.cm⁻¹(v/v) for methanol and 700 ppm as the limit of detection. For validation, the methanol content of a commercial rubbing alcohol was determined.     

气相输运沉积制备c轴择优取向的碘化铋薄膜

铋基卤化物材料因其无毒和优良的光电性能而显示出巨大的应用潜力。BiI₃作为一种层状重金属半导体,已被用于X射线检测、γ射线检测和压力传感器等领域,最近其作为一种薄膜太阳能电池吸收材料备受关注。本文采用简单的气相输运沉积(VTD)法,以BiI₃晶体粉末作为蒸发源,在玻璃基底上得到高质量c轴择优取向的BiI₃薄膜。并通过研究蒸发源温度和沉积距离对薄膜物相和形貌的影响,分析了BiI₃薄膜择优生长的机理。结果表明VTD法制备的BiI₃薄膜属于三斜晶系,其光学带隙为~1.8 eV。沉积温度对薄膜的择优取向有较大影响,在沉积温度低于270 ℃时,沉积的薄膜具有沿c轴择优取向生长的特点,超过此温度,c轴择优取向生长消失。在衬底温度为250 ℃、沉积距离为15 cm时制备的薄膜结晶性能最好,晶体形貌为片状八面体。     

雾化辅助化学气相沉积法氧化镓薄膜生长研究

采用自主设计搭建的雾化辅助化学气相沉积系统设备,开展了Ga₂O₃薄膜制备及其特性研究工作。通过X射线衍射研究了沉积温度、系统沉积压差对Ga₂O₃薄膜结晶质量的影响。结果表明,Ga₂O₃在425~650 ℃温度区间存在物相转换关系。随着沉积温度从425 ℃升高至650 ℃,薄膜结晶分别由非晶态、纯α-Ga₂O₃结晶状态向α-Ga₂O₃、β-Ga₂O₃两相混合结晶状态改变。通过原子力显微镜表征探究了生长温度对Ga₂O₃薄膜表面形貌的影响,从475 ℃升高至650 ℃时,薄膜表面粗糙度由26.8 nm下降至24.8 nm。同时,高分辨X射线衍射仪测试表明475 ℃、5 Pa压差条件下的α-Ga₂O₃薄膜样品半峰全宽仅为190.8″,为高度结晶态的单晶α-Ga₂O₃薄膜材料。     

光纤基底TiNi形状记忆合金薄膜制备工艺

将TiNi基记忆合金薄膜与光纤相结合可制成智能化、集成化且成本经济的微机电系统和微传感器件.本文采用磁控溅射法在二氧化硅光纤基底上制备TiNi记忆合金薄膜,系统讨论了溅射工艺参数以及后续退火处理对薄膜质量的影响.采用自研制光纤镀膜掩膜装置在直径为125μm的光纤圆周表面上形成均匀薄膜.实验表明:在靶基距、背底真空度、Ar气流量和溅射时间一定的条件下,溅射功率存在最佳值;溅射压强较大时,薄膜沉积速率较低,但薄膜表面粗糙度较小.进行退火处理后,薄膜形成较良好的晶体结构,Ti_49.09Ni_50.91薄膜中马氏体B19′相和奥氏体B2相共存,但以B19′为主.根据本文研究结果,在玻璃光纤基底上制备高质量的TiNi基记忆合金薄膜是可实现的,本工作为下一步研制微机电系统和微型传感器做了基础准备.     

Analysis of a new multispecies tumor growth model coupling 3D phase-fields with a 1D vascular network

In this work, we present and analyze a mathematical model for tumor growth incorporating ECM erosion, interstitial flow, and the effect of vascular flow and nutrient transport. The model is of phase-field or diffused-interface type in which multiple phases of cell species and other constituents are separated by smooth evolving interfaces. The model involves a mesoscale version of Darcy’s law to capture the flow mechanism in the tissue matrix. Modeling flow and transport processes in the vasculature supplying the healthy and cancerous tissue, one-dimensional (1D) equations are considered. Since the models governing the transport and flow processes are defined together with cell species models on a three-dimensional (3D) domain, we obtain a 3D–1D coupled model.     

Imposing accurate wall boundary conditions in corrective‐matrix‐based moving particle semi‐implicit method for free surface flow

Corrective matrix that is derived to restore consistency of discretization schemes can significantly enhance accuracy for the inside particles in the Moving Particle Semi‐implicit method. In this situation, the error due to free surface and wall boundaries becomes dominant. Based on the recent study on Neumann boundary condition (Matsunaga et al, CMAME, 2020), the corrective matrix schemes in MPS are generalized to straightforwardly and accurately impose Neumann boundary condition. However, the new schemes can still easily trigger instability at free surface because of the biased error caused by the incomplete/biased neighbor support. Therefore, the existing stable schemes based on virtual particles and conservative gradient models are applied to free surface and nearby particles to produce a stable transitional layer at free surface. The new corrective matrix schemes are only applied to the particles under the stable transitional layer for improving the wall boundary conditions. Three numerical examples of free surface flows demonstrate that the proposed method can help to reduce the pressure/velocity fluctuations and hence enhance accuracy further.     

