首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   7篇
  免费   13篇
物理学   20篇
  2009年   6篇
  2008年   2篇
  2007年   4篇
  2005年   5篇
  2004年   1篇
  2003年   2篇
排序方式: 共有20条查询结果,搜索用时 15 毫秒
1.
光纤光栅梳状滤波器及其在新型可选波长激光器中的应用   总被引:4,自引:0,他引:4  
对现有在同~段光纤上多次写入光栅制成光栅梳状滤波器的方法进行了改进,利用增加光栅长度,精确控制不同光栅的曝光时间,并结合调整光栅实际写入长度的方法,制成了不均衡度小于5%、最低峰值反射率高于95%的光纤光栅梳状滤波器;同时提出了一种新颖的可选波长光纤激光器结构。采用由上述方法制作出的反射率均衡的光纤光栅梳状滤波器和可调光滤波器结合在一起进行波长选择,实现了波长的快速准确选择,同时各个波长激光的输出特性稳定,功率均衡性好,边模抑制比大于50dB。  相似文献   
2.
具体分析了具有高数值孔径的双芯光纤的双折射特性。首先利用超格子正交函数法和耦合模理论分析了双芯光纤的几何双折射,并将两种方法计算的几何双折射进行了比较分析。数值计算结果表明双芯光纤在两纤芯非常接近的情况下,几何双折射仍较小,只能到10-5量级。利用超格子正交函数法计算了双椭圆芯光纤的双折射,改变结构参量可使几何双折射达到10-4量级。高的数值孔径需要高的掺锗量,理论上分析了高数值孔径时双芯光纤功率集中区域的应力双折射,应力双折射接近10-4量级。设计制作出了具有良好保偏性能的双芯掺铒光纤,测试、分析了它的几何参量和折射率分布;双芯光纤双折射系数达到了8.4×10-5。双芯掺铒光纤可以作为保偏掺铒光纤,应用到制作具有稳定的单一偏振态输出的光纤激光器。  相似文献   
3.
A 40-Gb/s optical time division multiplexing (OTDM) return-to-zero (RZ) transmission experiments including a dynamic polarization mode dispersion (PMD) compensation was reported. The dynamic PMD compensator is made up of two-stage four degrees of freedom (DOF). The first stage adopts polarization controller and fixed time-delayed line. The second stage is variable differential group delay (DGD) element. The PMD monitoring technique is based on degree of polarization (DOP) as error signal. A novel practical adaptive optimization algorithm was introduced in dynamic adaptive PMD compensation. The experimental results show that the performance of the PMD compensator is excellent for 40-Gb/s RZ transmission systems with the large DGD. With this compensator, a significant improvement of system performance can be achieved in the eye pattern of a received signal. The first-order compensating ability of the compensator is greater than 30 ps. The second-order compensating ability is greater than 200 ps2. The first  相似文献   
4.
Two silica host magnesium(Mg)-aluminum(Al)-germanium(Ge) co-doped erbium-doped fibers (EDFs) have been fabricated, which have different Mg concentrations. The concentration of all the compositions in the preform is measured through electronics probe micro analysis (EPMA). The maximum Mg concentrations of fibers A and B are 3.98 and 1.28 mol%, respectively. The performance characteristics including absorption spectrum and gain are measured and analyzed. The absorption coefficients of fibers A and B are 13.3 and 14.3 dB/m respectively at wavelength of 1532 nm. The max gains of these two erbium-doped fiber amplifiers (EDFAs) are 30.1 and 35.9 dB with input signal power of -30 dBm and pump power of 100 mW at 980 nm. Fiber B with maximum Mg concentration 1.28 mol% has better performance than fiber A. Fiber B has high absorption coefficient and high gain characteristics. The optimum fiber B length of C-band EDFA is 7 m and that of L-Band EDFA is about 30 m, which is much shorter than standard commercial EDFAs.  相似文献   
5.
使用MCVD法结合溶液掺杂技术制作了铒铋镓共掺的石英基光纤.根据光纤吸收谱,得出其中铒离子浓度是5.24×1025/m3.然后提出了一种新的利用透射率测定掺铒光纤的团簇率的实验方法,该方法相比于以前的方法更简单有效.利用该方法,测得了自制铒铋镓共掺光纤中团簇率.通过与前人的结果相比较,充分说明铋和镓的掺入大大提高了铒离子在石英基光纤中的溶解度,抑制了铒离子形成团簇.  相似文献   
6.
7.
基于实验测试结果分析了用于大功率光纤激光器的石英基包层抽运掺Yb3+光纤中Al3+共掺的特性.揭示出在高掺Yb3+的石英基光纤中,共掺Al3+的摩尔浓度为Yb3+摩尔浓度的9-11倍时既可以减小Yb3+的浓度猝灭概率,又可以获得高吸收系数,同时还可更好地满足数值孔径的要求的结论.在此基础上利用MCVD设备并结合湿法掺杂工艺制作出多根石英基掺Yb3+光纤预制棒,对拉丝后光纤的相关参数测试表明,通过精确控制疏松层的沉积温度,掺Yb3+光纤在976 nm波长的吸收系数可高达620 dB/m,且重复性好.这一结论为共掺Al3+的掺Yb3+光纤制作提供了良好的借鉴作用.  相似文献   
8.
研制出光敏偏振保持掺Er3+光纤,通过在这种光纤上紫外写入三个光纤光栅,形成对抽运激光高转化效率的谐振腔.在输出功率为23.617dBm、工作波长为976nm的激光抽运下,得到均值功率为9.20dBm、均值中心波长为1554.554nm的单波长激光输出.在室温下800min(约13.3h)的测量时间内,其输出功率的波动为±0.05dB,中心工作波长的波动为±0.0015nm. 关键词: 光纤激光器 3+光纤')" href="#">偏振保持掺Er3+光纤 光纤Bragg光栅  相似文献   
9.
对啁啾光纤光栅在超长距离多波长传输系统中应用时所存在的问题进行了研究,主要分析了多波长级联的啁啾光纤光栅之间的串扰,并提出了利用相干长度法来抑制不同信道间啁啾光纤光栅串扰的方法.在此基础之上实现了基于光纤光栅色散补偿的8×10Gbit/s,1500km G.652光纤上的传输系统. 关键词: 光纤通信 色散补偿 啁啾光纤光栅  相似文献   
10.
利用耦合非线性薛定谔方程分析了光脉冲在超高偏振模色散光纤中传输时,偏振模色散引起脉冲分裂。并用基模的两正交偏振分量耦合走离解释了脉冲分裂的成因。利用偏振模色散为237.95ps/km^1/2的光纤进行了实验验证。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号