Y2O3 and MgO co-doped ceria based electrolytes

Electrolytes of Ce_1-x-y Y _x Mg _y O_2-0.5x-y were prepared with citrate method and were characterized by inductively coupled plasma-atomic emission spectrometry, energy dispersive spectrometry, powder X-ray diffraction, and impedance spectroscopy. The effect of composition on the structure, conductivity, and stability of the electrolytes were investigated. When 0≤x≤ about 0.2 and 0≤y≤ about 0.05, the electrolytes were all single phase materials of ceria-based solid solution. However, when y> about 0.05, the electrolytes became two-phase materials, Y³⁺ and Mg²⁺ co-doped ceria-based solid solution and free MgO. The sample with nominal composition of Ce_0.815Y_0.065Mg_0.12O_2-d showed ionic conductivity at 973 K close to or even a little higher than that of similarly prepared Ce_0.9Gd_0.1O_1.95, but had lower cost of raw materials and a little better stability in reducing atmosphere. The existing of free MgO improved the stability of the electrolytes in reducing atmosphere, but too much free MgO reduced the conductivity.     

Fe(III)与2,3-二羟基苯磺酸钠配位反应的动力学研究

[H+]在0.01～0.70mol?L-1范围内,离子强度为1.00mol?L-1,[Fe(III)]>>[配体]、[H+]>>[配体]的条件下,研究了Fe(III)与2,3-二羟基苯磺酸钠(Tiron)的配位反应.发现当[H+]≤3.00×10-2mol?L-1时,[Fe(III)]2对反应速率有明显的贡献.求得了相关反应的动力学参数,从而揭示了FeOH2+和FeOH24+与Tiron配位的解离反应途径及FeOH32+的缔合反应机制,并提出了该配位反应的可能机理.     

七-O-乙酰基-β-乳糖异硫氰酸酯的合成、表征及电化学研究

本文合成了并培养出了七-O-乙酰基—β—乳糖异硫氰酸酯的单晶，用X射线衍射分析了其晶体结构。结果表明，晶体为正交晶系，P2₁2₁2₁空间群，a＝1．23282(7)，b＝1．80012(10)，c＝1.85230(10) nm，α＝β＝γ＝90°，V＝4．1107(4) nm³，Z＝4。电化学实验观测到单链DNA和双链DNA对该化合物的峰电流均有明显降低作用，表明化合物与DNA发生了静电作用。     

Hydroxyapatite gels and nanocrystals prepared through a sol-gel process

We have investigated the effect of the Ca/P molar ratio on the structural and morphological properties of hydroxyapatite (HA) gels and nanocrystals. The sol-gel process was carried out in aqueous, and alternatively in alcoholic medium (50% water-50% ethanol), at 37°C. Gel samples were obtained by drying the sols at 37°C or at 80°C, whereas powder samples were obtained by filtering the sols. Heat treatment at temperatures as low as 300°C is enough to obtain pure HA from the gels with a Ca/P molar ratio of 1.00 and 1.67. At variance, heat treatment of the gels with a Ca/P of 2.55 always produces secondary phases. The degree of crystallinity of HA increases with the Ca/P molar ratio of the sols, and it is slightly affected by the presence of ethanol in the precipitation medium. Filtering of the sols provides powders constituted of nanocrystalline HA that exhibit degree of crystallinity, crystal morphology and thermal stability closely related to the sols composition.     

氧化铬着色的随角异色颜料的制备与性能研究

采用具有干涉色的云母钛作为基质材料,以氧化铬膜着色,制备了随角异色功能颜料。用XRD、X-RiteMA86Ⅱ5角度分光光度计对产物进行测试分析,研究了不同的基质材料对颜料随角异色效果的影响,分析比较了黑白两种不同背底对颜料的明度和变化效果的影响。结果表明,改变基质材料的干涉色可以制得不同变色效果的随角异色颜料,颜料在黑色背底上的明度值变化范围较大,颜料的变色效果比较明显。     

Fe／ZrO_2气凝胶超细粒子催化剂的制备、表征及F－T反应性能的研究

用超临界流体干燥法制备出大孔高比表面高分散态Ｆｅ／ＺｒＯ_２气凝胶超细粒子催化剂，研究了在其制备过程中织构性质、颗粒大小、体相和表面结构的变化，并与普通浸渍法制备的Ｆｅ／ＺｒＯ_２催化剂作了对比。对几种Ｆｅ／ＺｒＯ_２催化剂的Ｆ－Ｔ反应性能考察表明，Ｆｅ／ＺｅＯ_２气凝胶超细催化剂显示出高的反应活性；随载体ＺｒＯ_２颗粒尺寸减小，活性组分铁的分散度变大，其颗粒尺寸变小，催化剂比表面积增大，反应活性增大，甲烷和低碳烃生成量增加，重质组分减少，认为产物烃分布主要受催化剂活性相颗粒尺寸效应制约。     

流动注射分光光度法测定微量铜的研究

研究了在ＴｒｉｔｏｎＮ－１０１存在下，２－羟基－３－羧基－５－磺酸基苯重氮氨基偶氮苯（ＨＣＳ－ＤＡＡ）显色流动注射光度测定微量铜的新方法，用ｐＨ０．４～１１．５Ｎａ２Ｂ４Ｏ７－ＮａＯＨ缓冲溶液作载流，ＨＣＳＤＡＡ和ＴｒｉｔｏｎＮ－１０１的混合试剂作试剂流，采双道流路，５３０ｎｍ检测反应生成红色配合物，方法线性范围是０．０２４～０．２０μｇ／ｍＬ，检出限为８ｎｇ／ｍＬ，进样频率为１００样次／ｈ，直接     

Ring expansion of 4,4-diethyl-1,2-dithiolane in the reaction with butylacetylene. Involvement of anion and radical intermediates

The action of lithium butyl acetylenide in THF causes 4,4-diethyl-1,2-dithiolane to undergo ring-opening to form 2,2-diethyl-4-thia-5-decyne-1-thiol, which cyclizes to give 2-butyl-6,6-diethyl-5,6-dihydro-1,4-dithiepin by either a homolytic or a nucleophilic mechanism. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 204–206, January, 1997.     

固相配位化学反应研究——ⅩⅩⅩⅩⅠ.[Co(NH_3)_5(H_2O)]Br_3,[Cr(NH_3)_5(H_2O)](NO_3)_3与无机盐KY(Y=Cl,Br,Ⅰ)的固相反应动力学研究

本文主要用气相色谱逸出气体分析方法,借助于红外、紫外可见漫反射谱等手段研究了[Co(NH_3)_5(H_2O)]Br_3、[Cr(NH_3)_5(H_2O)](NO_3)_3与无机盐KY(Y=Cl,Br,Ⅰ)的固相反应,计算了失水与失氨的动力学参数,发现第一步反应失水生成一取代中间产物,其活化能与外加阴离子无关,为S_N1过程。第二步失氨反应活化能与中心离子M以及取代基Y有关,当M=Co(Ⅲ)时,反应体系的失氨活化能大小有下列顺序:Cl>Br>Ⅰ(E值分别为187、155、98kJ·mol~(-1)),M=Cr(Ⅲ)时则正好相反:Ⅰ>Br>Cl(E值分别为213、146、79 kJ·mol~(-1))。