全文获取类型
收费全文 | 245篇 |
免费 | 49篇 |
国内免费 | 118篇 |
专业分类
化学 | 191篇 |
晶体学 | 3篇 |
力学 | 11篇 |
综合类 | 16篇 |
数学 | 71篇 |
物理学 | 120篇 |
出版年
2024年 | 3篇 |
2023年 | 11篇 |
2022年 | 19篇 |
2021年 | 11篇 |
2020年 | 3篇 |
2019年 | 10篇 |
2018年 | 9篇 |
2017年 | 16篇 |
2016年 | 9篇 |
2015年 | 11篇 |
2014年 | 21篇 |
2013年 | 8篇 |
2012年 | 14篇 |
2011年 | 23篇 |
2010年 | 21篇 |
2009年 | 9篇 |
2008年 | 24篇 |
2007年 | 15篇 |
2006年 | 17篇 |
2005年 | 11篇 |
2004年 | 17篇 |
2003年 | 8篇 |
2002年 | 7篇 |
2001年 | 3篇 |
2000年 | 14篇 |
1999年 | 14篇 |
1998年 | 6篇 |
1997年 | 11篇 |
1996年 | 6篇 |
1995年 | 10篇 |
1994年 | 14篇 |
1993年 | 7篇 |
1992年 | 2篇 |
1991年 | 6篇 |
1990年 | 6篇 |
1989年 | 2篇 |
1988年 | 1篇 |
1987年 | 1篇 |
1986年 | 2篇 |
1984年 | 1篇 |
1983年 | 4篇 |
1982年 | 1篇 |
1981年 | 2篇 |
1980年 | 2篇 |
排序方式: 共有412条查询结果,搜索用时 265 毫秒
91.
92.
水性涂料中挥发性有机化合物的气相色谱-质谱法测定 总被引:5,自引:1,他引:4
建立了内墙涂料中24种挥发性有机化合物(VOCs)的GC-MS检测方法,重点研究了现有检测方法分离度差和回收率低的问题,采用无水硫酸钠净化、二氯甲烷超声和膜过滤提取体系,改善了各种化合物的回收率,特别是提高了二元醇类化合物的回收率,优化后的实验条件下,样品的加标回收率为70%~94%,相对标准偏差不大于6.8%,检出限为3.1~10.6 mg/L。在30~300 mg/L范围内,方法的线性关系良好,相关系数大于0.99。该方法简便、快速、灵敏、精密度好,完全满足进出口水性涂料中常见的24种挥发性有机化合物的检测要求。 相似文献
93.
PVA改性PAMPS-PAM超高力学性能双网络水凝胶的制备 总被引:2,自引:0,他引:2
采用紫外光引发聚合制备了聚乙烯醇(PVA)改性的聚(2-丙烯酰胺基-2-甲基丙磺酸)-聚丙烯酰胺(PAMPS-PAM)双网络(DN)水凝胶.测定并比较了PVA改性前后PAMPS-PAM双网络水凝胶的溶胀动力学;通过扫描电子显微镜(SEM)观察了单网络水凝胶的结构;测定PVA改性前后PAMPS-PAM双网络水凝胶的压缩及拉伸性能.结果表明,经PVA改性后的PAMPS-PAM双网络水凝胶有较高的溶胀比;0.82%PVA用量的PAMPS-PAM双网络水凝胶在90%压缩形变率下仍保持完整、最大拉伸应力达到0.5 MPa,大幅提高PAMPS-PAM双网络水凝胶的力学性能. 相似文献
94.
聚乙二醇对PAMPS/PAM双网络水凝胶性能的影响 总被引:2,自引:0,他引:2
采用紫外光引发聚合制备了聚乙二醇(PEG)改性的聚(2-丙烯酰胺-2-甲基丙磺酸)/聚丙烯酰胺(PAMPS/PAM)双网络水凝胶.测定并比较了PEG改性前后双网络水凝胶的溶胀动力学以及单网络水凝胶中丙烯酰胺(AM)的吸收量;用扫描电子显微镜(SEM)观察了单网络水凝胶的结构;测定PEG改性前后双网络水凝胶的压缩及拉伸性能.结果表明,经PEG改性后的双网络水凝胶有较高的溶胀比;改性后单网络水凝胶更易吸收AM;改性后双网络水凝胶压缩形变率达到90%以上、拉伸形变率是未改性双网络水凝胶的2倍. 相似文献
95.
Heavy-light hadrons are studied in a mass loaded flux tube model. The study indicates that the dynamics of mesons and baryons containing a c quark is described well by the mass loaded flux tube. The hypothesis of good diquark-antiquark degeneracy is found reasonable in heavy-light quark systems. The spectrum of charmed (D) and charmed strange (Ds) mesons is systematically computed. D and Ds in 1D multiplets are predicted to have lower masses in comparison with other theoretical predictions. The predicted masses of the 1(13D1) and the 3(13D3) Ds agree well with those of recently observed Ds1(2700)± and DsJ(2860), respectively. 相似文献
96.
97.
98.
Characteristics and properties of metal aluminum thin films prepared by electron cyclotron resonance plasma-assisted atomic layer deposition technology 下载免费PDF全文
Metal aluminum (Al) thin films are prepared by 2450 MHz electron cyclotron resonance plasma-assisted atomic layer deposition on glass and p-Si substrates using trimethylaluminum as the precursor and hydrogen as the reductive gas. We focus our attention on the plasma source for the thin-film preparation and annealing of the as-deposited films relative to the surface square resistivity. The square resistivity of as-deposited Al films is greatly reduced after annealing and almost reaches the value of bulk metal. Through chemical and structural analysis, we conclude that the square resistivity is determined by neither the contaminant concentration nor the surface morphology, but by both the crystallinity and crystal size in this process. 相似文献
99.
基于模糊球概念构造了一个具有向量形式规则的模糊逻辑系统,然后利用其逼近性质给出了在紧致域上逼近多元连续函数的方法.首先,依据所给论域自身的几何特点,将其进行模糊划分,其次使用各个子论域上的采样点和母函数构造开模糊球,然后基于模糊球构造出描述每个子论域的模糊逻辑系统(FLS),最后在整个论域上生成逼近紧集上连续函数的模糊逻辑系统(FLS).这种模糊逻辑系统的规则为向量形式且具有较强的语言解释能力.与传统的FLS相比,本文提出的FLS用来描述高维情形时不必使用张量乘积构造规则,从而在一定程度上避免了维数灾难问题.最后的仿真例子说明了本文所采用方法的有效性. 相似文献
100.
一、问题的提出 在机械工业生产中,对加工对象多,工艺流向不一致的工作地单行布置,现在习惯采用“从至表一试验法”,即首先绘制各种零件在生产线机床设备上加工程序图,(也称零件综合工艺路线图),其次根据程序图,按给定的工作地顺序编制零件初始从至表,第三步是通过有限次地试验调整,改进从至表,求得接近于最优的工作地单行布置方案.这种方法看起来虽然简单,但试验调整的盲目性较大,达到较优方案的速度很慢。如何编制出一个较优的初始从至表,找出调整途径,尽量减少调整次数较快地达到接近最优的布置方案,一直是我们生产管理工作者渴望解决的… 相似文献