Development of a Chitosan/Nickel Phthalocyanine Composite Based Conductometric Micro-sensor for Methanol Detection

Thin-film composite of chitosan/nickel phthalocyanine (NiPc) was electrochemically deposited on the fingers of interdigitated gold electrodes, applying chronoamperometric polymerization technique. The presence of crystallized NiPc in the chitosan was confirmed by EDX and FTIR analysis. Acetone, ethanol, and methanol gas-sensing properties of the films prepared at optimum conditions were studied at atmospheric temperature, through differential measurements at an optimized frequency of 10 kHz, using a lock-in amplifier. The conductometric sensor presents the highest sensitivity of 60.2 μS.cm⁻¹(v/v) for methanol and 700 ppm as the limit of detection. For validation, the methanol content of a commercial rubbing alcohol was determined.     

Effect of oxygen on regulation of properties of moderately boron-doped diamond films

Regulation of oxygen on properties of moderately boron-doped diamond films is fully investigated. Results show that, with adding a small amount of oxygen (oxygen-to-carbon ratio < 5.0%), the crystal quality of diamond is improved, and a suppression effect of residual nitrogen is observed. With increasing ratio of O/C from 2.5% to 20.0%, the hole concentration is firstly increased then reduced. This change of hole concentration is also explained. Moreover, the results of Hall effect measurement with temperatures from 300 K to 825 K show that, with adding a small amount of oxygen, boron and oxygen complex structures (especially B₃O and B₄O) are formed and exhibit as shallow donor in diamond, which results in increase of donor concentration. With further increase of ratio of O/C, the inhibitory behaviors of oxygen on boron leads to decrease of acceptor concentration (the optical emission spectroscopy has shown that it is decreased with ratio of O/C more than 10.0%). This work demonstrates that oxygen-doping induced increasement of the crystalline and surface quality could be restored by the co-doping with oxygen. The technique could achieve boron-doped diamond films with both high quality and acceptable hole concentration, which is applicable to electronic level of usage.     

Diffusion Model of a Non-Integer Order PIγ Controller with TCP/UDP Streams

In this article, a way to employ the diffusion approximation to model interplay between TCP and UDP flows is presented. In order to control traffic congestion, an environment of IP routers applying AQM (Active Queue Management) algorithms has been introduced. Furthermore, the impact of the fractional controller PIγ and its parameters on the transport protocols is investigated. The controller has been elaborated in accordance with the control theory. The TCP and UDP flows are transmitted simultaneously and are mutually independent. Only the TCP is controlled by the AQM algorithm. Our diffusion model allows a single TCP or UDP flow to start or end at any time, which distinguishes it from those previously described in the literature.     

基于TOPSIS模型的机场网络节点重要度评估

在机场网络中单个机场节点的失效往往会对其他的节点产生影响,特别是关键节点的失效会波及整个网络.准确客观的识别重要节点机场关乎整个机场网络的安全运营.本文分析了机场网络拓扑特性中的度、集聚系数和接近度指标,考虑了机场旅客吞吐量和所在城市人口等交通经济特性指标,使用熵权法确定权重的基础上,应用TOPSIS法构建综合评价体系模型,最后以华东地区机场网络为例进行节点重要度排序.结果表明与单一指标的评估结果相比,该方法更加全面客观的确定不同属性指标的权重,避免了不同指标取值的差异性,使评价更加全面,更符合机场网络实际运营情况.     

Negative thermal expansion in NbF_3 and NbOF_2:A comparative theoretical study

Thermal expansion control is always an obstructive factor and challenging in high precision engineering field. Here,the negative thermal expansion of Nb F_3 and Nb OF_2 was predicted by first-principles calculation with density functional theory and the quasi-harmonic approximation(QHA). We studied the total charge density, thermal vibration, and lattice dynamic to investigate the thermal expansion mechanism. We found that the presence of O induced the relatively strong covalent bond in Nb OF_2, thus weakening the transverse vibration of F and O in Nb OF_2, compared with the case of Nb F_3.In this study, we proposed a way to tailor negative thermal expansion of metal fluorides by introducing the oxygen atoms.The present work not only predicts two NTE compounds, but also provides an insight on thermal expansion control by designing chemical bond type.     

In vitro investigation of cartilage regeneration properties of polymeric ceramic hybrid composite

There would be a major effect on the cartilage regeneration characteristics of ceramic material in a substrate implant requiring biologically active biomaterials and the reinforcement phase. At this moment, we produced collagen-hyaluronic acid @ hydroxyapatite-halloysite nanotube-single walled carbon nanotube composites, which is a successful technique for making a scaffold with a superior counter for cartilage property. FTIR, XRD, and SEM-EDAX were used to perform morphological and structural studies. The prepared composite's surface feature was investigated and discovered by HRTEM-SAED analysis, and it observed porous nature. The simulated body fluids (SBF) assessment of the materials was noticed their bioactivity and chondrocytes to determine their biocompatibility. Hybrid composite displayed promise for cartilage tissue engineering despite mesenchymal stem cells compatibility effect and magnificently demonstrated an antibacterial effect without antibiotics. The live/dead cells analysis shows that the composite can significantly improve mesenchymal stem cells, and the composite has the potential ability for cartilage regeneration. The above characteristics make the material quite interesting and important in the area for regenerative medicinal uses.     

Stability of Multiplier Ideal Sheaves

Chinese Annals of Mathematics, Series B - In the present article, the authors find and establish stability of multiplier ideal sheaves, which is more general than strong openness.     

Characterization and gas adsorption of a novel three‐dimensional metal–organic framework (MOF) generated from a new polydentate fluorene‐bridged ligand

A polydentate ligand bridged by a fluorene group, namely 9,9‐bis(2‐hydroxyethyl)‐2,7‐bis(pyridin‐4‐yl)fluorene (L), has been prepared under solvothermal conditions in acetonitrile. Crystals of the three‐dimensional metal–organic framework (MOF) poly[[[μ₃‐9,9‐bis(2‐hydroxyethyl)‐2,7‐bis(pyridin‐4‐yl)fluorene‐κ³N:N′:O]bis(methanol‐κO)(μ‐sulfato‐κ²O:O′)nickel(II)] methanol disolvate], {[Ni(SO₄)(C₂₇H₂₄N₂O₂)(CH₃OH)]·2CH₃OH}_n, (I), were obtained by the solvothermal reaction of L and NiSO₄ in methanol. The ligand L forms a two‐dimensional network in the crystallographic bc plane via two groups of O—H…N hydrogen bonds and neighbouring two‐dimensional planes are completely parallel and stack to form a three‐dimensional structure. In (I), the Ni^II ions are linked by sulfate ions through Ni—O bonds to form inorganic chains and these Ni‐containing chains are linked into a three‐dimensional framework via Ni—O and Ni—N bonds involving the polydentate ligand L. With one of the hydroxy groups of L coordinating to the Ni^II atom, the torsion angle of the hydroxyethyl group changes from that of the uncoordinated molecule. In addition, the adsorption properties of (I) with carbon dioxide were investigated.