Validation of a robust and rapid liquid chromatography tandem mass spectrometric method for the quantitative analysis of navitoclax

The Bcl-2 family small molecule inhibitor navitoclax is being clinically evaluated to treat multiple cancers including lymphoid malignancies and small cell lung cancer. A sensitive and reliable method was developed to quantitate navitoclax in human plasma using liquid chromatography with tandem mass spectrometry with which to perform detailed pharmacokinetic studies. Sample preparation involved protein precipitation using acetonitrile. Separation of navitoclax and the internal standard, navitoclax-d8, was achieved with a Waters Acquity UPLC BEH C₁₈ column using isocratic flow over a 3 min total analytical run time. A SCIEX 4500 triple quadrupole mass spectrometer operated in positive electrospray ionization mode was used for the detection of navitoclax. The assay range was 5–5,000 ng/ml and proved to be accurate (89.5–104.9%) and precise (CV ≤ 11%). Long-term frozen plasma stability for navitoclax at −70°C was at least 43 months. The method was applied for the measurement of total plasma concentration of navitoclax in a patient receiving a 250 mg daily oral dose.     

Development of a Chitosan/Nickel Phthalocyanine Composite Based Conductometric Micro-sensor for Methanol Detection

Thin-film composite of chitosan/nickel phthalocyanine (NiPc) was electrochemically deposited on the fingers of interdigitated gold electrodes, applying chronoamperometric polymerization technique. The presence of crystallized NiPc in the chitosan was confirmed by EDX and FTIR analysis. Acetone, ethanol, and methanol gas-sensing properties of the films prepared at optimum conditions were studied at atmospheric temperature, through differential measurements at an optimized frequency of 10 kHz, using a lock-in amplifier. The conductometric sensor presents the highest sensitivity of 60.2 μS.cm⁻¹(v/v) for methanol and 700 ppm as the limit of detection. For validation, the methanol content of a commercial rubbing alcohol was determined.     

The effect of molecular weight on the separation of semiconducting single‐walled carbon nanotubes using poly(2,7‐carbazole)s

The use of selective interactions between conjugated polymers and single‐walled carbon nanotubes has emerged as a promising method for the separation of nanotubes by electronic type. Although much attention has been devoted to investigating polyfluorenes and their ability to disperse semiconducting carbon nanotubes under specific conditions, other polymer families, such as poly(2,7‐carbazole)s, have been relatively overlooked. Poly(2,7‐carbazole)s have been shown to also preferentially interact with semiconducting carbon nanotubes, however a detailed investigation of polymer parameters, such as molecular weight, has not been performed. We have prepared seven different molecular weights of a poly(2,7‐carbazole), from short chain oligomers to high molecular weight polymers, and have investigated their effectiveness at dispersing semiconducting single‐walled carbon nanotubes. Although all polymer chain lengths were able to efficiently exfoliate carbon nanotube bundles using a mild dispersion protocol, only polymers above a certain threshold molecular weight (M_n ～ 27 kDa) were found to exhibit complete selectivity for semiconducting nanotubes, with no observable signals from metallic species. Additionally, we found the quality of separation to be strongly dependent on the ratio of polymer to carbon nanotube. Contrary to previous reports, we have found that an excess of poly(2,7‐carbazole) leads to incomplete removal of metallic carbon nanotubes. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 2510–2516