石墨基液流电池复合双极板

液流电池是一种安全性高、使用寿命长、可扩展的大规模储能系统,可以协助电网调峰储能,提高能源利用率,发展前景广阔。双极板是液流电池的重要组成部分。功能上起到了分隔、串联电池、传导电流、为电堆提供结构支撑等作用。从成本构成角度看,双极板的价格占电堆成本的比重也较大。开发高性能、低成本的双极板对加快液流电池的商业化应用具有重要意义,也是目前业界的迫切需求。虽然文献上报道了许多针对液流电池双极板开发的工作,但是目前高性能、低成本的液流电池双极板产品仍无法充分满足市场需求。本文着重介绍了石墨基复合双极板的研究现状,介绍了材料选择、工艺流程对关键性能的影响,对相关工作进行了评述,并为液流电池双极板的开发提出了建议。     

基于抛光基材的热蒸镀铜箔生长高平整单层石墨烯薄膜

在石墨烯的化学气相沉积工艺中,铜箔是决定石墨烯薄膜质量的重要因素。传统铜箔由于制备工艺的限制,存在大量的缺陷,导致石墨烯薄膜的成核密度较高。本工作选用抛光铝板、抛光不锈钢板、微晶玻璃和SiO₂/Si作为基材,用热蒸镀法制备了不同粗糙度的铜箔,并详细讨论了以该系列铜箔生长高平整度石墨烯薄膜的条件及铜箔对石墨烯薄膜品质的影响。实验结果表明,铜箔以(111)取向为主,与基材分离后,表面具有纳米级平整度。在生长石墨烯后,从SiO₂/Si剥离的铜箔成核密度是4种基材中最小的。同时,从SiO₂/Si剥离的铜箔晶体结构变化最不明显,具有良好的结晶性,表面几乎不存在铜晶界缺陷。当压强为3 000 Pa,氢气和甲烷流速分别为300 mL/min和0.5 mL/min时,可以获得约1 mm横向尺寸的石墨烯单晶晶畴。     

Interface‐fitted moving mesh method for axisymmetric two‐phase flow in microchannels

A boundary‐fitted moving mesh scheme is presented for the simulation of two‐phase flow in two‐dimensional and axisymmetric geometries. The incompressible Navier‐Stokes equations are solved using the finite element method, and the mini element is used to satisfy the inf‐sup condition. The interface between the phases is represented explicitly by an interface adapted mesh, thus allowing a sharp transition of the fluid properties. Surface tension is modelled as a volume force and is discretized in a consistent manner, thus allowing to obtain exact equilibrium (up to rounding errors) with the pressure gradient. This is demonstrated for a spherical droplet moving in a constant flow field. The curvature of the interface, required for the surface tension term, is efficiently computed with simple but very accurate geometric formulas. An adaptive moving mesh technique, where smoothing mesh velocities and remeshing are used to preserve the mesh quality, is developed and presented. Mesh refinement strategies, allowing tailoring of the refinement of the computational mesh, are also discussed. Accuracy and robustness of the present method are demonstrated on several validation test cases. The method is developed with the prospect of being applied to microfluidic flows and the simulation of microchannel evaporators used for electronics cooling. Therefore, the simulation results for the flow of a bubble in a microchannel are presented and compared to experimental data.     

Cytotoxic dimeric half-sandwich Ru(II), Os(II) and Ir(III) complexes containing the 4,4′-biphenyl-based bridging ligands

A series of dinuclear half-sandwich Ru(II), Os(II) and Ir(III) complexes [Ru₂(μ-Lⁿ)(η⁶-pcym)₂Cl₂](PF₆)₂ ( 1 , 4 ), [Os₂(μ-Lⁿ)(η⁶-pcym)₂Cl₂](PF₆)₂ ( 2 , 5 ) and [Ir₂(μ-Lⁿ)(η⁵-Cp*)₂Cl₂](PF₆)₂ ( 3 , 6 ), based on 4,4′-biphenyl-based bridging Schiff base ligands N,N′-(biphenyl-4,4′-diyldimethylidyne)bis-2-(pyridin-2-yl)methanamine (L¹; for 1 – 3 ) and N,N′-(biphenyl-4,4′-diyldimethylidyne)bis-2-(pyridin-2-yl)ethanamine (L²; for 4 – 6 ) is reported; pcym = 1-methyl-4-(propan-2-yl)benzene, Cp* = pentamethylcyclopentadienyl. The complexes were characterized by relevant analytical techniques (i.e. elemental analysis, FT-IR, NMR, ESI-MS), and their in vitro cytotoxicity was assessed at six cancerous and two non-cancerous (healthy) human cell lines. Overall, complexes 4 – 6 , containing the L² bridging ligand, revealed higher cytotoxicity as compared with 1 – 3 and, thus, they were studied in greater detail. The best-performing complex 6 exceeded at least twice the in vitro cytotoxicity of cisplatin and showed high selectivity towards the cancer cells over the normal ones, including the primary culture of human hepatocytes. In contrast to cisplatin, complexes 4 – 6 did not induce the cell cycle modification of the treated A2780 human ovarian carcinoma cells (studied by flow cytometry and Western blot analysis). High levels of superoxide anion were induced by complexes 4 – 6 at the A2780 cells. The levels of activated forms of Caspase-3 and Caspase-8 at the A2780 cells treated by Ru(II) complex 4 were comparable with cisplatin, while complexes 5 and 6 had only a minor effect on activation of these caspases.