Investigation on the Fabrication of Photonic Crystal Fibre

Effects of draw parameters, such as drawing temperature and feed speed, on the capillaries and the geometry of the final photonic crystal fibre （PCF） are investigated. Inert gas pressurization is introduced in the preform during the fibre drawing process to finely control the geometry of the PCF so that good uniform in transversal and longitudinal of the final PCF can be realized. Due to the introduction of a special method, the drawing temperature is increased over 1900℃ and the strength of the PCF is enhanced.     

椭圆孔光子晶体光纤的本地正交函数模型

提出了一种用于分析椭圆孔光子晶体光纤的正交函数模型.发展了一种新型超格子的构造方法，将光子晶体光纤的横向介电常数表示为两种周期性结构叠加，这两种周期性结构分别用余弦函数展开；同时将横向电场以Hermite-Gaussian函数展开.利用正交函数的性质，将全矢量波动方程转化为矩阵本征值问题，求得两偏振模式传输常数.利用此模型可以研究圆孔及椭圆孔光子晶体光纤的模式特性、色散特性、偏振特性等. 关键词： 光子晶体光纤 超格子 正交函数 本征值问题     

基于Lyot型光纤消偏器特性的研究

在对Lyot型光纤消偏器的特性进行系统的理论分析的基础上，首次推导出并讨论了其偏振度与相应变量之间的函数关系。实际制作了偏振度为2．0％的Lyot型光纤消偏器，并由此验证了理论分析结果。     

Design and Fabrication of an Er-Doped Silica Optical Fiber with Six Photosensitive Subcores

A type of multi-core Er-doped photosensitive silica optical fiber （MC-EDPF） is proposed and fabricated, in which a high consistency Er-doped core is surrounded by six high consistency Ge-doped cores. The multi-core design can overcome the difficulties encountered in the design and fabrication of single-core EDPFs through a modified chemical vapor deposition method combined with solution doping technology, and there is a conflict between high consistency Er doping and high consistency Ce doping. The absorption of MC-EDPFs achieved 15.876dB/m at 1550mm and lOdB/m at 98Ohm. The refleetivity of the fiber Bragg gratings （FBCs） written directly on the MC-EDPFs is as much as 96.84%.     

8 × 10-Gb/s transmission system over 1500 km on G.652 fiber dispersion compensated by chirped fiber gratings

The impact of dispersion on system performance in- creases as the operating bandwidth increases and also as the transmission distance and bit rate increase. To overcome the dispersion limit, various dispersion com- pensation techniques have been used. Dispersion com- pensation fiber (DCF) has been used popularly. How- ever, DCF is expensive. Sometimes, erbium-doped fiber amplifier (EDFA) is needed to compensate for the in- sertion loss of the DCF and the costs are high. Besides that, the…     

基于微环谐振器阵列与马赫-曾德尔干涉仪的反射型滤波器性能分析

理论分析了一种将微环谐振器阵列与马赫-曾德尔干涉仪(MZI)相结合实现的反射型滤波器结构。将此结构类比为两类四端口网络级联模型,利用传输矩阵法推导出其通用函数形式,并给出单环及三环结构下的能量反射系数具体公式。通过传输函数矩阵模拟计算了取不同耦合系数值情况下的反射谱形变化,给出了原因分析及讨论。并模拟了引入传输损耗对三环结构谐振峰反射率的影响。数值结果表明:适当选取直波导与微型环以及微型环间耦合系数幅值时,此结构能够作为反射型滤波器件应用于密集波分复用(DWDM)系统,也可实现激光器反射镜面的功能;由于传输损耗增加而引起的谐振峰反射率下降程度依赖于所选取的耦合系数值。     

Multiwavelength All-Optical Clock Recovery of Non-Return-to-Zero Data

A novel scheme of all-optical clock recovery from mutiwavelength non-return-to-zero （NRZ） data stream is proposed and demonstrated. The chirp induced by a chirped fibre Bragg grating and a semiconductor optical amplifier is used to enhance the clock. The clock is recovered after injecting the enhanced signal into the scheme based on the stimulated Brillouin scattering. The experiment is carried out and the dual-wavelength clock is recovered. This novel scheme can realize clock recovery of multiwavelength NRZ signal in the total wavelength range of 3.3nm. This clock recovery technology is transparent to the data bit rate and modulation format, also without pattern dependence.     

分子束外延法在Sapphire衬底上生长的Zn1-xMgxO薄膜折射率及厚度的测试

利用偏振光椭圆率测量仪对分子束外延(MBE)法在Sapphire衬底上生长的Zn1-xMgxO薄膜的薄膜折射率和厚度进行了测试.结合ICP法测得的薄膜中的Mg组成量,经数值拟合,导出表征薄膜厚度与薄膜生长条件、薄膜折射率与薄膜中的Mg组成量之间关系的曲线,为MBE法在Sapphire衬底上生长Zn1-xMgxO薄膜时控制薄膜厚度以及在制作Zn1-xMgxO薄膜的波导时控制薄膜的折射率提供了理论依据.     

掺铒孔辅助导光光纤的特性研究与优化设计

掺铒孔辅助导光光纤是由掺铒的高折射率纤芯、低折射率包层和少量的空气孔组成. 采用有限元法分析了掺铒孔辅助导光光纤的模式特性；给出了数值计算截止波长和模场直径的方法；提出了改进的平均粒子数反转度迭代算法来数值计算掺铒光纤放大器的增益和噪声系数. 研究空气孔对掺铒孔辅助导光光纤的截止波长、模场直径和放大器的增益系数的影响. 发现：减小相对孔芯距的值，可使截止波长向短波长移动，减小模场直径的值；当孔的相对大小较大时，截止波长、模场直径和增益的最大值基本上不随孔的相对大小的增大而改变. 最后，综合考虑掺铒光纤基模和二阶模的截止波长、与普通单模光纤的熔接损耗、放大器的增益和噪声系数等因素，优化设计了掺铒孔辅助导光光纤的四个结构参量——纤芯半径、纤芯与包层的折射率差、相对孔芯距和孔的相对大小. 关键词： 孔辅助导光光纤 掺铒光纤 光纤放大器 有限元法     

两平行长周期光栅耦合器型上下话路滤波器的研究

以两平行长周期光栅耦合器的通用模型为依据，全面分析了两光栅完全对准和存在纵向偏离时器件性能的稳定性. 在此基础上深入研究光栅调制强度、环境折射率以及光纤包层厚度等因素的影响，确定出实现100%上下话路滤波效率的条件. 初步的实验结果表明，不需要对光纤包层进行处理，利用两平行长周期光栅耦合器完全可以实现有效的上下话路.这为进一步简化制作工艺提供了依据. 关键词： 长周期光纤光栅 光纤耦合器 上下话路滤波器