Structural and Electrical Characteristics of Pb（Zr0.53,Ti0.47）O3 Thin Films Deposited on Si （100） Substrates

Pb(Zr0.53, Ti0.47)O3 (PZT) films were directly deposited on Si substrates without a buffer layer by pulsed laser deposition. Only(110)-oriented PZT peaks (other than Si substrate peaks) were observed from the XRD data. The electrical properties of the PZT/Si capacitor were characterized in terms of both the capacitance versus voltage (C-V) and current versus voltage (I-V) measurements. The clockwise trace of the C-V curve shows ferroelectric polarization switching, as is expected. From the I-V curves, the Schottky emission and spacecharge-limited-current behaviour are found to be the mainly leakage current mechanism in a certain electric field range in the negative and positive bias, respectively.     

激光淀积YBa2Cu3O7外延超导薄膜

利用准分子脉冲激光成功地在(100)SrTiO_3与(100)Y-ZrO_2衬底上淀积了 YBa_2Cu_3O_7超导薄膜,T_c(R=0)>90K,J_c(T<82K)>1×10~6A/cm~2.研究了衬底温度对外延YBa_2Cu_3O_7薄膜超导性能及结构的影响.     

�����װ�õĻԹ�ŵ�����

在四阳极直流放电装置上,测量并分析了辉光放电的电流-电压和发光特征随气压的变化关系。结果表明,采用稳流放电模式比稳压放电具有更宽的稳定放电气压和电流范围,能在从1～800Pa的较宽气压范围内实现氦气辉光放电,放电电流可达到500mA左右。随着电极表面亮斑的变化,对于同一气压,在低电流区,放电电压几乎成指数增长;随电流增大,电压的增长速度变缓;对于高的气压,碰撞频率的增大使得电压随电流升高的速率变小。分析表明,放电处于异常辉光区。从放电管的CCD图像可以看出,对于同一放电电流,随气压的升高,等离子体往阴极收缩。     

可用于激光核聚变的闪烁中子探测器

在当前激光核聚变实验中,中子集中在短时间内出现、且产额低。为适应这种特点,要求探测器的效率高,分辨时间短。利用闪烁中子探测器探测激光核聚变所产生的中子,能测定中子产额,记录中子能量,而且探测效率高,分辨时间短。缺点是易受γ射线、X射线的干扰。     

X光光电子能谱法测定胶片中氟,硅和铝的研究

应用Ｘ光光电子能谱法测定了几种彩色胶片表面层中氟的１ｓ能级的结合能；分别比较了水处理前后、溅蚀前后胶片护膜层氟的变化，表明氟化物分布在护膜最表层，是一种易溶于水的氟化物；测定了彩色片护膜层所含硅２ｐ能级的结合能，与自制彩色片护膜层测定结果比较，优质片含一种较多负电性，用与自制片的无机硅不同的硅化物作毛面剂；对溅蚀前后优质片和自产彩色片中的硅铝比变化进行比较，提出优质彩色片Ｆ－４００的护膜层可能是双     

刺五加味中黄酮类化合物的分析

利用电喷雾多级串联质谱（ESI－MS^n)技术，分析了刺五加叶中黄酮类化合物，并根据黄酮类化合物的特征显色反应，采用紫外－可见分光光度法，对刺五加叶中总黄酮的含量进行了测定。分析结果表明：刺五加叶含有槲皮素及其相关的黄酮甙类化合物，其含量达37．25％。     

一种适用于无程序升温的气液色谱仪的综合填充柱

目前,我国有一半以上的气液色谱仪没有程序升温装置,要在恒温下对不同沸点和不同极性的混合物高效分离,选择理想的柱子就成为一个关键问题,特别是在裂解色谱法中,高聚物裂解出的产物品种多,分子量范围宽,极性大小不一的情况下选择高效分离柱就更为重要。为了克服色谱仪无程序升温装置的缺陷,我们选用了三段串联填充柱,在恒温下能使复杂的裂解产物得到分离,并已成功地用于多种高聚物裂解产物的分离。     

Dispersion state and catalytic properties of vanadia species on the surface of V_2O_5/TiO_2 catalysts

The dispersion state and catalytic properties of anatase-supported vanadia species are studied by means of X-ray diffraction (XRD), laser Raman spectroscopy (LRS), H2 temperature-programmed reduction (TPR) and the selective oxidation of o-xylene to phthalic anhydride. The almost identical values of the experimental dispersion capacity of V2O5 on anatase and the surface vacant sites available on the preferentially exposed (001) plane of anatase suggest that the highly dispersed vanadium cations are bonded to the vacant sites on the surface of anatase as derived by the incorporation model. When the loading amount of V2O5 is far below its dispersion capacity, the dispersed vanadia species might mainly consist of isolated VOx species bridging to the surface through V-O-Ti bonds. With the increase of V2O5 loading the isolated vanadia species interact with their nearest neighbors (either isolated or polymerized vanadia) through bridging V-O-V at the expenses of V-O-Ti bonds, resulting in the increase of the ra     

Synthesis and Luminescence Property of 4,4＇-Bis（2,2-di（4-fluorophenyl）vinyl）biphenyl for Organic Blue-Light-Emitting Diodes

The novel fluorinated distyrylarylene, 4,4＇-bis（2,2-di（4-fluorophenyl）vinyl）biphenyl （DFPVBi）, was synthesized and fully characterized. The structure was confirmed with IR, 1↑H NMR, 13↑C NMR, 19↑F NMR and MS analyses. Its electronic and photoluminescence properties were investigated by UV-Vis absorption, cyclic voltammetry and fluorescence spectroscopy. The energy levels of the highest occupied molecular orbital （HOMO） and the lowest unoccupied molecular orbital （LUMO） are --5.77 and --2.75 eV, respectively. The electroluminescence proper- ties of the organic light-emitting diode fabricated by DFPVBi were also studied. The device exhibits a pure blue emission peaked at 454 nm, which indicates a maximum luminance of 5872 cd/m ^2 at 14.2 V and a maximum current efficiency of 2.82 cd/A at 10V, respectively.     

接触法制硫酸的模型

当研究制取硫酸的问题时,教师不得不基本上只利用图表,在最好的情况下,也不过是演示一下SO_2氧化为SO_3,因此,教师往往难于把硫酸的生产过程给予学生,我们所拟制的接触法制硫酸的活动模型,能够表明接触装置的和吸收系统的工作(图1)。